Question about 1999 Chevrolet Silverado 1500
May need a special tool-go to magicmechanic n hit ed center or view a haynes manual
Posted on Jan 01, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
This would more than likely NOT be a sensor problem.
In replacing the hinges you more than likely disrupted the wires that run from the cab into the door, causing a ground, pinching a wire or in some way causing no power to get through one of the wires. There is a rubber boot that runs between the door and the cab, pull it back and have someone hold the button in the down position. Then wiggle the wires until the window moves. That truck will have defog mirrors on it more than likeley so there will be plenty of wires to wiggle. When you find the problem wire simply cut the problem area, replace it with an end to end connector (**** connector) and seal it with silicone. If it is not one of the wires, you more than likely had a wire come off inside the door. (depends on how much you horsed it when you were changing those hinges) Thats where i'd start.
Best Of Luck!
Posted on Jun 05, 2009
the problem you are discribing would lead me to belive your fuel filter is clogged which is a simple fix 3 dollar part at any part store or on the worse hand your fuel pump itself could be weak you can open the gas tank cover and have another person turn the truck key to the on position without going far enough to start you will hear a faint whining noise if it is going bad or a louder noise if it is fine Good Luck
Posted on Mar 03, 2010
if its set up for trailers with brakes, it should have small black box under the dash above the pedals; if there is one you can adjust the brake timing to syncronize the trailers brakes with the trucks; if there is not one you can purchase one and mount it and run a few wires
Posted on Jun 05, 2010
SOURCE: How do I remove old
put a jack under door to hold up take a big screw driver pull spring out the use screw driver to drive both pins out thenpull door away from truck replace bushings then put door back put pins back in hinges
Posted on Feb 02, 2011
Tips for a great answer:
Oct 17, 2015 | Cars & Trucks
Apr 03, 2013 | 1999 Chevrolet Silverado 1500
Jan 21, 2011 | 1999 Chevrolet Silverado 1500
Oct 22, 2010 | 2000 Chevrolet Silverado 1500
Jun 03, 2010 | 1999 Chevrolet Silverado 1500
36 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: