Question about Cars & Trucks

Open Question

How to adjust an accelerator cable on a 93 crown victoria

It shuts off when idled

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
csmock132
  • 4669 Answers

SOURCE: wher is the starter on my 93 Crown victoria

Rear of engine, passenger side, right above the oil pan.

Posted on Mar 09, 2009

Ad
97crownvic
  • 28 Answers

SOURCE: crown victoria window motor replacement

remove the door panel. be very careful and make sure you get all the screws out. Should be maybe 2 on the bottom half of the door, and 2 on the top half. one is right by the handle, which is the one i forgot the first time i took my door pannel off. carefully pull the panel upward, and outward at the same time. Once the panel is off, disconnect the controls, and remove the light from the panel. Remove the plastic cover very carefully, it will tear, just keeps noise, and air, and the elements out.
There will be 3 screws, they are torx bolts, once you pull those 3 out. They are located middle of the door towards the right side. The motor will drop down a little bit. disconnect the wires for the motor, and wiggle the motor off of the regulator. the crown vics have a decent size hole to get into the door panel, you can also remove the speaker if that would help you do it. other than that, it just lining up the new motor into the car, pushing it into the regulator, and putting the 3 bolts in, make sure they are snug, and not cross threaded. put everything back together, and your set.

Posted on Mar 19, 2009

CLEONTI
  • 33 Answers

SOURCE: need wiring diagram for 2008 ford crown victoria

Hello,

You can purchase the wiring diagram for $5.99 from the following site: http://www.wiring-diagram.com/. You can also purchase a wiring diagram book from the following link: http://cgi.ebay.com/ebaymotors/2008-FORD-CROWN-VICTORIA-MARQUIS-WIRING-DIAGRAM-MANUAL_W0QQitemZ120394723100QQcmdZViewItemQQimsxZ20090320?IMSfp=TL090320147007r15080.

Hope this helps,

Chris

Posted on Mar 23, 2009

  • 93 Answers

SOURCE: 2000 crown victoria serpentine belt installation

Accessory Drive Component Locationsa0011762.gif

Posted on Jun 09, 2009

morse008
  • 1111 Answers

SOURCE: HEADLIGHT FLICKER THEN SHUT OFF

check to ensure the connection is secure at the light socket itself even jiggle the connection to ensure this dirt etc may cause a faulty connection ...also is this just one or both headlights

Posted on Sep 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98crown victoria loss og power and stalling


Most Reported Problem Reports for the Ford Crown Victoria

repairpal.com > Problems > Ford
Verified for the Ford Crown Victoria. 4 reports. Engine Stalling and/or Hesitation on Acceleration due to Faulty Idle Air Bypass Valve. Verified for the Ford Crown ..

Aug 04, 2015 | Cars & Trucks

2 Answers

PLEASE HELP!!!! 93 ford crown victoria wont accelerate in gear after a while driving in hot weather


The problem is with your transmission It's getting hot and not engaging Check the tranny cooler as well

Apr 08, 2014 | Cars & Trucks

1 Answer

Diagnois overheating on 2003 Ford Crown Victoria police interceptor


Does the cooling fan come on at 225F? Have the fan tested by the dealer with a scanner.

Jul 02, 2012 | 2003 Ford Crown Victoria

2 Answers

I have a 93 crown victoria and it runs great but more often when I put it into park it doesnt want to start again. I have to reput it in park 3 or 4 times.


Bad PRNDL switch(park/reverse/neutral/drive/low).May be adjustable,but most likely the switch is bad.As a temporary/free solution,try starting in Neutral(USE YOUR PARKING BRAKE!)

Mar 14, 2012 | 1993 Ford Crown Victoria

1 Answer

2000crown victoria willnot idle but will stayrunning whileapplying pressure to the gas.


The problem is a clogged fuel filter. You stated that it will not idle unless you maintain pressure on accelerator. Replace the fuel filter and it should clear up.

Dec 10, 2010 | 2000 Ford Crown Victoria

1 Answer

My 1997 crown victoria's idle is too low and it needs to be adjusted. i was wondering how to do that.


there is no adjustment, the IAC (idle Air Control) is a common failure, so replace it.

Dec 06, 2010 | 1997 Ford Crown Victoria

2 Answers

I just purchased a 93 Crown Victoria with the 4.6 litre V8. It idles ok but bucks under any acceleration...misses badly. To the point where I went over an overpass and begin losing speed. All the spark...


your problem is not wire location, it sounds like bad wire or wires, also those engine are pron to bad coils,but i think you should start with wires,also check fuel filter or just replace if you can check fuel preasure.hope this helps.

Oct 10, 2009 | 1993 Ford Crown Victoria

1 Answer

1988 Ford Crown Vic Strange Idle (Getting Worse)


i am trying to install an aftermarket temperature guage with capillary tube into my 1988 crown victoria ltd 5.0 efi. where does the capillary tube mount?

Jun 27, 2009 | 1988 Ford Crown Victoria

2 Answers

2000 Ford Crown Victoria


when you hold the accelerator does the vehicle stay running? if so the problem is in ithe IAC idle air control motor, take a small screw driver and using the handle tap the iac motor and usualy the motor will kick in and the vehicle will run fine then if the problem is rectified replace the IAC

Nov 24, 2008 | 2000 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...