Question about 2004 Jeep Grand Cherokee

Open Question

2004 jeep grand cherokee will not shift into 3 gear

Wont shift into 3, 4 or overdrive

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
hi99ins
  • 123 Answers

SOURCE: overdrive Problem

inside the transmission...i doubt u could repair it yourself....

Posted on Jan 17, 2009

Ad
  • 2 Answers

SOURCE: 94 jeep grand cherokee will not shift into overdrive

My 97 Jeep Grand Cherokee was doing the same thing. I changed the TPS ( Throttle Position Sensor) Now it is great goes into overdrive fine. It is really easy to change.

Posted on Feb 11, 2009

  • 6982 Answers

SOURCE: TRANSMISSION

sounds like either a bad speed sensor or controller. shift points are too high, should be at 2000 or slightly less. if fluid is good and clean and shifts do not flair, check those control units. Not sure about calibrate...could mean out of calibration...Id ask
another tech about that. (i don't know everything!)

Posted on Mar 12, 2009

  • 1 Answer

SOURCE: windows and lock wont operate on a 2004 Jeep Grand Cherokee

I just had the same with mine, pull the rubber boot back on the drivers side front door and look for a severed wire, mine was black...simply spliced the wires back together and problem solved!

Posted on Mar 23, 2009

techbuster
  • 5081 Answers

SOURCE: shift indicator light 1999 Jeep Grand Cherokee

There are two parts to it, a voltage resistor, and the EL panel itself.

You need to remove the console first. There are 2 screws under the front rubber pad, two under the cup holder, two in the bin. Remove those six first, take the storage bin out, then slide the rear cupholder out, remove the two screws under the cup holder, and one in front of it.

There are a total of 6 flat screws, and 3 self tapping screws you have removed.

Put the parking brake on, shift the tranny to N, and the transfer case to the middle position if equipped.

Remove the entire console. Slide the shifter beezel as far up vertically as you can. There are 4 clips you ned to remove to do it.
You will see a blue and black wire running into the back. Follow those wires to the resistor. You will see a transparent EL panel attatched to the resistor by two clips.

Usually, one or both of these clips has come loose, causing the light to work intermittantly. Clip them back on, and turn on the headlights to confirm that the light works correctly now.

Re-install everything in the opposite order.

Posted on Oct 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 jeep grand cherokee is stuck in second gear, the overdrive button is not functioning, and getting the data control center says service 4wd switch


wow no engine size stated, the 5.2L run a special trans... so....
hopeless to help you much.
zj jeep with automatic.
it didnt lie, it told you to service it, so take it to a shop and let the work on this old dog..
stuck , now what does that mean.
the shift lever lever stuck, or its cable failing end to end.? or?
or shifts from 1 to 2 and hangs there.
or down shifts from 3 to 2 and and hangs there
DIY ? question is that it? you never said intentions.....
so we open the 93 ZJ book and what do we see.
ax-15 stick box, seems not.
the aw-4 auto , electronically shifted with TSM (scan it yet?)
and the 46RH auto. used on the 5.2L, has no TCM brain.
its a Hydramatic.
here are the OD words off the 46h page

Overdrive Control Switch
The overdrive control switch is located in the instrument
panel. In the On position, automatic shifts
into fourth gear overdrive will occur. In the Off position,
the switch overrides the powertrain control module
preventing a shift to overdrive fourth gear range.
The switch has an indicator light that illuminates
when overdrive is turned off. The switch also resets
when the ignition key is turned to the OFF position
so that the automatic overdrive feature is restored.
The use of fault codes is employed to help diagnose
the electronic components that operate the overdrive
unit and torque converter clutch.

Jul 16, 2016 | 1993 Jeep Grand Cherokee

1 Answer

Wont shift down or go into overdrive


I think that the modulator valve has failed. It isn't a tough fix. Get a new one and replace it and you should be okay.

Mar 19, 2014 | 1996 Jeep Grand Cherokee

1 Answer

My 2001 jeep grand cherokee wont shift into 4th it only goes to third what would cause the 4th gear to not engage


There are several things that could cause that.
> Replacement transmission not equipped with overdrive
> Overdrive solenoid in replacement transmission defective
> Overdrive control circuits damaged or loose pins or connections.
> Gear shift linkage or cable out of adjustment
> Transmission range sensor malfunction or out of adjustment

Since you have a computer-controlled transmission, it would be better to ask the onboard computer that question....you will probably get a much more definitive answer.

Apr 18, 2012 | 2001 Jeep Grand Cherokee

1 Answer

My 1996 jeep grand cherokee will not shift into overdrive


whats if its staying in a high gear and wont shift down or go into overdrive

Dec 18, 2011 | 1996 Jeep Grand Cherokee

1 Answer

My 1995 Jeep Grand Cherokee transmission slips in overdrive


sounds like a possible shift solenoid. If it's due for a fluid change, do that and add a container of lucas trans conditioner. Likely you have a drain plug on the pan so if the fluid was recently serviced, just drain a quart out and replace with the additive, then top off.
If the condition does not change within a week, likely you will need better diagnosis from a reputable trans shop.

Jun 03, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Odd shifting 99 jeep grand cherokee


A common problem with most overdrive units.Overdrive should only be used above 40 mph. With the mileage odds are that you need to have transmission looked at professionally.It maybe time to consider rebuilding it.I do not see a trans service of being a benefit.

Oct 03, 2009 | 1994 Jeep Grand Cherokee

1 Answer

Automatic transmission wont shift


no this is a warranty problem any rebuild is obligated to the mechanic for at least a year to me make him refix it ya dig

Apr 04, 2009 | 1993 Jeep Grand Cherokee

2 Answers

94 jeep grand cherokee will not shift into overdrive


My 97 Jeep Grand Cherokee was doing the same thing. I changed the TPS ( Throttle Position Sensor) Now it is great goes into overdrive fine. It is really easy to change.

Jan 27, 2009 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

Related Topics:

102 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...