Question about Cars & Trucks

Open Question

2005 altima blower motor relay location - Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
deathraider
  • 64 Answers

SOURCE: blower motor relay

there is not a relay , I had same problem and found out that its called a resister . the location is behind glove box , and to the left of the blower motor housing . look for a blue box with about 6 wires plugged into it . It has one screw holding it in , that the resister it is 39.99 @ auto zone and it will have to be ordered Please leave feed

Posted on Dec 02, 2008

Ad
  • 1596 Answers

SOURCE: 2005 Town Country front blower motor inop fuse/relay ok

Break Down And Replace The Blower Motor


REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIR-BAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN AN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY OR DEATH OR DEATH.

NOTE: The blower motor is located on the passenger side of the vehicle under the instrument panel. The blower motor can be removed from the vehicle without having to remove the HVAC housing.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the passenger side cowl trim panel.
  3. Position the carpet to access the front upper screw that secures the air inlet housing.
  4. Remove the recirculation door actuator.
  5. Disconnect the blower motor wire lead connector from the blower motor resistor or power module, depending on application.
    1. Remove the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing.
    2. Remove the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and remove the lower HVAC housing.
    3. Push the rubber grommet through the opening in the lower air inlet housing.
    4. Route the blower motor wire lead through the opening in the lower air inlet housing and remove the lower air inlet housing from the vehicle.
    5. Position the recirculation-air door as necessary to access and remove the three screws that secure the blower motor to the lower half of the HVAC housing.
    6. Gently flex the recirculation air door downward to gain access to remove the blower motor from the HVAC housing. NOTE: To aid in installation, note the position of the blower motor mounting tabs prior to removal
      1. Remove the blower motor from the HVAC housing by rotating and tilting the blower motor as necessary.
      INSTALLATION

      1. Gently flex the recirculation-air door downward to gain access to install the blower motor into the HVAC housing.
      2. Position the blower motor to the HVAC housing and tilt and rotate the blower motor as necessary to install it into the HVAC housing.
      3. Align the blower motor mounting tabs to the locations noted during removal and install the three screws that secure the blower motor to the HVAC housing. Tighten the screws to 2 N·m (17 in. lbs.).
      4. Route the blower motor wire lead through the opening in the lower air inlet housing and seat the rubber grommet.
      5. Position the recirculation door pivot shaft into the lower air inlet housing and install the inlet housing.
      6. Install the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and the lower HVAC housing. Tighten the screws to 2 N·m (17 in. lbs.).
      7. Install the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing. Tighten the screw to 2 N·m (17 in. lbs.).
      8. Connect the blower motor wire lead connector to the blower motor resistor or power module, depending on application.
      9. Install the recirculation door actuator.
      10. Reposition the carpet.
      11. Install the passenger side cowl trim panel.
      12. Reconnect the negative battery cable.
      13. Perform the heater-A/C control calibration procedure.

Posted on Feb 07, 2009

  • 24 Answers

SOURCE: 2001 Saturn L200 Sedan blower motor relay location

it's by the firewall pass side in the plastic blower box. Multi wire plug and two screws are showing.

Posted on Jul 22, 2009

  • 202 Answers

SOURCE: where is the blower motor relay on 95 accord

on the very top of the fuse/relay box in driver's side kick panel. on the very top of the fuse/relay box have 3 relay , the blowe motor relay is the center one.

Posted on Aug 08, 2009

co7196
  • 3433 Answers

SOURCE: 2002 Lincoln Town Car AC Blower Motor Relay Location

Relays are normally located under the hood in a protective plastic box. Good Luck Ned

Posted on Oct 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Manual blower fan on 2005 altima stuck on high


Blower motor resistor is bad common issue with sentras, best to have a qualified Nissan tech replace it, due to the location of resistor

Mar 14, 2015 | 2005 Nissan Altima

2 Answers

Where is the blower motor relay location on a 2005 Chevy Impala


The blower motor resistor is located under the dash on the passengers side between the blower motor and the fire wall. You will need to remove the hush panel first, also if you remove the blower motor the resistor will be easier to replace.

Feb 06, 2015 | 2005 Chevrolet Impala

1 Answer

The heater in my 2005 nissan altima does not blow any air at all


check for loose wiring by heater blower motor if that dont work,take the blower motor out and check it to see if its any good by using two wires connect them and check blower motor on battery posts if it turns then its not that

Jan 15, 2013 | 2005 Nissan Altima

1 Answer

Blower motor not working on 2005 buick lacrosse cxl


Blower operation is handled by the HVAC control module which gets its power from the 10A HVAC fuse in the instrument panel fuse block. There is a blower motor control processor that gets its power from the 30A BATT MAIN 4 fuse in the underhood fuse block. The HVAC control module sends speed signals to the blower motor control processor which turns on the blower motor at the selected speed. Note that there is no relay involved. If you check the fuses and check the path to the blower motor you may find that the motor is OK and the trouble is somewhere else

Oct 15, 2012 | 2005 Buick LaCrosse

1 Answer

Blower motor runs all time


Either the blower motor relay is stuck closed and running all the time.Relay should be under the hood. Look in the owners manual for the location. Also does it shut off with key or continue to run, Most likely a stuck blower motor relay.

Jun 14, 2012 | 2005 Buick LeSabre

3 Answers

2005 Nissan Altima blower motor does not work


Check the direct connection to the blower motor. Check the fuse. Sometimes you can try to put it on high and try hitting the blower motor to see if turns on. It may also be the blower switch or the blower itself.

Nov 22, 2011 | 2005 Nissan Altima

1 Answer

2005 Chevy Trailblazer fan only works on settings 2 and 3. Is the relay going bad and where is it located?


This not the relay, the problem is probably the blower motor resistor pack or the wiring connector for it. These are located near the blower motor behind and below the glovebox.

Oct 17, 2011 | 2005 Chevrolet TrailBlazer

1 Answer

2005 Nissan Altima where is blower motor resistor is located and what does it look like


The blower motor resistor is mounted under the glove box. It is in the corner somewhat covered by the kick panel. The card, at least on my pathfinder, is held in with 2 phillips head screws. The plug has 4 wires, one large wire and 3 smaller wires. You should see it very near to and parallel with the firewall.

May 17, 2010 | 2005 Nissan Altima

1 Answer

Location of fuel relay switch


The fuel pump relay is on driver's side of the car under the hood. It is under a label row of relays. thanks.

Jun 13, 2009 | 2005 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...