Try checking the switch that controls the up and down, I just had the opposite problem with my 2003 venture the window would not roll down, the garage put in a new switch for the part was about 75 dollars. it took about an hour to fix.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
CarGurusOct 9, 2012 - Power Windows not working - I have a 2006 Honda Accord and thepassenger and back power windows quit working all at once. ... My key less entry doesn't work either after I replaced the master Window control unit. 6 out of ...
was regulator bad? did it work from drivers side switch before you did regulator repair?..if so passenger side switch wiring has issue and is not sending signal through it back to the drivers side master switches.. otherwise you need to pin test for power up power down on drivers side switch and repair that if issue going to the window on passenger side.. (possible pinched at door jam area common)
Try switching the power window switch from the passenger side to the drivers side. Before you do that try with the switch on the up position, wiggle it from side to side. The contacts may be worn and by wiggling it may make contact. Other then that try to park it in side or garbage bag taped to keep rain out till you get it to the shop.
Hint, take it to a Auto window repair shop to replace the switch if it's bad or if the motor is bad. They have more experience to removing the door panels and removing the power window regulator (motor) if that needs to be replaced.
Good luck and hope this helps.
The problem may be in the wiring which if you pull up the carpet on the front passenger side by
removing the door floor trim and lifting the carpet you will see the
wiring underneath. Probably laying in water or has been. Look for splices in the
wiring which will have corroded. Repair the wiring then check the fuse. Another problem may be in the motor found inside the door.
The brushes may have worn out. If so you need to replace the motor.
Ususally the drivers side will fail first since it is the most used.