Question about 2006 Honda Pilot EX

Open Question

Map lights dont work on 2006 honda pilot

Overhead front map lights both driver & passenger side dont work

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
TheAsian
  • 93 Answers

SOURCE: How do you adjust the headlight of a 2005 Honda Odyssey?

I assume you are talking about a vertical adjustment.

If so Easy enough. Park the car about 25 feet from a wall or so. This is normal range for adjustment. Turn on your low beams.

Now Pop the hood and take a look at your headlight On You will see a black rubber bump stop. This is used to adjust your hood height.

Right behind that you will see a area where you can insert a screw driver into. Turn that with the screw driver and the headlight vertical angle will change

Here is a picture
[IMG]http://i67.photobucket.com/albums/h298/JDMITRCinci/RJAAI003_204.png[/IMG]

Posted on Dec 13, 2008

Ad
  • 236 Answers

SOURCE: 2003 Honda Pilot Door locks not working

may be a relay switch, or a faulty wire on the right side behind the glove box

Posted on Jun 17, 2009

  • 58 Answers

SOURCE: honda pilot the driver's power seat dont work what could cause that

There is a wire coupler under the seat see that it is incerted in its mate. This is where the switch gets its power

Posted on Aug 13, 2009

positrac
  • 30 Answers

SOURCE: passenger side power window does not go down

Electric window motor seized. Those motors have internal copper brushes that usually lock after time. Some times a quik test is to get to the motor and tap it with a wrench while pressing the switch to get it unseized. ( Not a fix ! ... still needs replaced ).

Posted on Sep 09, 2009

  • 1986 Answers

SOURCE: need to remove inner rear passenger side door

On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you need to pull back the weather seal and then you can access the bolts securing the outer handle

Posted on Nov 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace a map light on 2005 Honda pilot


Mall flat screwdriver pops the lens out, then pull the bulb out with your fingers.

Feb 27, 2015 | 2005 Honda Pilot

1 Answer

Interior courtesy light


Page 116 and 117 of the manual explain that there's a two-position slide switch on the map light, DOOR and OFF. The back light has three positions, ON, Door Activated, and OFF.

Pages 116 and 117:
http://techinfo.honda.com/rjanisis/pubs/om/ACC080/ACC0808OM.pdf

Dec 12, 2013 | Honda Cars & Trucks

2 Answers

Map lights wont work


you can check your owner's manual
------------
autel maxidas ds708 original

Oct 18, 2012 | 2006 Honda Pilot

2 Answers

2003 Honda pilot door locks and remote not working


There is a small electric motor inside the actuator assembly that has probably "burned out". Same problem with my 03 pilot. The remote would not lock the other doors or arm the security system unless you physically locked the driver's side door. Eventually my passenger side burned out as well. Fixed it myself pretty easily. Cheap fix too. works like new now. http://www.ebay.com/itm/120935451126?var=420082237231&ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649

Sep 05, 2012 | 2003 Honda Pilot

1 Answer

How do you replace a map light bulb in a 2006 honda pilot


take a small screw driver and place it between the white lense and caseing carefully pry the lens of there should be eather 2 or 4 prongs holding it in place ounce the lense is off pull the bulb out (just pull) then install new bulb replace lense and you are done good luck cj

May 14, 2010 | 2006 Honda Pilot

1 Answer

The power door locks on my 2003 Honda Pilot for both the drivers and passangers side do not work. I have to manually raise and lower the locks. The fob and the swith on the door do not work. Help


The Power locks actuators need to be replaced. I did on my front passenger door already. A friend of mine had to do it in the 2 passenger side doors. The part is the whole door latch mechanism. You will need a hand impact driver to remove the 3 screws on the door jamb.

Feb 03, 2010 | 2003 Honda Pilot

1 Answer

Power locks don't work with remote or control from


The door lock/unlock input from the driver's key switch goes to the Door Multiplex control unit (main switch), the Door multiplex control unit then sends a signal on the BUS (CAN) circuit to the passenger's multiplex control unit; the passenger's multiplex control unit then controls all the door locks. The passenger's door lock key switch inputs to the passenger's multiplex control unit, if the locks work from the passenger's side key switch but not the driver's side key switch, the most likely cause is the driver's multiplex control unit (main switch) not sending the signal to the passenger's side multiplex control unit. This could also be the drivers side door lock actuator. Hope this helps!

Jan 07, 2010 | 2003 Honda Pilot

1 Answer

My radio, clock and CD player suddenly quit


Well I just found my solution.... I was a little too quick the first time.
There are 3 fuse boxes for the 2004 Pilot. One on the drivers side, one under the hood, and one on the passenger side. My 15 Amp fuse on the passenger side (fuse #9) was blown thus causing the front AC outlets and the radio/clock/CD player to be completely dead. I pulled the 15 Amp spare from the fuse box under the hood, and replaced the blown fuse in the passenger side fuse box. The radio came on like a champ and I didn't even need to reset the radio code. I figure I just saved at least $100 vs. taking it to a dealer. :)

Jul 11, 2009 | 2004 Honda Pilot

1 Answer

2003 Honda Pilot lighting problem


the driver's door has a switch which tells the multiplexer control unit that the door is open and the control unit then switches on the lights. It sounds like the switch is not making contact when the driver's door is open. The lights work and the other door switches work--so it isn't a fuse or multiplexer problem.

Feb 22, 2009 | 2003 Honda Pilot

1 Answer

2005 honda pilot with navigation, i purchased this unit from the usa and imported it to canada. navigation system doesn't work, where is the navigation disk slot located and is there a disk for north...


same problem, disc is located under passenger seat, talked to honda canada , alpine and honda usa, they dont make a disc for 05, couldnt get nav in 05 cannadian pilots , they dont even make north america disc just stricly usa maps

Jan 19, 2009 | 2005 Honda Pilot

Not finding what you are looking for?
2006 Honda Pilot EX Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...