Question about Hyundai Accent

Open Question

Need wiring diagram for Hyundai Accent 2005 - Accent Hyundai Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 31 Answers

SOURCE: 2005 Hyundai accent overheating, radiator

A car can overheat for a lot of reasons.First make sure this is the problem by checking the radiator hose or water level. Open the radiator cap when the car is cold, crank it, and then watch the water level. If it drops when the car warms up this is not the problem.
The tools you will need will depend on what you have to take off to get to it. If you can access the thermostat you should only need a ratchet or wrench to remove it and something to scrape off old gasket with.
Location:The thermostat should be inside the thermostat housing on the motor. Follow your top radiator hose to the place where it goes into the motor. There should be a sort of dome shaped housing there with probably a bolt on either side of it.The thermostat is inside that.
This is a reasonably easy job, but shouldn't be done carelessly. It's also kind of messy.
When the car is cold remove the bolts from the housing with a ratchet. Lots of coolant and water will drain out. But the thermostat will be visible.Pay attention to which side of the thermostat is up.It should just lift up. Remove all the old gasket from around the area and clean it up well. Replace the thermostat and gasket then the bolts. Be very careful not to over tighten the bolts or the housing will be ruined.

Posted on Apr 22, 2009

  • 2 Answers

SOURCE: Replace license plate light 2005 Hyundai Accent

A slightly better set of instructions might help you. Mine is a 2003 Accent. You have to remove the access panel that covers the lamps and the wiper control. Remove the phillips screws along the bottom of the panel (closest to the floor of the trunk when the lid is closed). Then remove the two screws that hold the brackets onto which the two strings are linked which are used to raise the rear deck slightly when the trunk opens. Next, there is a small cover underneath the rear wiper (about 2 inches square) that you need to carefully pry off using a small flat head screw driver via the indents on the lower side of the plastic cover. Inside you will find a 10mm bolt; use a ratchet to remove the bolt. Next, using a small flat head screw driver, carefully pry the middle section of moulding between the panel you are removing and the molding that covers the top portion of the back glass. There are two clips at the base of each middle moulding piece closest to the panel you are removing. Once those pop free, grab the panel at the bottom and firmly but gently pull away from the car body to pop free the two retaining clips holding the moulding to the car body. Finally, use one hand to grasp the panel from the bottom and the other to help help slide the panel "up" towards the glass (top of the car). The panel's top is flanged, and must slide up and away from the lip on which it sits. With the panel removed, grasp the white socket that holds the bulb and with gentle pressure turn it counter clockwise about 40 degrees and then pull the socket out. The replacement bulb is a type 168. Reverse these instructions to assemble, making sure in the end to push all retaining clips back into place until you hear them "catch" and hold the panel firm;y against the car body so that you do not get vibration noise.

Posted on May 19, 2009

  • 171 Answers

SOURCE: need a wiring diagram for a 99 hyundai accent tape deck

1999 Hyundai Accent Car Stereo Radio Wiring Diagram Car Radio Constant 12V+ Wire: Red/Yellow Car Radio Ignition Switched 12V+ Wire: Blue/White Car Radio Ground Wire: Black Car Stereo Illumination Wire: N/A Car Stereo Dimmer Wire: N/A Car Stereo Antenna Trigger Wire: N/A Car Stereo Amplifier Trigger Wire: N/A Front Speakers Size: 5 1/4′ Front Speakers Location: Doors Left Front Speaker Wire (+): White/Red Left Front Speaker Wire (-): Black/Red Right Front Speaker Wire (+): White/Blue Right Front Speaker Wire (-): Black/Blue Rear Speakers Size: 6 1/2′ Rear Speakers Location: Rear Deck Left Rear Speaker Wire (+): White/Red Left Rear Speaker Wire (-): Black/Red Right Rear Speaker Wire (+): White/Blue Right Rear Speaker Wire (-): Black/Blue

Posted on Jan 02, 2010

jturcotte
  • 7795 Answers

SOURCE: 2000 hyundai accent need timing

Timing marks are in the circles. Make sure belt is tight on right side when marks are aligned, then release tensionser to take up slack on the left side. Thanks for using fixya.


jturcotte_1107.gif

Posted on Feb 26, 2011

  • 61 Answers

SOURCE: I need a radio wiring

Radio 12v orange/black + radio
Radio Ground black - radio
Radio Ignition blue/black + radio
Radio Illumination green/orange + radio
Factory Amp Turn-on
Power Antenna pink + radio
LF Speaker +/- red - blue radio
RF Speaker +/- white - brown radio
LR Speaker +/- green - orange radio
RR Speaker +/- orange - blue radio

Posted on Feb 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Keeps blowing wiper fuses 2005 hyundai accent


Good Morning,.
Have you gone to the dealer and asked about a recall on the wiper motor? (bring your VIN #.

