Question about 1998 Chrysler Cirrus
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: how do I change the
I did a Google search "How do you replace the rear spark plugs on a 2000 Chrysler Cirrus?" and found this link: http://www.faqs.org/qa/qa-6243.html
I haven't tried it yet and am thinking of purchasing a Chilton manual just in case, but as far as explanations go the one at the very bottom of the page in the link sounds the most legitimate so far.
Besides, I have to pay you guys $9.99 for one answer that I can get for free; or I can get the Chilton and have a whole heap of answers for around $20.
Posted on Jul 14, 2008
The throttle position sensor may be misaligned. This tells the computer how much throttle is being applied, and when they go bad, or come out of alignment, the idle tends to get up there. If that's not the issue, remove your air cleaner, the housing and everything until you get to the MAP sensor. Give it a good spray with carb cleaner, let it dry and replace the air cleaner with a new one. If the MAP sensor detects minimal air flow, the computer jacks up the idle to compensate.
Posted on Nov 07, 2008
Posted on May 07, 2009
Don't buy it. My husband and I have a 1996 Cirrus and it is a money pit. We have only owned the thing for a short while but we have already had to fix some major problems - and now the horn won't stop honking and the shim we are using to stop it from doing so is no longer working. We are going to have to take apart the steering column and disable the horn at this point. Hope its not connecting to any of the tail lights!
Posted on Jun 04, 2009
Had the same problem on my 1999 cirrus lxi. Replaced the output speed sensor on the tranny and topped off the tranny fluid... cleared the check engine light and the cirrus ran great. Caution...the output speed sensor reqires removal of the front left tie and plastic weatherproofing to replace. once you find it's locvation, the replacement is relatively easy.
Posted on Jan 10, 2010
Tips for a great answer:
Apr 05, 2016 | Chrysler Cars & Trucks
Nov 24, 2015 | Cars & Trucks
Aug 29, 2015 | Chrysler Cars & Trucks
Aug 31, 2012 | 2000 Chrysler Cirrus
not starting or turning over indicates towards multiple possibilities. It can
be issue with battery or weak battery. But if battery checks out ok, then it
can be starter issue or faulty alternator or problem with low fuel pressure or
no spark at spark plugs due to dirty spark plugs or faulty ignition
coil or injectors getting cracked or dirty and needs to be cleaned.
confirm the problem, the basic troubleshooting is required.
this link below and follow the troubleshooting:------
This will help.
Jan 31, 2012 | 1999 Chrysler Cirrus
Apr 28, 2011 | 1998 Chrysler Cirrus
Mar 21, 2011 | 2000 Chrysler Cirrus
Oct 30, 2009 | 1999 Chrysler Cirrus
Jul 11, 2008 | 2000 Chrysler Cirrus
90 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: