Question about 2000 Dodge Dakota Quad Cab

Open Question

2000 Dodge dakota stereo system makes loud popping noise

It is barely tolerable to listen to radio because it will suddenly make a loud POP noise. can adjust to the left speaker or right speaker and it will still POP even with low volume. I was told to get another factory stereo to test the situation. Is this a complicated procedure?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: How to put a cd player in place of factory stereo in 1994 dodge dakota. Need wiring diagram in color.

i had this problem to, do not hook the ground wire from truck to your radio. use the braided wire that hooked to your old factory radio by inserting a bolt into the braided wire and ground from your new radio.
then check fuses one more time and you are good to go.I didnt think this would work but it did..

Posted on Dec 27, 2008

Ad
  • 1 Answer

SOURCE: Dodge Ram popping noise front left (drivers side) suspension

its a lot of times universal joints.. the ball joints break with no warning.

Posted on Jan 05, 2009

  • 2 Answers

SOURCE: how would i add amp and sub to a factory stereo system

you have to goto best buy wal mart or somewhere like htat they sell an adapter that converts speaker wire to rcs its like 20 to 30 bucks what i did is take the left rear speaker and direct wired it to the right side then conected the converter box to the left rear wires and then you can go from there with your rcas

Posted on Feb 14, 2009

ourhowse
  • 2007 Answers

SOURCE: loud clicking noise which the clicking noise getss faster as i accelerate

From what you are describing it sounds like it must be a valve lifter sticking. Try putting a cup of transmission oil in your crankcase, or pick up some suitable additive from your local parts store. I wish i could hear it and give you a better idea. Maybe let them listen to it at the parts store, and they can determine if it's a lifter or not. Let me know how you make out.

Posted on May 21, 2009

  • 1244 Answers

SOURCE: 2004 dodge dakota V6 3.7L ... loud tapping noise

you have either a lifter collapsed or a rocker arm backed off!! or a lobe flat on the camm pull the valve cover and check the rockers

Posted on Jan 14, 2010

Testimonial: "Excellent answer...upon opening the left valve cover...a rocker arm had fallen off. Thank you for the answer. "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I started my 2000 dodge dakota truck and immediately heard a loud noise. When I started drivig the power steering would not work. Suggestions?


The power steering system has two main components - the hydraulic pump and the hydraulic ram. The pump is driven by a belt situated on the front of the engine, so if you heard a noise at start-up, the chances are that something went bang around the pump area, maybe the drive belt or a broken pulley. Locate the pump and do a visual to see if you can identify a problem there.
It is very unlikely that the ram would have a problem, or at least a sudden problem as the one you are describing.

Feb 21, 2015 | Dodge Cars & Trucks

1 Answer

Rear HVAC unit in 2002 trailblazer making loud poping noise and then quits after a couple of minutes


The only thing i can think this would be is a blower motor noise, have shop take a listen is my best advice.

Oct 25, 2012 | 2002 Chevrolet TrailBlazer

1 Answer

How do ihook up a new car stereo to my 2000 dodge slt quad cab wit 4speakers with crossovers how do i find the wireing 4 all the audio systerm


Go 2 auto zone or any stereo shop and get a factory wiring Harness adapter 4 youre year and make it will plug in and Will be color coded and labled for easy install remember U will need a adapter plate 2 for aftermarket radio 2 fit Factory hole each will run u about $20.00

Jun 13, 2011 | 2000 Dodge Dakota Quad Cab

1 Answer

It makes a loud noise when i turn and shakes and thumps driving, when i push the gas it gets worse and makes awful noises the whole time i am driving.................i had the wheel baron replaced last...


does it click click click when turning or pop pop pop either-or the rack and pinion steering may be bad.or just a u-joint on the steering rod

Aug 13, 2010 | 2000 Nissan Maxima

1 Answer

The stereo in my dakota keeps flickering power


check the gound wire and make sure it is secure

Jun 20, 2010 | 2000 Dodge Dakota Quad Cab

1 Answer

Transmission made a loud pop then quit moving in drive. Truck still moves in reverse


An automatic transmission consists of a series of bands (gears) which is each gear within the transmission. You state that truck will move in reverse, but not in drive. The loud pop you heard was the forward gear band breaking. From this point you have two options...either have the transmission rebuilt or replaced.

Jun 11, 2010 | 1992 Dodge Dakota

2 Answers

How do you remove radio from a 2003 dodge dakota?


pop off trim in center cluster by hand .then remove 4 bolts securing radio, pull out, unplug.

Nov 22, 2009 | 2003 Dodge Dakota Club Cab

1 Answer

Wiring color codes for stereo system in a 1990 dakota


Dodge Dakota http://www.installdr.com/Harnesses/DCP-Wiring.pdf
1991 Chevy Cavalier http://www.installdr.com/Harnesses/GM-Wiring.pdf
Here is a link that should help you get your radio wired up again, good luck. 

Jul 29, 2009 | 1990 Dodge Dakota

1 Answer

Stereo static


Antenna connector behind the radio must be loose or barely connected to it's socket. Now you're getting all the noise electricity can throw at you. Check it by pulling the radio out with the specific radio tool, and don't forget the radio code, you'll need it when you reinstall it back again for it to operate.

Apr 01, 2009 | 2000 Volkswagen Golf

Not finding what you are looking for?
2000 Dodge Dakota Quad Cab Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...