Question about 2008 Subaru Outback
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
two screws on each headlight control the direction the headlights are aimed. One screw, usually at the top but sometimes below the headlight, adjusts the headlight up and down. The other screw, located to one side, controls the headlight from right to left. Turning the appropriate screw one direction or the other will change the direction the headlight points.
In order to aim your headlights you need to have a flat vertical surface you can aim your headlights at in front of a level surface on which to park the car. If your driveway is level your garage door is the perfect place to aim your headlights.
The tools you will need for this job are simple. Masking tape is used to mark where the headlights are to be aimed and a screwdriver is needed to adjust the headlights. A tape measure will be necessary to measure the distance of the vehicle to the surface you're using to check the aim and to measure the up and down distances from your marks
Posted on Nov 11, 2009
Head lamp ajustment is part of safety and must be aligned with specification from the saftey standards.You might want to consider takeing your car in to have them ajusted by a certified garage most are.
Posted on Dec 24, 2009
SOURCE: front windshield washer nozzle
Use a thick needle (or tooth pick), partially insert into the nozzle and gently re-orientate the direction. Test a nozzle spray and repeat steps until desired trajectory is aquired.
Posted on Jan 16, 2010
Hello, to my knowledge there is no way to do this adjustment manually. You must hook up the Subaru scan tool and adjust the sensitivity that way. If the dealer has already calibrated it once they may have just not desensitized it enough or the sensor is faulty and is not accepting the recalibration protocol and is biased to full sensitivity. In this case the sun-load sensor must be replaced. I hope this info helps...(subytech1)...
Posted on Feb 07, 2010
P0420 Usually indicates a bad catalytic converter or a bad oxygen sensor. Since you car is 2008 my money is on the oxygen sensor. Or it could be something as simple as an exhaust leak. The cruise control will keep flashing until you get the CEL fixed
Posted on Nov 07, 2011
Tips for a great answer:
Jan 10, 2016 | 2007 Subaru B9 Tribeca
2006 Subaru Liberty 3.0 Blitzen, 52,000kms. It's unbelievable, both my low beams went out at once and when I checked it was both the globes had gone at once. Never has this happened on any other vehicle before, I've ordered a HID conversion kit over the net, hope that works well.
Oct 03, 2012 | 2006 Subaru Outback
Sep 21, 2017 | 2008 Subaru Outback
Nov 18, 2010 | 2005 Subaru Outback
Jan 20, 2010 | 2009 Subaru Outback
Nov 09, 2009 | 2002 Subaru Outback
Mar 27, 2009 | 2006 Subaru Outback
Sep 25, 2008 | 2007 Subaru Impreza Outback Sport Wagon
Jul 24, 2014 | 2008 Subaru Outback
696 people viewed this question
Usually answered in minutes!