Question about Cars & Trucks

1 Answer



Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Cars & Trucks Expert
  • 325 Answers

Unfortunatly engine`s get addicted to easy start, the only way l have cured this problem is to completly strip out top end de-glaze cylinder bores, re-cut valve seats re-build with new head gasket set and never, ever use the stuff again!!!!!!!!!!!!! maybe of some use....

Posted on Dec 31, 2012


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: wont start without starting fluid

Could it be a plug up injector , have sewiing needle , stick it in the sprayer part of the injector on the carberator part

Posted on Sep 16, 2008

  • 1 Answer

SOURCE: Having problem with a 420

       I had this problem. It turned out to be the "fuel pump relay control unit". It is situated with two other box shaped units and is the largest of the three near, or behind the battery.        I opened the unit up and on "very" close inspection found a bad contact on the enclosed circuit board, I gave the connection a clean and added the maximum amount of solder (weld) to dissipate the heat.        It was great to hear the pumps running possitively again and of coarse the problem was solved.

Posted on Nov 26, 2008

  • 7 Answers

SOURCE: my 1999 gmc jimmy will not start unless i use starting fluid

u may want 2 check with a dealer gmc dealer but u may have 2 fuel filters on your jimmy poss. an in-line filter runs down the pass. side or driver side not all cars are the same

Posted on Apr 25, 2009

  • 49 Answers

SOURCE: wont start unless primed with starting fluid

Sounds like no gas reaching the motor. Could be fuel filter or fuel pump. I would recommed you disconnect the fuel line and start car to see if fuel is coming up if it is then ur injectors r clogged or no good if nothing comes up u know is pump or filter I would change both.

Posted on Jun 06, 2009

  • 12 Answers

SOURCE: 95 camaro wont start.

did you check for spark? are you getting a rpm signal from your crank and/or cam sensor?is it a six or eight cyl?

Posted on Jul 29, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

04 Buick rendevous. Hit curb and now won't start. Fuel pump kicks on and it's getting spark but will not start. Any ideas?

Is there B+ voltage to the fuel injectors ? Blown fuse's ? Security light lit on the instrument cluster ? If the vehicle will run with you sparying starter fluid in the intake , low or no fuel pressure or injectors not spraying fuel into the engine. Hooking up a fuel pressure test gauge an checking pressure an flow would be the thing to do , not guessing ,because you hear the fuel pump turn on . That does not mean it's making fuel pressure . Your best bet , take it to a qualified repair shop .

Nov 12, 2017 | Buick Cars & Trucks

1 Answer

My toyota corolla does not start normally unless i spray fuel inside the caburator please help to solve this problem.

is it a carboretor or is it fuel injection if a carboretor probably a sticking flote easy to do just remove it and clean if its fuel injection get the fuel pump checked or injectors

Sep 26, 2012 | 1990 Toyota Corolla

1 Answer

Dakota wont start

your pickup coil could be the problem. not geting enough spark or sparking all the time

Apr 09, 2010 | 1996 Dodge Dakota

1 Answer

It will turn over but wont start

check the fuel pump! Use some starter spary in the intake if it starts then you have a fuel delivery problem.

Sep 26, 2009 | 1992 Chevrolet Corvette

1 Answer

505 wont start fuel not being injected

your injectors may need replacing

Jul 23, 2009 | 1987 Peugeot 505

1 Answer


is it fuel injected? you might have a faulty sensor it sounds like a vapor lock, also you fuel injectors might be dirty or bad also check fuel pump pressure or a cloged fuel filter, or it is putting to much gas if your vette has a carb.

May 31, 2009 | 1990 Chevrolet Corvette

1 Answer

Wont start without starting fluid

Could it be a plug up injector , have sewiing needle , stick it in the sprayer part of the injector on the carberator part

Aug 22, 2008 | 1990 Ford F150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15360 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides