Question about 2000 Chevrolet Suburban

1 Answer

2000 chevy suburban 2500 4x4...im getting spark to coil packs but not to plugs and also no fuel to check valve on fuel rail...have already replaced crank shaft sensor and fuel pump and checked fuses and relays

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,101 Answers

Have you checked the ignition control module in the distributor

Posted on Jan 01, 2013

  • josh hendon Jan 01, 2013

    naw...wasnt aware this model had distributor...thought only the GOOD old motors had them...where is location of ?

  • josh hendon Jan 01, 2013

    no distributor...coil packs

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2000 chevy blazer, truck cranks

Does your battery go dead?

Posted on Dec 18, 2008

GM Elec
  • 1000 Answers

SOURCE: 92 Chevy Suburban Electrical Fuel System

I assume the fuel pump fuse is good?
The only time voltage will be sent to the fuel pump will be the first 2 to 3 seconds if the starter is not engaged. You will want to crank the engine over and check for voltage on the load side of the relay, circuit #30 at the relay.
Let me know after you check.
Regards,

Posted on Feb 23, 2009

sledge1863
  • 149 Answers

SOURCE: 1995 lumina cranks but will not start

Sounds like it has jumped timing, dont know which engine you have so could be chain or belt.

Posted on Mar 23, 2009

Davaith
  • 56 Answers

SOURCE: 2000 chevy venture doesnt start

Not the IAC, or MAF, or 02

Does the Van Crank over?
Have you checked the IGN Relays? 1,2,and 3?
How did the Battery test out?
Anything below 11.9v battery is dead.
So I suggest that you do not throw any more parts and check the battery again.

Posted on Jul 15, 2009

  • 490 Answers

SOURCE: 1999 V6 CAMARO 3.8 LITRE ENGINE STALLING PROBLEMS

with all of these replacement parts done,you have one of two things I can think of.
The computer can cause this and not show up on and equipment,I seen it happen,it a chance you would have to decide to take.
the other it would have to be mechanical something with your engine itself that is not showing yet.

Posted on Aug 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trying to locate spark plugs on 99 crown vic police interceptor engine


They should be mounted down in the cylinder heads, you'll need to remove each coil pack. A long extension and 5/8in spark plug socket and an extendable magnet will help. Also, you may need to remove the fuel rail to get to move the coil packs.

Oct 17, 2010 | 2000 Ford Crown Victoria

2 Answers

How to replace spark plugs on 2000 jeep cherokee classic 6 cyl.? Also does 2000 cherokee have inline fuel filter?


TO REPLACE SPARK PLUGS YOU REMOVE COIL PACK MOUNTING BOLTS THEN REMOVE THE COIL PACK WITH BOOT OVER THE SPARK PLUG.YOU HAVE 6 INDIVIDUAL COIL PACK TO EACH CYLINDER. YOU NEED A 3/8 RATCHET WRENCH - LONG 3/8 EXTENSION -SPARK PLUG SOCKET - SPARK PLUG GAUGE.AND TORQUE WRENCH.THE 2000 MODEL JEEPS FUEL FILTER INSIDE THE TANK.1993 - 1996 MODEL JEEPS FUEL FILTER LOCATED LEFT SIDE OF THE VECHICLE NEAR THE FUEL TANK.

Jul 20, 2010 | 2000 Jeep Grand Cherokee

2 Answers

Not turning over. will crank. already replaced spark plugs dist cap rotor button spark plug wires ignition coil and crankshaft position sensor. im out of ideas


Is it getting gas? If so then check the ignition module and before that check that power is getting to your distributor.

May 06, 2010 | 1997 Dodge Dakota

2 Answers

I have a 1999 chevy blazer that died and will not start


Looks like you've covered the basics, make sure the firing order is correct with your spark plug wire replacement. Hope this diagram helps.
graphic.aspx?mod=reptiff&module_id=1&session_id=%7b5cc52220-8f88-4d0e-a430-d6f1cb46d743%7d&image_guid=95c27211&print_bw=0&

Mar 01, 2010 | 1999 Chevrolet Blazer

1 Answer

Looking for plug in on the Expedition 2000


There on top of motor under coil pack's, coil pack's held on with an 8mm bolt, sit right under injector fuel rail, disconnect harness to coil pack's remove 8mm bolt remove coil pack and remove spark plug's.Hope this was helpful.

Dec 08, 2009 | 2000 Ford Expedition

1 Answer

On a 2000 Mercury Marquis, do you need to remove


The fuel rail can stay in place. Loosen the 7mm headed screw that secures the coil pack and loosen and rotate the coil out. The rubber part of the coil allows enough movement to get it around the fuel rail.

Dec 04, 2009 | 2000 Mercury Grand Marquis

1 Answer

I Have A 2000 Grand Cheroke The Car Will Not Start Will Turn Over OK I Changed The Coil Pack With No Results


First off insure that you are getting spark to the plugs. If no spark after changing the coil check the cam plate in the distributor and check the crank sensor mounted on the top of the tranny bellhousing next to the engine. If you have spark check and make sure you are getting fuel to the engine. Find the serator valve on the fuel rail push in the little valve and see if fuel is coming out. If no fuel at the rail check and see if it is coming out of the filter. If no fuel at the filter the pump is not working check the fuses and make sure you are getting power back to the pump if you are getting power the pump is probably bad.

Oct 04, 2009 | 2000 Jeep Grand Cherokee

1 Answer

My buick will not start. if i hold down the gas pedel it will the start but if i let it up the car will die. what might be wrong?


One or both of your coil packs are likely faulty and not all cylinders are getting spark.

A plugged fuel filter may also cause this. As well as bad fuel pump. I would first check to make sure that you are getting spark to all cylinders first. You can remove one plug at a time and lay on engine block, have someone else turn motor over while you watch to see if every plug is getting spark. Do one plug at a time. If one or two plugs aren't sparking, than coil pack is bad, If not spark, then crankshaft position sensor is faulty.

If spark is good, check for fuel pressure at fuel rail. there is a test valve on the rail. If pressure is low, then filter could be plugged, or your fuel pressure regulator is faulty. You can test power to it with a voltmeter. Or test unit itself with an ohmmeter.

You can go to autozone.com and register for full free online repair manual.

Sep 23, 2009 | 2000 Buick LeSabre

3 Answers

1992 Pontiac Grand PrixPower loss,erratic idle


spark plug gaps are very critical on computerised cars!! [some wont even start!]
distributor module may be breeaking down as temp rises they fail!
otherwise do compression check as it may have valve problems
also check plug leads & injectors aswell as the fuel pump pressure [ could bestarving for fuel]

Jul 18, 2009 | 1992 Pontiac Grand Prix

Not finding what you are looking for?
2000 Chevrolet Suburban Logo

168 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...