Question about 2007 BMW 750Li Sedan

Open Question

Transmission fault 2007 bmw 750li

Fault light on steady

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
steve_e_uk
  • 1675 Answers

SOURCE: my 2006 bmw 750li is showing transmission fault

hi, this could be your battery loosing voltage, check it with a volt meter to see if it reads between 12v - 12.5 v if it is low it might need replacing, you could also check your alternator to see if it is charging correctly you will find your car will be stuck in either 3rd or 4th gear ( limp home mode ) hope this helps please vote thanks

Posted on Mar 21, 2010

Ad
  • 291 Answers

SOURCE: my cigarette lighter is out.

most solid rule of thumb is to get a test light from auto part store and check all fuses in the box.. sometimes a fuse can blow in a circuit label something else than what you are looking for.. can't miss with checking all

Posted on Nov 13, 2010

  • 437 Answers

SOURCE: 2006 750Li Transmission Fault -

The electronic control modules that control BMW transmissions have historically been very sensitive to the quality of the electrical supply. The first step in diagnosing erratic transmission behavior is always to first make sure that the battery is in good shape, the connections and ground are clean, and the alternator is putting out a strong clean DC charge.
Once that possible problem is eliminated, if the problem persists, you will need some high quality transmission expertise.

Posted on Jan 23, 2011

  • 2 Answers

SOURCE: passkey of the bluetooth

I HAD THIS SAME ISSUE. I TOOK OUT THE REAR PANELS INSIDE THE TRUNK. FIRST, START WITH THE LOWER CENTER PANEL RIGHT WHERE THE LOCKING LATCH IS LOCATED. THEN, MOVE TO THE LEFT PANELS ON THE SIDES OF THE INSIDE OF THE TRUNK. ONCE YOU HAVE TAKEN OUT THE PANELS, THERE'S A SILVER BOX IN THE TRUNK WITH A "PK 0000" NUMBER PRINTED ON A STICKER. THAT "PK" NUMBER IS YOUR CODE.
IT'S NOT AS BAD AS YOU MIGHT THINK TO TAKE OUT THE PANELS, I DID IT IN ABOUT 15 MINUTES. JUST TAKE YOUR TIME AND THEY ALL GO BACK IN AS EASY AS THEY CAME OUT. JUST TRY NOT TO FORCE ANYTHING BACK IN IT'S PLACE.
HOPE THIS HELPS. LEONARD-

Posted on Apr 26, 2009

Fixitman909
  • 430 Answers

SOURCE: my 2006 bmw 750li is showing transmission fault

Try changing Trans oil and filter..if this dont help...Tranny time GL

Posted on Jun 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 BMW 750 Li My dynamic drive inactive light came on, then a generator fault light came on


BMW has been using electronically controlled automatic transmissions in most models since the late 80s. These transmission systems employ a transmission control unit which controls electrical solenoids to manipulate the various control and shift valves and functions in the transmission valve body. When the transmission control unit detects a problem that it thinks could be damaging to the transmission or engine, it goes into a fail-safe or limp mode. In this mode, the transmission will function in reverse normally, but in forward it will operate in only one gear (whether you have the shifter in D, or any of the lower gears). This will typically be 3rd or 4th gear, depending on the model. It will start in this gear and stay in this gear with no shifting. You would experience this as sluggish acceleration and higher than normal engine speed at about 40 mph and above.

If you must drive the vehicle when the transmission is in the fail safe mode, accelerate gently and keep the road speed lower than full highway speed.

Earlier models do not employ fault codes and must be diagnosed manually. Late models do employ fault codes and a diagnostic/scan machine can be used to check and read the faults to assist in diagnostics. Note that this is not your common OBDII engine management fault code tool. This is what A BMW dealer or a properly equipped independent shop would have for full vehicle system diagnostics and coding operations.

Feb 13, 2015 | 2006 BMW 750Li

1 Answer

What does the Drive Control System malfuction/yellow light mean?


Unfortunately that error is about as specific as the "check engine" light. The error is generic and only indicates that a fault was registered in the drive train electronics. It could be something very serious and you should get it checked out by a BMW mechanic asap. To narrow down the problem you need to check the computer fault code memory.

Mar 25, 2013 | 2007 BMW 750Li Sedan

2 Answers

Dynamic traction control malfunction 750li


You should have the control module checked by a tech as either their is too much slippage or it is interfering with the anti-lock system.

Aug 30, 2012 | 2006 BMW 750Li

1 Answer

How to change brake fluid in a 2007 bmw 750li


you would need to draw the fluid from the reservoir the fill it with fresh fluid then bleed the brakes until fresh fluid comes threw

Aug 18, 2012 | 2007 BMW 750 Li

1 Answer

What are the recals on 2006 750li


Hi, I purchased a 2006, BMW 750li 7 months ago..this car has 71,000 miles and I hardly drove it since buying it.However, I noticed that fluids was leaking and to my a long story short, I took it the the BMW dealership-they changed the oil pan, but the reason for going was because it started showing transmission fault, and when I put the gear in drive it jumps back to park-on top of a very hard jerk when I put into drive to drive off. I ask the dealer to re set the fault control, but the car is doing the same thing..anyone has a solution to this problem? The said I need a transmission, and it will cost $7,700.00

May 29, 2012 | 2006 BMW 7 Series

1 Answer

My cigarette lighter is out. where is the fuse. I know where the box is but which fuse is the lighter on a 2007 bmw 750li.. what is the symbol


most solid rule of thumb is to get a test light from auto part store and check all fuses in the box.. sometimes a fuse can blow in a circuit label something else than what you are looking for.. can't miss with checking all

Nov 13, 2010 | 2007 BMW 750Li Sedan

2 Answers

My 2006 bmw 750li is showing transmission fault


hi, this could be your battery loosing voltage, check it with a volt meter to see if it reads between 12v - 12.5 v if it is low it might need replacing, you could also check your alternator to see if it is charging correctly you will find your car will be stuck in either 3rd or 4th gear ( limp home mode ) hope this helps please vote thanks

Mar 20, 2010 | 2006 BMW 7 Series

1 Answer

97 bmw 740i can not reverse while its shiftning on drive perfectlu. what could be the problem? mileage is over 200,000.


Sounds like the reverse gear is gone out in your tranny. Try a reputable transmission shop.

Jul 10, 2009 | 2007 BMW 750Li Sedan

2 Answers

1990 BMW 750il Auto Transmission Switch Problem


have your bmw dealers check switch it might need to be replace.

May 08, 2009 | 2007 BMW 750Li Sedan

Not finding what you are looking for?
2007 BMW 750Li Sedan Logo

Related Topics:

261 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...