Question about Cars & Trucks

Open Question

How do you solve Enemy #1 Puzzler's? The solution diagram is wrong.

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Jeep Cherokee- we just purchased last week.... front wipers won't work. Checked fuse- it's good. Ran wire from battery to wiper motor- it works. Ah ha.... no relay.... purchased relay- NOW......


You can not solve by guessing

You need wiring diagrams, so you know what is
in that system & what is most likely the problem

Then you test to confirm,never replace any parts
until tested & fail a test

Wish & Hope-Push & Poke Not a diagnostic strategy

Nov 24, 2012 | Cars & Trucks

2 Answers

My cars steering is really loose. Everytime i drive it gets worse. Its a 2000 toyota camry. I took it in to a couple shops and nobody could find what was wrong with it, all said it looked fine just maybe...


You say the steering feels loose
You say it is getting worse

Two shops & nothing wrong !!

If it was mine, I would be careful using it, or not use at
all, until repaired

It is not possible what you say & nothing found
by a repair shop.
Those shops obviously don't care & may be incompetent,
based on the fact, you know the steering has issues

They knew & you now know that an alignment wouldn't solve
your issues

The alignment shop is questionable as well because an alignment
only shop not some place in a shopping mall,usually find worn
parts & replace before they would ever attempt the alignment

They also knew that flushing fluid won't solve the worn parts issue

So you got the run around like what I believe happen all too often

Did you really explain the problem & did you go for a ride at all those
places with you as a passenger & a mechanic driving,if not then my
opinion is that they never planned on diagnosing the problem with
the steering & you can testify to that

I can't from the internet tell you if you have a bad lower ball joint,loose steering rack bushings,bad tie rod ends, worn steering
rack or other possible items,but you see how these places operate
& you see the list of parts I suggest that could contribute.

You have my sympathy & I don't know how to help you find a
honest & capable shop,that is why I have always done my own
repairs & never have any problems diagnosing & solving things
once & done.

Oct 12, 2012 | Cars & Trucks

1 Answer

GMC Sonoma automatic Transmission Problems, engine rev's in D & 3rd


First check trans. fluid. It should be full, & clean. Clean means light red color fluid (like red cool-aid) if it looks like darker red, or brown fluid, like motor oil, that is way too dirty & should be flushed. May need to change the filter too. dirty trans. fluid is your big enemy. could also be an electrical problem in the trans like a shift solenoid or something like that, but check for clean fluid first.

Aug 10, 2012 | 2003 GMC Sonoma Extended Cab

1 Answer

Precat O2 sensor wiring diagram for a 2004 saturn vue 4cyl


I did all that... chasing my tail...

I like to stick to original engine specs ...
"MECHANIC" indeed... ((try artist) con-artist).

Your wiring diagrams & tech bulletins are FREE (registration require (these are real GM documents)) ... at
BBB Industries (below)

My first ... best recommendation would be to have an exhaust shop check the cat & muffler before you DO ANYTHING to your sensors... Put them back-right

Like blaming the thermometer for having a FEVER.

2004 SATURN VUE 2 2L L4 Catalytic Converter RockAuto

BBB Industries Premium Alternators Starters Power Steering Products

Carnac the Magnificent

Mar 11, 2017 | 2004 Saturn VUE

2 Answers

I NEED TO SEE A LARGE DIAGRAM SHOWING THE BELT ROUTING FOR A 1997 PONTIAC BOONEVILLE


Hello mchaffin98,

Below is an image of the belt routing.

netvan_232.png

I hope this helps.

Regards,

Jerry

Sep 11, 2011 | 1997 Pontiac Bonneville

1 Answer

Stiff clutch on 2002 elantra , clutch and transmission new , slave clinder pushes wrong way ,whats wrong ?


FYI, the slave cylinder is pushing correctly, the clutch is the 'PULL TYPE', not the 'PUSH' type.
Go to www.hmaservice.com and register the vehicle by VIN #. You'll then have access to Shop Manuals, Wiring Diagrams, Illustrations, Service Bulletins, etc.

The clutch on the 2002 Elantra, as I mentioned, is the "Pull Type". Instead of 'Pushing' on the throw-out bearing, it "Pulls" on it. The pressure plate engages when the bearing is released (when it is 'pulled' back into the pressure plate 'fingers'

Was the new trans & clutch installed at an authorized Hyundai Service Department? If not, you might want to have them inspect the installation to determine what's wrong. If it WAS installed by a Hyundai Service Dept, take it back to them & tell them to FIX IT!

Jun 30, 2011 | Hyundai Motor 2002 Elantra

2 Answers

NEED TO PUT SARKPLUG WIRES ON NEED FIRING ORDER DIAGRAM


Here's a picture for you. I hope this helps you and good luck.


clifford224_210.jpg

May 06, 2011 | 2000 Chevrolet Malibu

1 Answer

We changed spark plugs & wires on our 1991 GMC & seem to have the order wrong on the distributor cap because truck won't start. need diagram


Here is the firing order diagram for the 5.0 liter (305), 5.7 liter (350) and the 7.4 liter (454) V-8 engines (note position of locking latches/screws between the 3 and 6 and the 1 and 2 terminals on the distributor cap). Let me know if you need the 4.3 liter V-6 engine diagram (hopefully not in a 2500 series truck) or if you require any further assistance.




zaraki_35.jpg

Nov 28, 2010 | 1991 GMC C2500

2 Answers

DISTRIBUTOR FIRING ORDER DIAGRAM & CAN THE ROTOR BOUTTON BE PUT ON WRONG OFF A LITTLE OR WHAT?


fived ty button only goes on 1 way slotted. Problem was distributor wired wrong .used firing sequencs order to solve ty

Nov 06, 2009 | 1998 Dodge Ram 1500 4WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

311 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...