Question about 1994 Eagle Vision

1 Answer

Remove gauge cluster from 1994 eagle vision

None of the gauges work, neither does the overhead display and fan for the AC/heater. Had strong electrical smell when all the above stopped working. I believe the problem to be with the gauge cluster and need to know how to remove them for inspection and repair.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 755 Answers

I do not think that this is your problem ,if you smelled some wires burning you had a short under the dash or something , I very rarelly seen clusters go bad find your short first , this may also be why your lights are not working right either

Posted on Feb 03, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 62 Answers

SOURCE: Eagle Vision overheating

look for bleeder screw on thermostat housing or front middle of intake manifold area.open bleeder while vehicle running bleed air out.

Posted on Jul 27, 2008

  • 2 Answers

SOURCE: Chrysler Vision (Eagle Vision) A/C ventilator works all the time at max.

The problem was in ventilator valve resistor, located below glow box, near ventilator. A transistor replacement did the job!

Posted on Sep 08, 2008

justuscc
  • 360 Answers

SOURCE: 1996 eagle vision over heating

look for leaks on the passenger side!!!! also this car has a "air pocket" you need to find the bleed off screw on the upper hose fitting on the engine and bleed it when filling up with coolant

Posted on Sep 18, 2008

  • 512 Answers

SOURCE: my eagle vision radio is not worrking i need the owners manual

check fuse 2 and 13 in the fuse block inside the car

Posted on Dec 04, 2008

localwonder
  • 6784 Answers

SOURCE: 1994 eagle talon is not starting up!

i would check the coil or, distributor unit and wires then, i would also check the battery for weakness. if the batt is fine, check the starter and wires that lead to the starter as well. sometimes the starter wires can jiggle themselves loss at times. hope that helps ya and thx for using fixya:)

Posted on Feb 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

None of my gauges are working ion my dash


Intermittent gauges usually mean a bad ground connection for the gauges. Things to check: look for multiple ground connections at one screw to chassis frame & tighten it; check large connector at rear of instrument cluster for good connection; replace gauges fuse - it can be cracked. If none of those work, than instrument cluster circuit board will probably have to be replaced - which means removing the cluster.

Jul 13, 2014 | 1997 Eagle Vision

1 Answer

Intrument cluster


If all gauges cut off, its is likely a power supply problem not the cluster. Try wiggling the rear connector, unplug and re-plug to "wipe" the connections.

Jan 26, 2014 | 1995 Eagle Vision

1 Answer

What makes gauges work none of them are working


if none of your gauges are working, then you have a wiring problem with the gauge cluster. check all the connectors going into the cluster for tightness and any dirty or corroded connectors

Feb 06, 2010 | 1998 Dodge Dakota

1 Answer

Flasher relay 95 Eagle Vision


use channel locks and rip it out

Jan 12, 2010 | 1995 Eagle Vision

1 Answer

How do you get to the heater blower motor of a 1994 eagle vision


You will have to remove your panel off and then you will see it just after heater/AC controller (climat control panel) to your left side

Dec 10, 2009 | 1994 Eagle Vision

1 Answer

None of the dash gauges work on my 99 jeep Cherokee


remove the cluster clean contacts with dielectric spray then apply dielectric grease to connectors and reinstall if this doesnt help you need a cluster

Aug 05, 2009 | 1999 Jeep Cherokee

2 Answers

1996 eagle vision tsi fuel,speedometer,temperature gauges


do you have an amp for the stereo could also be a bad ground most common from big ground on batt should also be a small ground to body let me know

Feb 02, 2009 | 1996 Eagle Vision

1 Answer

1996 eagle vision over heating


look for leaks on the passenger side!!!! also this car has a "air pocket" you need to find the bleed off screw on the upper hose fitting on the engine and bleed it when filling up with coolant

Sep 18, 2008 | 1997 Eagle Vision

Not finding what you are looking for?
1994 Eagle Vision Logo

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Eagle Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Stewart Dibbs

Level 2 Expert

267 Answers

Are you an Eagle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...