Question about Cars & Trucks

Open Question

Corolla verso central locking problem some doors lock at times then dont drivers door wont lock

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

auditech13
  • 43 Answers

SOURCE: Driver door central locking

You need a new door lock unit to fix properly.

Posted on May 28, 2009

  • 6 Answers

SOURCE: Noisy central locking Nissan MIcra

Hi there, this is a very common fault, you need to replace the drivers door actuator to stop the noise, ive done loads of these. hope this helps.

Posted on Jun 07, 2009

  • 1 Answer

SOURCE: How do I remove drivers door handle that key will

Central lock dosen't respond ,put the lights are flashing!Where I need to look my problem?

Posted on Aug 22, 2009

  • 291 Answers

SOURCE: central locking stopped working on my corolla

TWO THINGS TO TRY... FIRST DISCONNECT BATTERY. LEAVE DISCONNECTED FOR TWENTY MINUTES, WHILE DISCONNECTED TURN THE IGNITION KEY TO THE RUN POSITION AND LET SIT...AFTER 20 MINUTES TURN KEY OFF RECONNECT BATTERY.. THEN TRY IF STILL NOTHING, THEN TRY TURNING KEY TO THE RUN POSITION AND LEAVE FOR 10 MINUTES.. THEN TRY IF STILL NO THEN GET BACK WITH ME FOR FURTHER INFO

Posted on Sep 01, 2009

planet-x
  • 232 Answers

SOURCE: problem with Central door lock on peugot 106

there is a switch attached to the back of the door lock that opens all doors, it may have fallen off or become damaged, or the mechanical connection to the lock may have snapped.

if the door itself does not even open with the key on its own, the lock mechanism has become detached from the locking rods inside the door, you would need to take off the door panel and look / feel inside near the lock, there is a thin rod connected to the actual locking part and the part the key is inserted into, as well as the internal lever to open or lock the car, it may have popped off. The key-lock itself is usually held on by a thin flat round circlip-washer affair, this may have slipped out too and the key-lock is not connected any more.



Posted on Oct 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 toyota corolla verso remote won't unlock


This one you may be stuck paying the 50 dollars but what I would do first is contact the manufacturer of the remote control. I would bet they will help you out. The other option is to go to an after market installer of car alarms that is a bit smaller. They will most likely help you in the hopes of you coming back for further business.

Mar 17, 2014 | Cars & Trucks

1 Answer

Toyota corolla drivers door not locking/ unlocking with key


Check the connector inside the door, whether is broken or not

Mar 09, 2014 | 1997 Toyota Corolla

1 Answer

CENTRAL LOCKNG


double posted,
Check all fuses... in cab and eng. bay.
try again, again, say what dont work?
key fobs (all) dead??
or keys actual, or what,
what works and what dont. ???????????

central locking is complex. lots of switches fob and doors.
try saying what dont work exactly , instead of just central.......

Dec 30, 2013 | 1998 Toyota Corolla

1 Answer

Drivers door wont open


Chrysler2008 sebring drivers door wont open all other doors and central locking working including drivers door but will not open any suggestions..

Jun 01, 2012 | 2007 Chrysler Sebring Sedan

1 Answer

1997 toyota corolla drivers door lock not working...


http://www.manualowl.com Hope this helps! Jimmy

Apr 10, 2012 | 1997 Toyota Corolla

1 Answer

Central locking not locking all locks from drivers door, will unlock, but not lock. working fine on passenger door with key, locks all. switch to activate central locking on drivers door unlocks but doesnt...


You will need to replace the driver door switch. You can try to pick a switch up from the dealer or a local car wrecker (i.e. Pick-n-Pull). It will involve learning to take apart the door trim panel.

Sep 05, 2011 | 1993 Toyota Corolla

3 Answers

Toyota corolla verso 2007 . the central locking has stopped working


Toyota Corolla Verso - Central locking has just stopped responding


So you don't waste your time, here are some assumptions: -

1. When I press the key fob there is no sound of doors trying to lock/unlock and I know the key fob is fine.


Solution:


In this situation reset the alarm/locking system

Below is the procedure I followed to get the central locking working again: -

Open the passenger door, and look at the side of the dash board. There should be a triangular panel. Pull the panel off to reveal a small set of fuses(see the back of the panel for the fuse map). To power down the central locking you need to remove the Dome Light fuse, this is located top left. Second one down 7.5 amps. (if in doubt remove the top two 7.5 amp fuses I did)

When you remove the fuse(s) you will notice the interior light go out indicating you have powered down the system.

Now leave them out for at least 30 mins so any capacitors can discharge properly. (Be aware while the fuse is removed all central locking is disabled, so the other doors are open. I left the fuse(s) out over night with all the doors open but I don't recommend it, 30 mins should be fine)

After 30 mins replace the fuse(s) close all doors, and then try your key fob, hopefully you should here that satisfying locking sound.


2. When I press the key fob I hear the locking system trying to engage.

This could be a faulty door switch on any door including the boot, or there could be a dent in the inner door panel of any of the doors, usualy the rear doors due to the seat belt not retracting properly.

Solution:

Check all door switches for damage, and check inner panel for dents, just a small dent where the switch connects can be enough to not engage the switch. This will stop the central locking.

Use some kitchen roll wrapped in tape (as a makeshift pad) and tape to the inner door as a temp measure to engage the door switch. At least you can then lock the car.


Jan 04, 2011 | 2007 Toyota Corolla

2 Answers

Passenger door wont unlock, key turns in the lock but door wont unlock. Electric locks dont work. Driver door works fine 1991 Nissan pathfinder XE 4door


2006 Nissan Pathfinder rear passanger doors don't open unless opened from insinde handle first. Then will open all the time until central locking is used then same problem occurs

Apr 03, 2010 | 2001 Nissan Pathfinder

1 Answer

How to repair central locking


first check blown or missing fuses 2nd locate locking module open it up and fire the neg side of the relays with a test light if the locks fire your master door motor is shot located in driver door if they dont fire check your module has power if so it may be faulty

Jun 20, 2008 | 1991 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...