Question about 1995 Buick Century
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 95 Buick Century dash removal?
you should not have to remove the dash to install a new radio all you have to do is remove the trim around the radio and then take out the bolts that hold the radio in and remove the wires from the back and also if there is a Walmart or Radio Shack near you get an installation kit and you plug it from the plugs from your old radio and it is alot easier to wire it that way
Posted on Mar 04, 2009
call a parts store they usually can provide you the routing for serpantine belts good luck getting it right though it can be tricky pay close attention to how the belt is routed :)
Posted on Jun 22, 2009
The resistors are located in the firewall just above the blower motor. they have a heavier gadge wire going to it. As for the water if it is not antifreeze then you have a leak in your cowl area by the lower windshield. I ran in to this problem on several gm cars such as yours it can be deficult to find good luck
Posted on Oct 20, 2009
Testimonial: "Iccjester, thanks for the information it was very helpful much appreciation Mike S 1999 Buick Century"
Yes it is the blower Motors Resistor board. It is up behind the blower motor, just under the glove box. You have to remove the black KICK panel with its two "Push Pins" that will break too. There are 3 screws holding that resistor board in, the back two are a bear to get to. Good luck.
Posted on Feb 26, 2010
Tips for a great answer:
Dec 28, 2016 | Buick Cars & Trucks
Remove the passenger side kick panel using a Phillips head screwdriver. Pull the rug back from under the blower motor to allow enough room to drop the blower motor without the rug interfering.
Disconnect the electrical plug from the blower motor. Pull the rubber vent hose out of the blower motor.
Remove all the Phillips head screws securing the blower motor to the housing. Drop the blower motor straight down.
Install the new motor in reverse order of removal
Jan 13, 2012 | 2001 Buick Century
Nov 15, 2011 | 1998 Buick Century
Jan 23, 2011 | 1999 Buick Century
REMOVAL & INSTALLATION See Figures 1, 2 and 3
This procedure is applicable for vehicles, with or without air conditioning.
Fig. Fig. 1: Remove the blower motor retaining bolts ...
Fig. Fig. 2: ... then disconnect the hose
Fig. Fig. 3: The blower motor can now be removed
Oct 03, 2010 | 1988 Buick Century
Feb 13, 2010 | 1999 Buick Century
Dec 07, 2009 | 1997 Buick Park Avenue
Jan 24, 2009 | 1985 Buick Century
Dec 18, 2008 | 1998 Buick Century
25 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: