Question about 1992 Isuzu Pickup

1 Answer

Back fire and fuel bogging changed distrib plugsand wires,fuelfil

At first it wouldnt start like was getting no gas but smelt like lots of fuel -like flooded then would die then i get it started it would backfire then die i have changed the distributor plugs and wires also changed fuel filter now will sometimes start then in time it it will back fire and die i would also like too know were the fuel pump is PLEASE AND THANK YOU im thinking timing or fuel pump

Posted by on

  • Anonymous Mar 16, 2014

    i think i have a wireing problem

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The fuel pump is in the gas tank but there is also a gas regulator right at the front on the valve cover.

Posted on Jan 19, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Truck will not start


remove coil wire at distributor and plug a HEI GM tester spark plug to see if spark at ignition coil if not test ignition coil for current and signal not short to ground

Apr 10, 2014 | 2000 Chevrolet Silverado 1500

1 Answer

Will not start


It seems that something was burned out trying to make the starter turn. The problem could be the starter and/or the solenoid.

Go to youtube and enter, "how to check a starter" you may have to remove it to check it. I could tell you how. But it is better if you see how it's done for yourself. Also check the fuses.

Mar 21, 2014 | 1987 Chevrolet Corvette

1 Answer

Chevy 1500 six cylinder changed plugs and wires and still bogging down


yes I would put my money there, I have 2002 chev s10 4x4 4.3 liter and it ran great for 10 years then the rotor button acted up and it caused a lot of problems. its your best bet, that fails try the fuel filter :)

Apr 07, 2013 | 1999 Chevrolet Silverado 1500

1 Answer

It needed an alternator so i replaced it and then went and drove it and ran fine and then when i tried to accelerate it wouldnt it just bogged down. And then it would crank and try to start but wouldnt...


Is is possible that you ran out of gas? I would put some gas into the car, unless you are sure you got gas. in that case I would start checking for loose ground wires.

Mar 14, 2011 | 1989 Acura Integra

3 Answers

My 2004 suburban wont start i have to spray starting fluid


Does it stay running after you spray it or just die out ? If it stays running it sounds like time for a tune up. If it just dies out you may need a fuel filter replacement or a fuel pump replacement.

Nov 18, 2010 | 2004 Chevrolet Suburban

1 Answer

I have an 89 dodge ramcharger 4x4 i drove it about 600 miles parked it then the next day it wouldnt start i thought it wasnt getting fuel and dumped some down the intake and it fired up after a lot of...


look at a fuse,relay for fuel pump ,and or pump maybe the cause.you might even have a broken or corroded wire.I would try the fuse or relay first

Mar 19, 2010 | 1989 Dodge Ramcharger

1 Answer

88 f250 300 6cyl,changed all fuel relays,fuel pressure regulator,starter,coil,fuel pump,everything possible,started once,ran rough,finally idled,shut off,started again,waited 20 min,wouldnt start or...


I know some old fuel injected systems will dump fuel because of the coolant temp sensor should be located on lower intake in the front. Also check the timing.

Jan 25, 2010 | 1988 Ford F 250

2 Answers

1987 chevy S10 engine idle problem


relace the throtle air idle valve.The temp switch will allso cause this problem.

Jul 19, 2009 | 1987 Chevrolet S-10 Pickup

2 Answers

1987 chevy engine problem


you have to reset base idle see manual at library for procedure

Jul 19, 2009 | 1987 Chevrolet S-10 Pickup

Not finding what you are looking for?
1992 Isuzu Pickup Logo

Related Topics:

248 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

63242 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...