Question about 2002 Volkswagen Eurovan

1 Answer

Turn signals and foglight problem

The signals and hazards light up but do not blink. Can manually make the signals blink on the tree. Bulbs and fuses have been replaced too. Front and rear fogs do not work.

Posted by on

  • Anonymous Mar 20, 2014

    i got some fog lights put in and now my turn signals want come on or blink

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 566 Answers

Hiya from uk the rear fogs and front fogs will only work when head lights are on also this is the correct operation re if weather conditions warrant use of fog s then you should req head lights ? if you understand ? as for indicators/hazards this problem is more than likely the relay switch is at fault ? this relay on most modern cars is the hazard lights switch which is a combined indicators and hazard lights relay unit try a replacement or price a new unit hope this helps ?

Posted on Jan 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My left turn signal recently stopped working. Before ceasing to work, the turn signal (just the left) would blink very rapidly (machine gun speed).


sounds like one of light bulbs was malfunctioning and caused the flasher unit to blink rapidly and iy burned out. Replace front and rear turn lite bulbs and see if flasher flashes. if not check fuse and replace fuse. If fuse okay replace flasher unit. Good luck

Jul 08, 2016 | 1997 Plymouth Voyager

1 Answer

Turn signals, brake lights, reverse lights all blinking when turn signal is activated


The right tail light assembly is not grounding the chassis. Pull the access panel off and look for the ground points from the wiring harness and the assembly. Undo the nuts a bit and tighten them again. That should restore the ground and clear the problem.

Feb 22, 2015 | Subaru Forester Cars & Trucks

4 Answers

Turn signal lights don't work


The first place to start are fuses, check your owners manual for location, typically left side of dash.

The emergency (hazard) flashers and turn signals are on separate fuses and run through the hazard switch. If all the lights work when the hazard switch is on then the problem will likely be a blown turn signal fuse.

Other possibilities are the hazard switch itself is bad, the turn signal switch is bad or a broken wire, all of which require a meter (or test light) wiring diagram and knowledge of the circuit to test it - better to have it done.

Robert Grove
Mobile Mechanic Malibu 310 651 8020 Auto Truck RV Mobile Repair...

Aug 09, 2014 | 2002 Chevrolet Impala

1 Answer

Turn signal hazard lights work but not running lights


The parking lights should be on a different circuit from turn signals - hazard lights. The bulbs usually have two filaments, one for each circuit.
On most models there is a tail light fuse and relay that handles front and rear parking lights.

Jun 28, 2013 | Toyota Tacoma Cars & Trucks

2 Answers

2002 silverado blinker issue


you can go to the car service center , buy a new one for your car ,remember the year and the model of your car for compare .

May 23, 2013 | 2002 Chevrolet Silverado 1500

1 Answer

I have no signals and when brakes lights are on, lose brake light to either side turn signal is set on


Hi!!

If you activate the turn signal switch and you step on the brake pedal, the turn switch (on the steering column) deactivates the brake light to make the signal light more visible. The bulb for the stop and turn lights is the same.

Turn hazard lights ON. If they don't blink, replace turn/hazard flasher, If one or more lights don't come on, replace bulb.

Check fuse and circuit wiring for broken or loose connections. If all looks fine, check following:

If front turn lights work fine, check brake/turn bulbs.

If turn lights come on but don't blink, replace turn signal/hazard flasher.

If front and back turn lights don't come on, replace switch on column.

Let me know how it worked out, Good Luck

Mar 24, 2010 | 1991 Plymouth Acclaim

1 Answer

Turn signals won't blink


relay is bad turn signal relay

Jul 31, 2009 | 1998 Dodge Durango

2 Answers

95 lumina turn signals


make sure you replaced the correct directional light relay, and not the hazard relay. Check all fuses. check grounds at rear lights. If all of the following are good, your lumina would have a faulty multifunction switch.

Jul 22, 2009 | 1993 Chevrolet Lumina

1 Answer

Signals don't signal


check fuse number 17 in fuse block if ok check bulbs <you said they turn on just don't flash so thats ok> the relay feeds power to the switch cluster but the flasher unit itself is built into the combo switch for turn signal/hazard switch

Mar 24, 2009 | 1994 Volkswagen Golf

1 Answer

98 Hyundai Elantra turn signal and hazards only work sometimes.


You need to replace the fuse - have a look at the manual and see which fuse it is buy a new one put it in and it should be fine - the on off thing is where the fuse wire touches and then moves again.

Dec 29, 2008 | Hyundai Motor 1993 Excel

Not finding what you are looking for?
Cars & Trucks Logo

389 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60792 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...