Question about Ford Ranger

Open Question

2003 ford ranger od light blinking - Ranger Ford Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

davesmith_37
  • 94 Answers

SOURCE: where is the pcv valve located on a 2003 ford ranger

  • The PCV valve can be located in several places. The most common location is in a rubber grommet in the valve cover. It can be installed in the middle of the hose connections, as well as installed directly in the intake manifold.
  • Once the PCV valve is located, make sure all the PCV system hoses are properly connected and that they have no breaks or cracks.
  • Remove the air cleaner and inspect the air and crankcase filters. Crankcase blowby can clog these with oil. Clean or replace such filters.
  • Oil in the air cleaner assembly indicates that the PCV valve or hoses are plugged.
  • Make sure you check these and replace the valve and clean the hoses and air cleaner assembly.
  • When the PCV valve and hose are in satisfactory condition and there is oil in the air cleaner assembly, perform a cylinder compression test to check for worn cylinders and piston rings.
  • Posted on Feb 27, 2009

    • 257 Answers

    SOURCE: 2003 Ford Ranger, 5 speed manual. Sometimes I

    if you have a slave cylinder on it my not be working right,, if you have levers maybe a brushing wearing out cause wobble

    Posted on Aug 12, 2009

    Testimonial: "Thanks, I'll check it out."

    • 4336 Answers

    SOURCE: 2002 Ford Ranger transmission slipping?

    The longer you drive with that condition, the more damage you will cause. Park it until you can repair it.

    Think of it as how long would you think it is okay to run your engine without oil? Zero.

    Doc

    Posted on Sep 14, 2009

    • 115 Answers

    SOURCE: O.D light blinks, won't shift, runs rough at low rpms 2003 F-150

    This is likely your electronic speed sensor. On my 2003 F150 it would rev quite high before finally shifting into 2nd. and my O.D light would blink also. The speed sensor is located under the vehicle about halfway back on the frame on the passenger side. The part costs about $70 and is a fairly easy repair.

    Posted on Mar 05, 2010

    csmock132
    • 4669 Answers

    SOURCE: changing clutch on a 2003 ford ranger how do I

    Well to start, you need to remove the shifter from the transmission. Then remove the driveshaft. Then unplug the plugs from the side of the transmission and disconnect the clutch fluid line. Then remove the crossmember. Unbolt the bellhousing bolts. Then have a friend help you remove the transmission. Then unbolt the clutch.

    Posted on Jul 09, 2010

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    2 Answers

    2013 ford ranger speedo cluster dead


    Check for shorted wire for OD switch in steering column if you have OD, common issue

    Apr 14, 2016 | Ford Cars & Trucks

    1 Answer

    Od flashing; high rev at low speed; no dtc.


    Bad Sleeves - Ford Servo Bore Transmission Fix Solution

    www.fordservoboretransmissionfixsolution.com/blog/bad-sleeves
    Original owner let it run low on fluid because of leak. ... The worn bores will cause slipping, hard shifts, and high revs between shifts from those gears. ..... Andy I bought a 02 mercury mountaineer v6 4.0 the the O/D flashes and service light is on ... Get on a flat surface at highway speeds and manually turn the OD of and on.

    "O/D off" light blinking on dash? please help anyone? - Discussion ...

    www.topix.com > Ford Explorer
    Aug 24, 2009 - i have a problem with my 2002 ford explorer sport trac OD blinking... it will turn of if i .... That wire led down to the transmission speed sensor. ... the O/D off light started flashing and its revving really high before it will change ... 2004 Jeep liberty problems
    Dec 9, 2011
    Ford Explorer O/D Light, Slipping Transmission
    Nov 20, 2011
    2003 Ford Escape Rough Idle/Engine light blinking
    Apr 20, 2011
    FLASHING O/D OFF LIGHT 1995 EXPLORER V6 EDDIE BAUER
    Dec 3, 2009
    More results from www.topix.com

    Dec 05, 2015 | Cars & Trucks

    1 Answer

    My 2003 Ford Ranger marks incorrect 3rd. gear ratio what can the problem be?


    The OD light is flashing due to a transmission problem. Have it scanned for fault codes.

    Mar 26, 2014 | Cars & Trucks

    1 Answer

    Auto trans od


    Scan for codes? Can be vavle body seloniod or vavle body gasket

    Mar 09, 2014 | 2003 Ford Ranger Regular Cab

    1 Answer

    Od light flashing 2003 ford explorer


    You need to have the transmission scanned for fault codes, the light blblinks only when the transmission control module detects a fault, in this model it is usually the result of the computer seeing excessive slippage, you may not fell it but sooner or later it may fail completely. Before deciding whether the ****** is defective have the system scanned by a ****** repair shop for the blinking light.

    Sep 11, 2012 | 2003 Ford Explorer

    1 Answer

    O.D light blinks, won't shift, runs rough at low rpms 2003 F-150


    This is likely your electronic speed sensor. On my 2003 F150 it would rev quite high before finally shifting into 2nd. and my O.D light would blink also. The speed sensor is located under the vehicle about halfway back on the frame on the passenger side. The part costs about $70 and is a fairly easy repair.

    Feb 21, 2010 | 2003 Ford F150 Regular Cab

    1 Answer

    2003 FORD RANGER/BLINKING LIGHTS


    not sure but in the newer cars the ground wires seem to be most important becouse the ecm is working through the groung side. i would start by finding ALL the grounds and cleaning and tighting them

    Apr 06, 2009 | 2003 Ford Ranger Regular Cab

    1 Answer

    Overdrive light blinking


    Have a mechanic check for loose wires going to the transmission. Usually when the OD light blicks it's because there is something wrong with the transmission. Have your transmission fluid checked. If it appears brown, dark, or smells burnt have it and the transmission filter replaced immediately. It may also be that you have a leak in the transmission and need to add transmission fluid so that it's at the right level.

    Nov 24, 2008 | 2000 Ford Ranger SuperCab

    1 Answer

    200 Ford Ranger V6


    The trans has failed, is the OD light on the shift handle blinking? in any event you need to get the transmission control module tested for trouble codes, this will give us some idea of what has happened.

    Oct 22, 2008 | 2000 Ford Ranger SuperCab

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    42 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    75797 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22114 Answers

    fordexpert

    Level 3 Expert

    5495 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...