Question about Cars & Trucks

1 Answer

Our cs56 pro will idle all day but it won't rev up

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Cars & Trucks Master
  • 1,669 Answers

That CS-56 soil compactor is set up with a govenor to stay at a fixed speed! If you need to change the speed you need to reset the govenor bu adjusting it to tighten the spring. If the revs increase in that direction OK, otherwise turn the adjustment the other way!

Posted on Jan 01, 2013

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5370 Answers

SOURCE: starts,idles & runs fine, but won't rev over 2400

This is indication of faulty MAF sensor. Its located on the air inlet, look and the air filter box and follow it to the engine there inline you will see the mass air flow sensor and the air intake temp sensor is built into the mass air flow sensor. when you locate the air filter box you will see the maf sensor its bolted to air box.Make sure the connector is good and also the wiring.Remove the MAF sensor, clean it and recheck.Also try driving without MAF sensor.If its revs fine, then its faulty MAF.------- This should help.Thanks.Helpmech.

Posted on May 19, 2011

jayhawke
  • 338 Answers

SOURCE: My ford exporer won't rev pass 2000 it will idles

check fuel filter- replace more than likely- if does not fix- look at catalytic converter- may be melted

Posted on May 30, 2011

  • 2 Answers

SOURCE: 2003 Envoy (v8) loses power and key won't come

I have a same problem. need help

Posted on Jul 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 Nissan 200sx won't rev past 4000 RPM in neutral. What's the cause?


STOP doing that, forget about it, your going to blow your engine !

Mar 06, 2013 | 1998 Nissan 200SX

1 Answer

Santa fe idles but will not rev above 2000 rpm's - won't take a load


make sure you have the wires in the right places. (see pic)
Make sure you did not leave something unplugged. (sensor/vacuum line)
12_22_2012_10_22_13_pm.jpg

Dec 22, 2012 | Cars & Trucks

2 Answers

96 Taurus. Won't rev over 4000 revs even in park or neutral


That is the rev limiter kicking in at idle.

Oct 02, 2012 | 1996 Ford Taurus

1 Answer

Crx will idle won't accelerat


I had the same problem with my 91' crx it would idle and have a low rev i adjusted my tranny cable located below the battery tray and accelerated and shifted fine afterwards

Jul 07, 2012 | 1989 Honda CRX

2 Answers

I have a 1993 300zx twin turbo that's heavily


you are SURE you have enough fuel pressure? like 60?

Feb 19, 2012 | 1993 Nissan 300ZX

1 Answer

2001 tahoe 5.3 stalls in a slow hard turn to lft or rt. Service eng light on. checked power steering(good). found that wife didnt put gas cap on correctly. been loose for a few days while driving. just...


What codes do you have?

You have a service engine lamp on
Have to start there

Also the turning thing, tells you something,maybe

The idling won't do a thing

The EVAP System may not run a monitor for days
& you have to drive under certain conditions for it to run

Sep 20, 2011 | Chevrolet Tahoe Cars & Trucks

1 Answer

My ford exporer won't rev pass 2000 it will idles


check fuel filter- replace more than likely- if does not fix- look at catalytic converter- may be melted

May 30, 2011 | 2003 Ford Explorer

1 Answer

Had a question bout my mazda rx8 I was driving it one night it was running fine the next day went out and it won't turn over it takes awhile bit it finally starts and idles real rough and you give it...


Too many possibilities

Won't turn over is one problem -battery,cables,grounds,
starter,solenoid,etc

Idles rough-- vacuum leaks,spark plugs never replaced,
egr valve etc

Worn O2 Sensors
Dirty MAF Sensor
Old Fuel Filter

You have to go into a lot of technical detail & history
on your vehicle, for us to even guess.

May 23, 2011 | 2005 Mazda RX-8

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...