Question about 2004 Toyota Sienna

Open Question

How do I adjust the headlights for a 2004 Toyota Sienna

The left HL is very high and when I turn on High Beams... They both change so much I can't tell where that are really pointing. If I can just adjust the Left Side to its correct position then maybe I'll be able to get a better look at the Hight Beam problem. Thx for direct instructions to adjusting the Left HL.

Posted by on

  • Jeff White Dec 31, 2012

    Ok... fixed it. Found the seraded adjustment bolts on the light case... Was a little difficult because there was only 1 1/2" of space from the bolt to the Fuse box located directly behind the light case. Had to use needle nosed plyers and it took about 10 mins to bring the light back down to the proper level.

  • Jeff White Dec 31, 2012

    Ok... fixed it. Found the seraded adjustment bolts on the light case... Was a little difficult because there was only 1 1/2" of space from the bolt to the Fuse box located directly behind the light case. Had to use needle nosed pliers and it took about 10 mins to bring the light back down to the proper level.



2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 93 Answers

SOURCE: My 2004 toyota solara the

It sounds like a bad bulb

Posted on Jul 29, 2011


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Headlights do not work high or low beam all other lights work

Re: Condensation in Sienna Right Headlight.... - Toyota Sienna Forum
Mar 10, 2009 - 15 posts - ‎9 authors Over the years, I was not a frequent visitor to SiennaClub...but when I did visit, it was... in the right, passenger-side xenon HID headlight of my 2004 Sienna...the light has... Check with your dealer and see if they can do anything about it. .... :o The HID bulb is also a PITA to remove because you are working ... Re: 2004 Sienna no brake lights, radio, heater/AC ...
15 posts
Jan 4, 2013
Thread: HELP: Both Low Beams don't Work
6 posts
Nov 27, 2011
Thread: 2000 sienna drl and/or headlight issue
5 posts
May 7, 2010
Automatic Headlight Option: Useful or Not?
8 posts
Mar 3, 2010
More results from

Toyota 2004 Sienna repair: Replacing HID ballast or ...
May 1, 2010 - Replacing HID ballast or computer control lighting for the Headlight. Just got a ... Up until now, I did not know I had the option of seeing twice as far with Xenon. Also up to ... In the end after buttoning everything up, the light did work fine. .... Howdo you determine if you have a HID or non-HID light? Reply ...

Oct 15, 2015 | 2004 Toyota Sienna

1 Answer

How do i adjust my headlights in my 2004 vovlo xc70

If you look just behind the headlight glass from the top, you will see two holes with 7mm hex head screws. These will adjust your headlights up, down, left and right.

Sep 23, 2014 | 2004 Volvo XC70

1 Answer

Toyota Sienna 2004 Headlight Problem

If you have the HID bulbs, and there is moisture in the bottom of the assembly, the high voltage box at the bottom will not work. this requires removing the whole headlamp, removing the circuit board from the bottom and drying out. I have done mine twice before finally finding how water was getting in at the top seam of the lamp assembly. You will have to dis-assemble part of the wheel well and bumper cover to gain access to all the mounting bolts. Best of luck

May 02, 2010 | 2004 Toyota Sienna

1 Answer

93 Camry Headlight Switch

From the symptoms you describe it sounds as though your headlamp switch is dirty, broken or out of adjustment. I would disassemble it and find out what is going on.

Oct 23, 2009 | 1993 Toyota Camry V6

1 Answer

Headlights wont turn on but high beams do on my camry

Have you tried new bulbs, its rare but both low beams may have blown at the same time, it has happened to me in the past.
I don't know your car but the high and low beams could be fused separately so you are left with at least one set in an emergency.

Jul 02, 2009 | Toyota Corolla Cars & Trucks

1 Answer

Adjusting Headlamps

I have an 87 MR2 and this is how to adjust mine. Headlights have two spring loaded adjusting screws, one on the top controlling up and down movement and one on the side controlling left and right movement. The simplest method requires a blank wall 25 feet in front of the vehicle and a level floor. Position masking tape vertically on the wall in reference to the vehicle centerline and the centerlines of both headlights. NOTE: It may be easier to position the tape on the wall with the vehicle parked only a few inches away. Adjustment should be made with the vehicle sitting level. Starting with the low beam adjustment, position the high intensity zone so it is 2 inches below the horizontal line and 2 inches to the right of the headlight vertical line. Adjustment is made by turning the top adjusting screw clockwise to raise the beam and counterclockwise to lower the beam. The adjusting screw on the side should be used in the same manner to move the bean left or right. With the high beams on, the high intensity zone should be vertically centered with the exact center just below the horizontal line. NOTE: It may not be possible to position the headlight aim exactly for both high and low beams. If a compromise must be used, keep in mind that the low beams are the most used and have the greatest effect on driver safety. I typed this out of my "Haynes Manual 1985-1987 Toyota MR2 Book. I would think it would be the same method for a 1989 also. Hope this helps you. Redheadedwop

Sep 10, 2008 | 1987 Toyota MR2

Not finding what you are looking for?
2004 Toyota Sienna Logo

Related Topics:

342 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides