Question about 1997 Honda Civic

Open Question

Where can i find glass run channels for my honda civic they are worse off then the regulators and motor and thanks honda tech's freckin love my honda happy new year honda people!

All i find is the regulators and motors do the run channels come with the package deal?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 840 Answers

SOURCE: How do i install a driver window for a 95 Honda Accord EX 2 door?

if you take the channe out rubber that holds in the glass/ put the glass first in then get like glass cleaner spray in the groove sthen you slide the run channel back into the window and slide it down/ that piece should thengo into glass and hold it into the run channel. if you have any questions let me know Please rate my response thank you very much

Posted on Jan 28, 2009

Ad
lemmingleejn
  • 173 Answers

SOURCE: oil filter in civic 97

If you go to a reputable motor factor,
you can only be sold the correct filter for the civic.
As there are soo many variables in engine type, it's almost impossible to tell, oil volume, or which type filter.
However, I will say, be sure that you don't mix semi-synthetic oil, and mineral oil.
Oil changes should be undertaken every 30,000 miles, (unless under extra work load, (in which case, slightly more regularly))

Otherwise, 10/40 or 15/40 grade oil, is perfectly fine.
The trick to not overfilling the oil, is simply just to take your time, clean the dip stick and retry, until you have the correct reading.

Please don't forget to rate:)

Posted on Jul 29, 2009

  • 72 Answers

SOURCE: my 1991 honda civic motorized seat belt problem?

Your motor for the seat belt is no good you need to replkace it , it should not cost no more the $ 100.00 dollars or less it all depends on whether or not you choose to buy a new one or you go to a salvage yard mysfl I would go to a salvage yard to see if that they have one or not first before you buy a new one.

Posted on Sep 14, 2009

Lloyd Six
  • 560 Answers

SOURCE: where is the the wiper motor on a 99 honda civic

Back of engine bay and base of the windsreen you will see some plasic covers known as scuttle panels, you may have to remove the wiper arms first (10mm M6 nut under the Black circle cap on each arm)
The motor will be the size of a coke can with Silver linkage bars going to it

Posted on Nov 29, 2009

bayyagg
  • 1672 Answers

SOURCE: Problem: passenger window will not

Hi,
The problem would be the power window switch assembly! That switch controls the power to ur window motors! If u are a tinkering man, try to borrow from any garage/friend w/ the same window switch and test it!
Or
Go to ur service center and have them check it for free... they always try the new switch... and you will know the main prob!

Posted on Jun 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

DX. Why are rear wiper and hazard signals not working?


Honda Civic How To: Hazard Switch Bulb - YouTube

? 4:54
www.youtube.com/watch?v=P3TqheRsX1w
Sep 25, 2013 - Uploaded by Honda Civic How To
Hi in this first video i will look at how you can easily change a failed bulb in a 2001-2005 Honda civic's hazard ...

DIY] 92-00 Civic REAR Hatch Glass Intermittent Wiper ...

honda-tech.com/honda-civic.../%5Bdiy%5D-92-00-civic-rear-hatch-glas...
[DIY] 92-00 Civic REAR Hatch Glass Intermittent Wiper Retrofit Guide ... The answer lies in a 1997 Honda CR-V. So the 98+ CR-V models all had their rear ... Remove the Rear Intermittent Washer/Wiper Relay from the under-side of the dash, ...

Oct 03, 2015 | 1997 Honda Civic

1 Answer

Stiff and slow driver-side window (not regulator)


Try lubricating the glass run channels with silicone spray.

Apr 26, 2013 | 2000 Honda Civic

1 Answer

How do I replace the cable that controls the glass window on the drivers side?


This cable is part of the regulator. This is what you have to replace. there are 6 to 8 bolts to remove off the door and a couple that you have to remove from the window. Remove the window first and push it up, put a wedge or tape it in place so it doesn't fall. Then remove the regulator. You will have to remove the motor from the regulator, but wait till yo get the new one to see how it bolts up. You don't want to remove the wrong piece.

Jun 28, 2011 | 1998 Honda Civic

1 Answer

How to remove and install the driver side window (just the glass) on a 94 honda prelude


Hi!!
Here is how:
REMOVAL & INSTALLATION
See Figures 1, 2, 3, 4, 5 and 6
  1. Remove the door pad and inner moisture barrier.
  2. If working on the rear window of a sedan, remove the two upper screws securing the center channel. Remove the two lower bolts (in the door) securing the channel and remove it. On some cars, the two screws are concealed below the weatherstrip.
  3. For sedan rear doors, remove the quarter glass. The entire glass and rubber seal may be removed as an assembly from the door.
  4. Lower the door glass until the glass mounting bolts are accessible. One will be easily seen in the large access hole in the door; the other will appear in the smaller, round access hole. Remove the bolts.
  5. Stand next to the inside of the door. Tilt the door glass and remove it through the slot.
  6. On front doors, remove the bolts securing the front run channel, then remove the channel.
  7. Remove the regulator mounting bolts and remove the regulator. On later models, there are additional roller guide bolts to be removed. Mark the roller guide mounting bolts to ease window alignment later.
  8. For power windows, remove the motor from the regulator if desired.
CAUTION The regulator gear will move suddenly when the motor is removed due to action of the large spring. Keep hands well clear.
TO INSTALL, REVERSE DIRECTIONS
FIG 1 1kbron_122.gif

FIG 2 1kbron_123.gif
FIG 3 1kbron_124.gif

FIG 4 1kbron_125.gif

FIG 5 1kbron_126.gif

FIG 6 1kbron_127.gif

Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa!!

Feb 16, 2011 | 1994 Honda Prelude

1 Answer

Stuck crank window, drivers side, 97 honda civic


1996-00 Civic 2-doors had a problem with the front windows binding or coming out of the run channel. The window regulator needs replaced and the rubber run channel needs inspected for damage and to make sure its properly seated into the window channels. note: make sure you install the window crank in the 10 o'clock position, so your not tempted to use the window crank as a door handle to pull the door shut. This can break the crank and/or the regulator. -Hope this helps:)

Jan 24, 2010 | 1997 Honda Civic

1 Answer

To replace the motor/regulator on 99 civic it says put the window down, if the motor is broken does anyone know how you get the window down so i can remove it?


You have to remove your interior door panel and then remove all of the little 10mm bolts that connect your regulator to your door skin. This will let the window collapse. Just move it around all over the place to gain access through any available holes in the door skin that let you in. There will be 2 bolts that you need to get to to remove the glass from the regulator, then you can wiggle that old regulator out.

Oct 03, 2009 | 1999 Honda Civic

1 Answer

How do i install a driver window for a 95 Honda Accord EX 2 door?


if you take the channe out rubber that holds in the glass/ put the glass first in then get like glass cleaner spray in the groove sthen you slide the run channel back into the window and slide it down/ that piece should thengo into glass and hold it into the run channel. if you have any questions let me know Please rate my response thank you very much

Jan 28, 2009 | 1995 Honda Accord

1 Answer

Window jumped off window track


drivers window?
the best way to fix it is to replace the window run channel (rubber the glass slides in) and the regulator. or to get by if the regulator isnt bent take the door panel off, take the door glass out, the front of the run channel inside the door is bent foreward a little bend the metal track to the rear a little by hand, careful its weak, spray the run channel with silicone spray and reinstall the glass. if the run channel is torn it wont last.

Dec 18, 2008 | 2000 Honda Civic

1 Answer

Driver's side window regulator


I just replaced the regulator in my mother's 98 civic ex and didnt need any special tools. I do recommend replacing the glass run channels on either side of the window. I have replaced the regulator twice and it is still having problems as I haven't replaced the run channels. If not replaced very soon I can see myself replacing the regulator...yet again!

Aug 04, 2008 | 1998 Honda Civic

Not finding what you are looking for?
1997 Honda Civic Logo

Related Topics:

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...