Question about Cars & Trucks

1 Answer

Can I take a inline 6cyl out of a 1997 jeep grand cherrokee laredo and put it in a 1995 jeep grand cherrokee laredo

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 2,101 Answers

Yes you can just use the sensor off the good motor

Posted on Jan 01, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
fastboyz
  • 674 Answers

SOURCE: Airbag light indicator: Jeep Grand Cherokee 1997

there are many sensors and and each airbag have sensors so you will have to get it scanned to know where to start. just a note air bag parts can be very expensive so check out your local salvage yard. they can save you hundreds. good luck
paul

Posted on Sep 28, 2008

motor1258
  • 6674 Answers

SOURCE: diagram or location of knock sensor

Look under exhaust manifold on drivers side, closer to rear of engine . mounted on engine block.

Posted on Jun 01, 2009

  • 57 Answers

SOURCE: 1999 jeep grand cherokee laredo 4.0 litre

OK here we go you will need a test light for the following tests, i will try to be as descriptive as possible so lets get started

fist start the engine and turn on the a/c that should command the fan on.
right front engine compartment next to the battery is the power distribution center pop off the top, ground your test light to the negative battery terminal and find fuse number 10 it is a 40 amp fuse check both sides of this fuse with your test light, if you have power on both sides of the fuse than we shall go further.

unplug the connector from the cooling fan, there should be two wires in the plug one is dark green and the other is black with a pink tracer, with your test lite grounded to the negative battery terminal check the dark green wire for power, if there is power there than move your test light ground clamp to the battery positive terminal and test the black wire for ground,
if testing the black wire made the test light shine than the ground circuit is good, if it did not than check you ground connection behind the right headlight.
when testing the dark green wire, if the dark green wire made the test light shine and the ground circuit is good than you simply have a bad coolant fan motor.

I suspect you were not getting power to the fan motor so you will need to take a look at the radiator fan relay, this is a special solid state relay mounted to the inside of radiator core support on the right side down behind the bumper.

here you will find a single plug with 4 wires in it

black = ground
dark blue / pink = relay controll from pcm
dark green = output to radiator cooling fan
gray = battery power from fuse # 10 in pdc

unplug the relay ground your test light to the battery negative terminal, with the engine running and a/c turned on check the gray wire the test light, it should turn on if not recheck fuses.

move your test light to the battery posistive terminal and test the dark blue / pink wire, if the test light turns on than you have a bad radiator fan relay, you can pick one up at your local parts store for about $85.00 just make sure you get a high quality one the cheap ones have a hard time with the amprege consumption of that fan.

good luck

wesley schacht@hotmail.com

Posted on Jun 14, 2009

  • 9 Answers

SOURCE: What type of transmission does my 95 jeep grand

If you call a dealership with your VIN # they should be able to look it up for you.

Posted on Apr 20, 2010

ZJLimited
  • 17970 Answers

SOURCE: Could you tell me where

zjlimited_1234.jpg

Fig. The coolant temperature sensor is installed in the thermostat housing (click image for zoom).

  1. Partially drain cooling system until coolant level is below cylinder head.
  2. Disconnect coolant temperature sensor wire connector.
  3. Remove sensor from thermostat housing.
Hope helps (remember to rate ths answer).

Posted on May 12, 2011

Testimonial: "This is an excellent community. Thanks for the help!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1995 jeep grand cherokee laredo 4.0 inline 6


Something mechanical, ignition, or fuel.
It can run rough under a load such as in gear and ok in neutral with no load. Have you checked the plugs and dist cap ?

Feb 11, 2014 | Jeep Grand Cherokee Cars & Trucks

1 Answer

How do i know if my 95 jeep grand cherokee laredo 4.0 inline 6 is an interference engine


You have a timing chain that is good for the life of the engine. The only thing that could need replacing is the chain tensioner if it starts to make noise.

Jan 31, 2014 | 1995 Jeep Grand Cherokee

1 Answer

Is a 1995 jeep grand cherokee limited v8 vs. inline 6 transmission interchangeable?


No sir they will not interchange. i worked at a transmission shop for 7 years. the inline 6 has a 500 trans in it and the v8 has a 518 trans in it. the bellhousings are different.

Jan 03, 2014 | 1995 Jeep Grand Cherokee

1 Answer

If you install an after market stereo in a 2004 jeep grand cherrokee laredo what would cause it to only come on when you turn the headlights on


Wrong connection. Your stereo should be connected to the red/WHT wire from 25A fuse 5 in the junction block

Sep 23, 2012 | 2004 Jeep Grand Cherokee

1 Answer

What is the maximum parasitic draw with the ignition off for a 1993 Jeep Grand Cherokee Laredo inline 6cyl 4.0 liter?


I'm not sure they have vehicle specific parasitic draw tests, but I've heard that it should never exceed 0.2amps but I also think I've heard 0.5amps somewhere else. The modules and lights must be off when checking these things too which I'm sure you know (the door can't be open to pull fuses inside).

Jun 29, 2011 | 1993 Jeep Grand Cherokee

1 Answer

How to disable the alarm system on a 1997 jeep grand cherokee laredo


i have a 1997 jeep grand cherekee laredo and am having a problem with the alarm its a factory alarm it whent off and i cant get it to reset i tryed everything i could locking and unlocking the doors i put all new fuses and relays in i even unpluged top dash alarm sensor and body control module and it just dont want to reset and it dont want to run at all how can i take care of the problem

Nov 25, 2010 | 1997 Jeep Grand Cherokee

1 Answer

What type of transmission does my 95 jeep grand cherokee laredo inline 6 4x2 have?


If you call a dealership with your VIN # they should be able to look it up for you.

Apr 15, 2010 | 1995 Jeep Grand Cherokee

1 Answer

1995 jeep cherokee laredo engine number location and fuel tank capacity


the fuel tank capacity if it is a 6cyl. 4.0l then it should be about 20 gallons

Dec 28, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Wipers, windows radio and power outlet does not work the fuses i found under the hood are all ok this is on a 1996 jeep cherrokee grand


try fuses on inside of jeep, usually located under dash, usually have to remove cover with screw driver to see.

May 11, 2009 | 1997 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...