Question about 1991 Ford Bronco

Open Question

How to change a fuel pump in a 1991 ford bronco

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1996 Ford Bronco Fuel Pump Replacement

A 1996 Bronco fuel pump is in the tank. The tank will have to be dropped. After that, it's quick & easy. The filter is on the rail, not so easy even with the line removal tools. Wear safety glasses in case of any pressure.

Posted on Jan 31, 2009

  • 218 Answers

SOURCE: No power to fuel pump

Hi..my name is Keith..and the 2 things that i know of...that will not let power go to the fuel pump is 1..the fuel pump relay being bad..or 2..that something has tripped the Inertia Switch...and it needs resetting..i hope this will help

Posted on Jun 30, 2009

  • 242 Answers

SOURCE: 1987 FORD FULL SIZE BRONCO FUEL PROBLEM, SHUTS DOWN

The only way air can get in the fuel line is if you have a hole in it! Problem of course is were? I would run the fuel line from back to front and back again. Look for any wet spot that you can find. You may even have to drop the tank to ba able to look on top. I would suspect the problem is in the line before the high preasure pump, being as you are pulling air into the system. I have seen leaky lines allow air in, but not let fuel out.

Posted on Sep 12, 2009

  • 1 Answer

SOURCE: Fuse panel diagram for 1990 ford bronco 2

Here's the diagram for the fuse panel under the dash. There is also a fuse panel under the hood next to the air filter.e589aae.jpg

Posted on Jan 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my fuel gauge always register full in my


Open wire or the sender is open, ground the sender wire as close to the pump as possible. If the gauge goes to empty then your sender is at fault. If it remains at full then the wire from the sender to the guage is open.

Sep 29, 2014 | 1991 Ford Bronco

1 Answer

1991 ford bronco fuel pump wont shut off


The fuel pump should turn on for about 3-5 seconds when you turn the ignition switch to on. If the engine starts the pump should still continue to run, if you do not start the vehicle the pump will shut off. It sounds like your fuel pump relay is stuck. Sometimes they will stick on even with the key off. The relay should be located in the relay box, under the hood on the drivers side on the inner fender well. You can try tapping on the relays with a end of a screwdriver, etc. See if that does anything for you. If that doesn;t help I will have to look up some info. Been a while since I had issues with that .

Mar 31, 2014 | 1991 Ford Bronco

1 Answer

Oil pressure keeps dropping? when i turn 1991 ford bronco on the pressure reads fine sometimes than it drops and the engine starts to tap. where is the pump located and how do you chANGE IT OUT?


You'll have to drop the oil pan and you will see your oil pump...Not much to replacing it either the hardest part is dropping the pan good luck and have fun wrenching...

Apr 25, 2010 | 1991 Ford Bronco

2 Answers

1991 Ford Bronco Stalls when put in drive


could be torque convertor valve or sticking valve in transmition, best get mechanic to check it out

Apr 24, 2010 | 1991 Ford Bronco

2 Answers

Bronco would not start changed fuel pump relay ran


have you checked your mafs that sounds like it the problem clean it witha mafs cleaner

Jan 08, 2010 | 1992 Ford Bronco

1 Answer

Fuel Pumps!


Most Ranger/Bronco II vehicles had a dual pump system up until 1991 when the Bronco II was replaced by the Explorer. While you more than likely do have two fuel pumps, the best way to be certain is to look. if you crawl under the truck, right around the driver's door, and look on the inboard side of the frame, there should be to bolts coming through the bottom holding a plate onto the frame. if that is there then you do have two fuel pumps. That is a blocking plate to protect the HP pump from road damage. It will not be there if there is no pump, and it IS important to have if you have the 2 pump system.

Oct 27, 2009 | 1988 Ford Ranger

1 Answer

WHERE IS FUEL PUMP ON 1987 BRONCO 2


The fuel pump on a Bronco is located inside the fuel tank. The level sender unit and pump are usually mounted together but they can be changed individually.
You will probably need a speacial tool to seperate the flexible fuel hoses from the metal fuel pipes.

Oct 15, 2009 | 1987 Ford Bronco II

Not finding what you are looking for?
1991 Ford Bronco Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...