Question about 2004 Rover 25 1.4

Open Question

Location of common earth connector on a Rover 25

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Which fuse forbreak light on Rover 25 2006 please. Both side break lights not working. Bar light is.


Check for bad connection at trailer hitch tap connector located on frame close to back bumper. Check owners manual for fuse location

May 19, 2017 | Rover Cars & Trucks

1 Answer

Why is ther no power at obd connection


Degrading of the wiring going to the OBD Connector ! Check the OBD by removing and cleaning contacts and also the earthing behind the passenger side footwell kick panel

Jun 05, 2014 | 2000 Land Rover Range Rover

1 Answer

Rover 25 indicator not working


Poor earth.
Try adding a better connection

May 04, 2014 | 2004 Rover 25 2.0

1 Answer

Rover 25 common faults


Just change the clutch set with a new one.

Apr 07, 2014 | 2005 Rover 25

1 Answer

Series III Earth problem


Can\'t see any specifics here, but in general:
Pour a little boiling water over the battery terminals to clear the stuff, then remove the connectors and wire brush to bright metal. Clean the connectors similarly and refit, smearing with petroleum jelly to protect. Follow the negative lead to the engine, and disconnect here and clean in a similar fashion.

If you mean a component earth problem, easiest way is to make a temporary earth wire for the component which connects directly to the battery negative terminal. If the problem is resolved, clean up the component\'s earth path or simply install a permanent bypass earth.

Oct 21, 2013 | Land Rover Cars & Trucks

1 Answer

Where is the boot light earthed


riught up behind the panneling its easire to renew the earth and leave the existing earth wire connected as well so anything else using the same earth will work as well through the new earth.

Jan 14, 2013 | 2004 Rover 25 1.4

2 Answers

Where is the crank sensor located in a 2001 land rover discovery


On the lower driver side of engine facing the transmission,it is very common for the CKP connector to come loose,check that also

Mar 02, 2012 | 2001 Land Rover Discovery Series II

1 Answer

How do I fix the heater switch on a rover 25 1.4i Y reg


** First check the Fuse 19, 20A, in passenger fuse box (see manual- under steering wheel). then earthing connection E5 (Front LH inner wing.
**electricat connections are most accessable at Motor resistor bank, behind glove box (released by 8mm 2 bolts underneath ) Resistor pack in front of blower motor, 2x 6mm bolts. flick or squeese electrical relaese tab**



** Check the state of the motor speed resistor pack/ prone to resistor/resistor wire failure , which is behind the glove box,

The motor circuit is Green, live feed , to motor, slate black to motor speed selector (resistor pack), Output (slate or Yellow or Green or pink And Black) then Heater selector switch to earth (black).
- The feed from the motor is Slate/ Black wire. It pass through (or bypasses) resistor bank which limits the current through) the motor thus controlling. the speed. This has 4 connection slate grey from motor.

**Check 12v feed on blower Motor connector Green +ve , Slate Black to Earth. if ok, short Slate/black(Sl/Blk) to earth motor should run.

-Slate/B black (S/B) via No restor to switch, pos 4,

-Yellow/ Black (Y/B) via High resistor to Switch Pos 3
--Green/ Black (G/B) via Medium resistor to Switch Pos 2.
--Pink/ Black (K/B) via Xresistor to Switch Pos x.


From heater selector all final connection to earth are via to Black wire to earth on ineer LH inner wing.

Jan 17, 2012 | 2004 Rover 25 1.4

1 Answer

Over heat


There is a bad earth on the instrument cluster wiring.Unplug the main electrical connector on the back of the cluster and test all black wires for resistance to earth.The earth wire to this plug goes to an earth header behind the facia panel next to the accelerator pedal (right hand drive )or the clutch pedal (left hand drive).The resistance should be minimal.

Aug 16, 2008 | 1997 Land Rover Discovery

Not finding what you are looking for?
2004 Rover 25 1.4 Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Rover Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Rob
Rob

Level 2 Expert

64 Answers

Are you a Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...