Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The TPS is usually located on the inlet manifold at the rear of the engine.If you look at where the accelerator cable connects to the throttle housing it should be there. It's held on by 2 torx or hex head screws & has a wiring block connector with 3 wires going in to it. This connector should simply pull off when you squeeze the clasp. You didnt say which engine you have but the TPS is similar across the range. You must make sure the ignition is off when unplugging it otherwise you will generate a fault code in the Engine Managment System. Once replaced switch the ignition on for 5 seconds & then switch off. This should position the sensor ready to start the engine.
Posted on Nov 24, 2008
check the belt,if its out it will flag up this code,your car will run on sequential firing from the crankshaft sensor,failing that put an oscilloscope on the signal wire at the sensor and ecu its possible the ecu might not be seeing the signal,start with the basics first
Posted on Dec 29, 2008
SOURCE: crank sensor 2001 kia rio
On 2001-2005 vehicles the crankshaft sensor is mounted on the front of
the transmission case adjacent to the flywheel.
Please rate and god bless:)
Posted on May 13, 2009
Tips for a great answer:
Jun 27, 2011 | Kia Rio Cars & Trucks
Jun 23, 2011 | 2006 Kia Rio
Sep 02, 2010 | 2001 Kia Rio
Jun 07, 2010 | 2003 Kia Rio
Dec 23, 2009 | 2001 Kia Rio
Jan 16, 2009 | 2001 Kia Rio
Sep 26, 2017 | 2001 Kia Rio
94 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: