Question about Cars & Trucks

Open Question

Change door hinge on 1987 xjs jaguar

Remove and replace door hinge on driver side of 1987 xjs jaguar

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 508 Answers

SOURCE: How to replace '96 Ford Explorer driver side exterior door handle

You will need to remove the door panel to gain access to the handle. Roll the window up or down as needed to get to the nuts that attach the handle to the door. You will also need to remove a rod the goes to the door lock. You will see the rod after the door panel is removed. Good luck.

Posted on Feb 18, 2009

  • 260 Answers

SOURCE: Need to grease driver side door hinge on our 2005 Sienna.

If you can get a can of lithum grease in a spray can use the straw to spray on inside of hinge this may save you time.

Posted on Apr 09, 2009

  • 1 Answer

SOURCE: how do i remove the drivers side door panel? need to access wiring to replace the drivers side mirror.

how do i replace the side mirror on 94 acura integra

Posted on May 29, 2009

  • 21 Answers

SOURCE: Driver side door problems

Get a set of hinge pins and bushings. There is a tool that you can get at harbor freight or tool king for removing the bushings. I use a floor jack and a 4x4 block of wood to support the door. you will need a spring compressor to remove the door "hold" spring. Once you have that removed, you can use a brass drift or similar rod to tap the pins out. once they are out the door will be resting on the wood. I use heater hose to wedge between the fender and the door to prevent dents and scratches. tap out the bushings. ever so gently tap in the replacements. apply a generous helping of white grease to the bushing and pin. line up the door and insert the pins. you may have to apply an ever so light amount of tapping pressure on the pins to set them final. reinstall the door spring and lube the joints with white grease. be proud of yourself as your just saved a **** load of money.

Posted on Jun 01, 2009

  • 1986 Answers

SOURCE: door panel removal

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Obd connector location for 1995 jaguar xj6


the data link connector is located under the dash. Next to the centre console expect for xjs and for an xjs it is under the dash near the drivers kick panel in front of the door

Dec 14, 2013 | Cars & Trucks

1 Answer

How to remove a fuel line from the fuel tank on a 1994 jaguar xjs convertible


under the drivers side rear of car there are 2 quick disconnect lines you push and turn and they pop loose

Aug 06, 2013 | 1994 Jaguar XJ6

1 Answer

How do i change glass in left rear window of 93 xjs


remove rear seats and relevant side panel trim ithink it all comes out as one

Apr 19, 2013 | 1993 Jaguar Xj Series

1 Answer

Trunk will not open fuel door will not open all fuses ok


You have listed the vehicle is a 1987 Jaguar XJ6. The trunk is not electronic and only unlocks with the key as well as both the gas doors. Any issues here then it is your key or the actual trunk latch. If you do have a 1988 model year then the trunk lock has 3 positions. locked all the time, unlocked all the time or the vertical position locks and unlocks with the vehicles drivers door lock. If the trunk button (paddle) is loose and moves but nothing happens then the inside rod has come loose and you will have to manually operate the latch by removing the license plate and taking a long screw driver through the lower plastic bungs. The fuel flap is a separate unite and does have a manual release but you need to open the trunk to get to it. If the fuel flap stays locked all the time then the actually filler neck module will need replacing.If you have a 1997 which has the electronic release button to open the trunk (95-2003) Then you will need to firstly lock all door and unlock the drivers door 2 times. Check the fuel flap is now released, if not then the fuel flap actuator located on the filler neck inside the trunk is bad. If the trunk does not open with the remote, inside car switch and trunk mounted switch then the passenger side trunk harness is broken. Open the trunk with the key and on the right(passenger) hinge there is a grey plastic cover, remove that cover and carefully peel back the wiring harness cover and you will find 1 or more broken wires. Once the wires are repaired then I recommend you zip tie them in place and retest the trunk release button.If this does not answer any of your questions please feel free to email mejpseuro@gmail.com

Jan 23, 2012 | 1987 Jaguar XJ6

1 Answer

Ive recently bought a 1988 jaguar xjs 3.6 auto coupe and both electric windows dont work. ive noticed there are no fuses to change in its manual and that it has a reset button but i cannot locate it. can...


Amazing cars and fun too! It is not uncommon for these motors to fail. Sometimes if you smack the door just right or try to activate the window switch while closing the door. If it activates, replace the window motors. If you have a volt meter, you can remove the door panels and check to see if you are getting voltage to the motors while activating the switch. Let me know.

Oct 20, 2010 | 1985 Jaguar XJ6

1 Answer

I am trying to locate the chrome LHS door mirror for 1989/90 XJS 5.3 V12


jaguar owners club.co.uk will be able to assist (if its just the glass get some cut locally.use double sided carpet tape to stick it on over the old))

Oct 04, 2010 | 1989 Jaguar XJ6

1 Answer

How to find and change fuse for drivers seat in 1995 Jaguar XJS convertible?


hi, there are fuse pannels on the side of the footwells on both side of your car, i know the side lights, head lights are on the left hand side (in britian left meaning (near side to the kerb)) not looking at the car from outside

Sep 07, 2010 | Jaguar XJS Cars & Trucks

2 Answers

1987 xjs hood is stuck car has been sitting for years


it lifts from the back and tilts foreward ,their are two cables running from the interior lever ,best thing is for you have a look at another one and if you can jack car up and try to reach each lever in turn with a long screwdriver and push or pull it with a wire .best of british with it

Jul 09, 2009 | 1987 Jaguar XJ6

1 Answer

1989 jaguar xjs front door lock assembly?


You may find it in this document if you download it.

www.arh.ee/jaguar/Xjs_help.doc

Dec 14, 2008 | 1986 Jaguar XJSC

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...