Also, go to the PARTS Department, not the service Dept (they want to make money from you) and ask for a schematic wiring diagram for the motor to assist with reference is further is needed.

you may want to check the wire circuit as the wiper motor may be touching the car body when shaken You may want to also shake the wires and terminals yourself while engine is running - BE CAREFUL OF MOVING PARTS..

Also, Your wiper motor may be about to go out, if it hasn't already, wiper motor pulling to many amps will cause the fuse to blow.

I owe, I owe, it's off to work I go!!

Please provide feedback and thanks for using fixya!

Best regards,
Ck

Best regards
Ck

Oct 30, 2011 | 2005 Hyundai Accent

2 Answers

Need set timing.


2005 Hyundai Accent. I replaced the timing belt, I get sparks, but won't start? Thanks.

Mar 24, 2010 | 2005 Hyundai Accent

1 Answer

Need a wiring diagram for a 99 hyundai accent tape deck


1999 Hyundai Accent Car Stereo Radio Wiring Diagram Car Radio Constant 12V+ Wire: Red/Yellow Car Radio Ignition Switched 12V+ Wire: Blue/White Car Radio Ground Wire: Black Car Stereo Illumination Wire: N/A Car Stereo Dimmer Wire: N/A Car Stereo Antenna Trigger Wire: N/A Car Stereo Amplifier Trigger Wire: N/A Front Speakers Size: 5 1/4′ Front Speakers Location: Doors Left Front Speaker Wire (+): White/Red Left Front Speaker Wire (-): Black/Red Right Front Speaker Wire (+): White/Blue Right Front Speaker Wire (-): Black/Blue Rear Speakers Size: 6 1/2′ Rear Speakers Location: Rear Deck Left Rear Speaker Wire (+): White/Red Left Rear Speaker Wire (-): Black/Red Right Rear Speaker Wire (+): White/Blue Right Rear Speaker Wire (-): Black/Blue

Jan 02, 2010 | 1999 Hyundai Accent

1 Answer

Accent 2005 brake light dont work fuse are good , bulbs blow out,I reset the override switch at shifth control


Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

Oct 04, 2009 | 2003 Hyundai Accent

1 Answer

My 2005 hyundai accent wont shift out of park unless i use the shift lock override. any advice?


on most cars when u step on the brake pedal youll hear a "click" near the center console which is the shift solenoid releasing the "lock" on the floor shifter allowing the shifter to come out of park.check to make sure all the fuses are good and check the brake lite switch(es) and wiringfrom brake lite switch to shifter solenoid.a wiring diagram always helps.

Aug 28, 2009 | 2005 Hyundai Accent

2 Answers

Windshield Washer Pump does not operate on 02 Accent


Your Accent has rear wiper/washer.. correct? That's where the 3rd wire comes in. They sold you/you bought the wrong pump. Here's the wiring diagrams:
bf35ab5.jpg
e609b85.jpg

Jun 01, 2009 | 2002 Hyundai Accent

1 Answer

Timing belt diagram for 2005 1300 hyundai getz


My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
I have only been a free contributor to this site for the past 4-months.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

CLICK
on the following LINK. It has the 2005 Hyundai Accent Timing which have Timing Belt Diagrams very similiar to what you will need.

If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!

Again my apologies...
http://www.2carpros.com/car_repair_information/year/2005/make/hyundai/model/accent/2005_hyundai_accent_timing_belt_diagram_marks.htm

Mar 23, 2009 | Hyundai Motor 2000 Tiburon

1 Answer

How to wire a trailer to hyundai accent 2005


There is a wiring diagram for European trailers here, but I guess you are in the US.

Sep 06, 2008 | 2005 Hyundai Accent

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...