Question about Cars & Trucks

Open Question

How do i remove lower rear seat 2008 ford f-150 crew cab?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

osoteddy
  • 1 Answer

SOURCE: How to replace map & dome light bulbs on a 2008 Ford F-150 Super

2008 Ford F-150 SuperCrew Cab (without moon roof or rails): How to replace the map light bulbs.  First, you'll need a "trim pad remover."  It is a tool with a screwdriver handle and the metal part has a 'smooth' forked tongue (see Snap-on Stock#: A177A for picture).  Go to the center counsel and "gingerly" work around he counsel and pull down at the same time.  The counsil is held in by six snap in tongs.  It should remove pretty easily.  once down, you'll see where the bulbs are.  Unscrew and replace.  Now, just line up the tongs and gently bump or hit the pressure points (where the tongs are) and it should snap into place.  It should take no more than five minutes, tops.

Posted on Nov 17, 2008

  • 5 Answers

SOURCE: Looking for keyless door code

Are you referring to the wireless remote or do you have the keypad access? Ford usually puts the keypad code on a decal inside the glove box. I believe it may be located in another area but can't remember off hand. The owners manual should tell you where to find it.

Posted on Jan 10, 2009

  • 1 Answer

SOURCE: Ford 2004 F150, Lariat, crew cab I have a

I had the same problem with my truck,ieven took it to a window repair shop while driving home it started to rain lord a behold,I looked on the back sit and it was wet.After all that i found out that the water was comming in from the break lite on top of the roof.all you have to do is take the cover off and replace the seal around the cover because it is worn out or get some sealeant and place it around the inside cover.

Posted on Feb 28, 2010

sscullys
  • 984 Answers

SOURCE: does my rear seat fold down in my 2006 ford f-150

Seat bottoms fold up.

You can remove the rear seat back, if that is what you are looking for. Just post a comment back.

Posted on Jul 01, 2010

sscullys
  • 984 Answers

SOURCE: The electric rear sliding window

If the power windows still work, it is not a fuse issue, they share the same fuse ( F401 form the accessory delay relay )

Either the switch or the motor is the cause.

When you press the button to the close direction ( with the window closed ) do the lights dim ( headlamp / interior lamps ) ?
If they do, the window is getting power in that direction, so it could be the switch for the open direction or the motor, or something in the track.

If you pull down the overhead console ( the non rail one is open the sun glass compartment, and pull down on each rear corner, it is held up with spring clips ) the wires to the slider are Red w/ yellow stripe and yellow w/ light blue stripe.
If you apply power to these wires, one direction is open, the reverse is close. Test direct to the wires to know if the slider motor is the issue or the switch.
sscullys_86.jpg

Check the entire track for obstructions

To get the slider motor, you need to remove the rear seat back
sscullys_87.jpg
sscullys_88.jpg
sscullys_89.jpg

Posted on Jan 25, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2008 Dodge Ram 1500 Crew Cab, manual seats. The drivers side seat won't recline. The side of seat with the lever unlatches, but the opposite side does not. Does anyone know how to fix this?


Lubrication. You will need to remove the seat from the cab, and lubricate all pivots associated with the recliner mechanism. These mechanisms are made of very cheap metal alloys, and are subject to jamming and rust.

Apr 25, 2015 | 2008 Dodge Ram 1500

1 Answer

How to remove rear seat of 2010 Ford F-150 supercab


I have found a link on a forum about this topic. I strongly recommend that you join the forum: http://www.f150forum.com/f38/2010-super-cab-rear-seat-removal-37019/ hope this helps! Please rate 4 thumbs up!

Apr 18, 2011 | Ford F-150 Cars & Trucks

2 Answers

Where is the horn fuse for the ford f 150 2002


The horn fuse for this 2002 ford f150 is located in the engine compartment fuse/relay box , heres a diagram of that box , i circled the fuse for the horn, it is in location f1.7. hope this is helpful. also you may want to check the horn relay thats also located in the same box and i circled that also. have a good day.johnjohn2_72.gif

Feb 27, 2011 | 2002 Ford F150 Regular Cab

1 Answer

Haw to gat out seat back


Rear Seat Backrest-SuperCab Removal
  1. Fold down both rear seat cushions.
  1. Remove the rear seat back.
    1. Push the wire hooks rearward to disengage the seat backrest from the back panel of the cab.
    1. Lift the rear seat back upward and remove.
    a0015238.gif
Installation
  1. Align the upper hooks with the upper brackets on the back panel of the cab.
  1. NOTE: Make sure the safety belt webbing is not twisted.
    Route the rear center safety belt through the retainer ******** the rear seat back.
  1. Place the lower hooks behind the lower brackets on the back panel of the cab.
  1. Lower the seat back until the lower hooks engage the lower brackets.
  1. Verify all three upper hooks have engaged the upper brackets

Feb 12, 2011 | 2005 Ford F-150

1 Answer

Does the rear seatback fold down in a Ford F-150 extended cab?


The 04-08 MY changed to a bottom of the seat folds up, where the 03 and older where the seat back folded down.

Do you need to remove the seat back ?

Oct 03, 2010 | 2006 Ford F-150

1 Answer

How to take out rear seats in a 2000 ford f250 lariat


crew cab,use a 50 torx in front bolts ,15mm on a ratchet on back bolts slide seat belt buckles throu seat crack ,fold rear of seat down ,lay seat with hinge toward floor slide out door (note watch brackets ,will scratch door pannals)

Aug 07, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

Does my rear seat fold down in my 2006 ford f-150 ext. cab


Seat bottoms fold up.

You can remove the rear seat back, if that is what you are looking for. Just post a comment back.

Jul 01, 2010 | 2006 Ford F-150

1 Answer

Door locks on doesnt not have any power and want work , how can i fix that? Its on a ford f-150 model 2005.


This is not real clear to me, sounds like the locks don't work when pressing the lock side of the button ( as in the unlock works ). If so, the lock actuator is most likely the cause.

If this is the PDL do not have power to them, did you check fuses 6, 40, 18 & 107 ?
The PDL are controlled by the VSM ( Vehicle Security Module ) which these fuses are associated with it. If you have a door keypad, does it still illuminate when you press a button ?

If installed, and it does not, could be the connector to the VSM or the ground to it. The VSM is mounted on the rear cab wall, behind the seat back in the Super Cab and Super Crew cab configurations. There is a thread in here on removing the rear seat, to get to it.

Usually the problems seen with the connector are for the auto lamps, so I would suspect the ground wire ( seen this 2 times, not real common ).

Apr 20, 2010 | 2005 Ford F-150

1 Answer

Westin nerf bars


Send them back and get the extended cab bars. if you have doors behind the passenger and driver seat it is the extended cab. If you don't want to do that, if you know a welder, they can weld them on for you.

May 23, 2009 | 2008 Ford F-150

1 Answer

How to replace map & dome light bulbs on a 2008 Ford F-150 Super


2008 Ford F-150 SuperCrew Cab (without moon roof or rails): How to replace the map light bulbs.  First, you'll need a "trim pad remover."  It is a tool with a screwdriver handle and the metal part has a 'smooth' forked tongue (see Snap-on Stock#: A177A for picture).  Go to the center counsel and "gingerly" work around he counsel and pull down at the same time.  The counsil is held in by six snap in tongs.  It should remove pretty easily.  once down, you'll see where the bulbs are.  Unscrew and replace.  Now, just line up the tongs and gently bump or hit the pressure points (where the tongs are) and it should snap into place.  It should take no more than five minutes, tops.

Nov 16, 2008 | 2004 Ford F150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...