Question about 1992 Plymouth Acclaim
Wipers stopped working. I replaced fuse but wipers still don't work.
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
If you move each wiper by hand, you will feel and hear a clunk. One of the bushings between the wiper motor and the wiper is shot. It could be the one where the wiper is mounted. This is not a costly repair as far as parts, but most time consuming and annoying! LOL Frankster016
Posted on Nov 29, 2008
you have to replace the " body control module " located under dash drivers side. and most of time they have to be reprogrammend unless you buy it new from dealer and they do it before you get it. the body control mod controls all those items and go bad alot.
Posted on May 25, 2009
SOURCE: odometer stopped working
OdometerGears.com has the gears you need to repair your odometer. E20=20 tooth gear and a 16 tooth medium pod The two gears together are $54.00 including the shipping. it is best to replace the gears as a set if you never want the odometer to fail again.
Posted on May 29, 2009
What has most likely happened is that the Heater-a/c unit needs to be recalibrated and here are the steps to do so.
With the engine running and fully warmed up, A/C has to be turned off for at least 5 minutes [don't turn it on at all] and transmission in Park do the following
1. Set the temp control all the way to cold
2. Set the mode selector to Vent so air blows out of the dash panel outlets.
3. Hold down the rear washer button and the rear wiper buttons simultaineously for about 5 seconds until most all of the heater and ac panel lights blink and then release both buttons
6. At this point the system should go into a self calibration test which can take up to 60 seconds. While it is calibrating various control panel switch lights will blink as it goes through it's tests.
7. When the system is done calibrating then just the rear wiper light should be flashing and you can exit the test by turning off the vehicle. Wait about 10 seconds and restart the engine and it should be fine. If both the rear wiper and intermittent light are both still flashing after the calibration then there is most likely a problem with the system that will need more diagnosing. I see this fairly often with battery replacements so I think you'll be ok. It sometimes takes a couple of tries to calibrate so don't give up if it doesn't work the first time. Good luck, hope this helps!
Posted on Jul 14, 2010
Tips for a great answer:
Feb 12, 2013 | 2003 Dodge Grand Caravan AWD
Nov 03, 2011 | 1995 Plymouth Voyager
Aug 02, 2011 | 1997 Plymouth Grand Voyager
Jun 21, 2011 | 2008 Chevrolet Malibu
May 07, 2011 | 1995 Ford Mustang
Jan 03, 2010 | 1994 Plymouth Acclaim
16 people viewed this question
Usually answered in minutes!