Question about 1999 Audi A4

1 Answer

Abs light on as well as brack light on the das

Hi brack pads r low but still working it a4 1996 18i 20v

Posted by on

  • paven007 Jan 19, 2009

    i am get it don today it book in

  • paven007 Jan 25, 2009

    i have had pads down but it still flashin abs and brack light

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 65 Answers

Brake pads are the ONLY way to stop you going like 30mph+ when you hit like a wall or person or like another road user & if you do crash YOU will be totally at fault for having an unfit car. The best way to get the lights on your dash to go out is to fit new pads. The lights show that the time when the brakes WILL fail is drawing very near, it is stilll up to you to get the pads changed. You will not get any further warnings from your car prior to not being able to stop at all thus causing endangerment. You will be shocked at just how bad they were when you feel the new pads.

Posted on Jan 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Low break pads


They should reset themselves or "go off" by themselves. Its possible you have instead a short or broken wire that was giving you a false indication in the first place

May 28, 2014 | 2009 Jaguar XF

2 Answers

I have a Mercedes c280 1996. My speedometer and odometer don't work along with abs. The abs light is on a long with the brake light on the dash. I have replaced the speed sensor and still isn't working?


hi i would check the abs module its located on the abs pump it controls the speedometer and can also bring lights on the dash eg abs &the brake warning light

Nov 23, 2013 | Cars & Trucks

1 Answer

Have several problems abs light on traction control light,low coolant light on, seat belt light on ,driver side heated seats stopped working and fuel gauge doesnt work always reads full


My 2003 Monte Carlo and my husbands 2003 chevy pickup both had the ABS and traction control lights on. When it began it only came on once in a while but got worse until the lights were on all the time. After several attempts to find the problem we purchased a ABS Brack Scan. Part #CP9449. Although it doesn't pinpoint the exact problem it does tell you what wheel has the issue and possible problems. My problem was a bad wire in the harness. Good luck!

Oct 17, 2010 | 2001 Chevrolet Monte Carlo

2 Answers

Brake light and abs light on


this means that one of you abs wheel sensors is not working take voltmeter check each wheel senser there on the caliper around it should be 12 volts then check fluid cause brake fluid set off brake light too but those only two possibilitys

Sep 14, 2010 | 1995 Chevrolet Caprice Classic

1 Answer

My car Toyota corolla 2003 VVTi was envolved in an acccident.Now after repairs on the dash board is showing engen light,ABS light and Hand brake light.How do i clear these indications because everything...


The accident caused a possible short circuit in the circuit and wires serving the ABS ,Engind and hand brake light system best to get checked by a Auto Electrician

May 17, 2010 | 2003 Toyota Corolla

1 Answer

1995 pontiac bonneville brack system warning light and chime on.


Be aware that if the (BRAKE!) light is on you are probably low on brake fluid and while your brakes are still working properly, there is a possible fluid leak somewhere that is going to causse them to not work at all. When this light is on it is serious. Although the sensor in the master cylinder that tells this light to come on is probably the answer, as they tend to malfunction in your vehicle. Check your brake fluid immediately, and fill it if it is legitimately low.
If the (ABS) brake light is on it is probably an ABS speed sensor in the vehicle that is bad, If the abs light is on have a service center do a diagnostic scan to verify which sensor is bad.

Dec 11, 2009 | 1995 Pontiac Bonneville

1 Answer

Brack pad change on 2003 volvo s40


It is the same as the older cars.
Just change the pads as usual.
It`s when you come to bleed the brakes that problems arise.

Feb 02, 2009 | 2002 Volvo S40

1 Answer

Asb light and brack keep flash and i have had pads changs


im pretty sure its your fluid level (steering) screw top as you stand infront of car right hand side screw top with metal connector attached

Jan 19, 2009 | 1996 Audi Cabriolet

Not finding what you are looking for?
1999 Audi A4 Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

61037 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

13152 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...