Question about 2002 Chevrolet Impala

Open Question

How to disable tire monitoring system for 2009 chevy impala

The front driver side monitor broke now it just ring constantly because of this

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: tire monitor system light

look for the fuse or try to unplug ur battery and let if set for a couple of mins and plug back in but like for radieo u will lose ur channels u will have to set them again

Posted on Nov 30, 2008

Ad
  • 19 Answers

SOURCE: Tire pressure monitoring system

Don't know that much about these but depending on where you bought ur tires they might service them for free, I know places like big o and discount both service tires for free. My guess would be that the batteries just need changed since they're supposed to last ten years and the car is 11 yrs old.

Posted on Jan 09, 2009

  • 1 Answer

SOURCE: 2005 chevy impala car vibrates bad at 50 and above

poss broken belts in tire(s) shocks

Posted on Mar 22, 2009

  • 206 Answers

SOURCE: 2005 chevy impala rear driver power window stopped going up.stuck

If neither switch works it is a bad connection at the motor or bad ground or a bad motor. Remove the door panel unplug the motor push the switch and see if there is 12volts on the wires if there is the motor is bad There are small brushes in the motor that go bad tap on the motor while pushing the switch if it works that way replace it

Posted on Mar 29, 2009

  • 1 Answer

SOURCE: driver side window off track

2 sets (total 4) T30 Torx screws need to be removed.
The 2 holding the interior door handle grip / cup.
And then behind where the cup is, there are 2 more, that secure the door panel to the door.

FWIW, there are also 2 philips screws. One at the top, near the mirror. The second at the moveable door handle latch.

Lastly, of course, the standard "pop" sort of fasteners, around the perimeter on the 2 sides and bottom of the door panel. Also, there are 2 light blue plastic alignment posts (that do *not* fasten).

When re-assembling, make *sure* to properly catch / engage the door panel's top black plastic lip into the 3 hidden metal "U" holders, at the very top of the door panel.

Posted on Jul 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the location of the fuel filter on a 2009 chevy impala 3.5 liter?


I haven't done a 2009 yet, but all chevy's are on the drivers side, under the car, about at the drivers door, inside the frame.

Oct 08, 2014 | 2009 Chevrolet Impala

1 Answer

I have a 2009 Chevy Impala the service tire monitor system light is on, the service airbag light is on, and the MPH,FUEL, thermostat gauge don't move at all, any ideas what the problem can be?


check your tire pressure first but if all this lights came on at the same time then theres a power issue with the i/p (instument panel) have the car scanned with a good scanner and find out if theres any problems with the BCM (body control module) which it's the computer thata
controls all the I/P functions.

Jun 07, 2014 | Cars & Trucks

1 Answer

Reset tire monitor


The tires must be inflated to what is stated on the driver's door jamb sticker. If your tires are larger than what came factory and require a different pressure than what the door jamb states, the RCDLR must be reprogrammed for such.

May 05, 2014 | 2007 Chevrolet Chevrolet Suburban 1500 LT

1 Answer

I own a 2012 chevy impala Lt soemtimes when i start my car my stablitrak, traction control, ABS light and service tire monitoring system light come on but most of the times they come on when i'm driving...


Brakes have nothing to do with all those codes

After the brake work, the shop can road test &
diagnose the codes for you.

If you get the codes you can google them & see
what they mean

Apr 09, 2014 | 2012 Chevrolet Chevrolet Impala LT

1 Answer

I need a radio wiring digram color code for 2009 chevy silverado


2009 CHEVROLET SILVERADO C1500 4DR TRUCK WITH 4.3L ENGINE AND STANDARD AUDIO SYSTEM

Remote Start
WIRE COLOR POLARITY LOCATION
Battery RED/WHITE (+) IGNITION SWITCH HARNESS
LOW CURRENT, FOR HIGH CURRENT USE RED/BLACK AT VEHICLE FUSE BOX
Ignition 1 PINK (+) IGNITION SWITCH HARNESS
Accessory 1 BROWN (+) IGNITION SWITCH HARNESS
MAY BE YELLOW ON SOME MODELS
Accessory 2 PINK/BLACK (+) IGNTION SWITCH HARNESS
FOR REMOTE START INTEGRATION
Starter 1 YELLOW/BLACK (+) AT MODULE UNDER HOOD BEHIND DRIVER HEADLIGHT
NOT FOR REMOTE START, FOR REMOTE START INFORMATION
Starter 2 PINK/BLACK (+) IGNITION SWITCH HARNESS
FOR REMOTE START INTEGRATION
Anti-Theft Type GM PASSKEY IIIĀ® ANTI-THEFT SYSTEM
Anti-Theft Descript THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER
Key Sense PINK (+) IGNITION SWITCH HARNESS
Tachometer WHITE (-) AT IGNITION COIL
Speed Sense YELLOW/BLACK (AC) AT ECM MODULE UNDER HOOD ON DRIVER FENDER
BLACK PLUG PIN #57
Parking Lights LIGHT BLUE (-) AT VEHICLE LIGHT SWITCH
Brake Lights LIGHT BLUE/WHITE (+) AT SWITCH ABOVE BRAKE PEDAL
IGNITION MUST BE ON FOR THIS WIRE TO TEST
Reverse Lights DARK BLUE (+) AT BCM MODULE UNDER DRIVER DASH
Horn TAN (-) IN HARNESS AT STEERING COLUMN
ALSO AT BCM MODULE UNDER DRIVER DASH
Modules
WIRE LOCATION
Please select another category
Doorlocks/Windows
WIRE COLOR POLARITY LOCATION
Power Unlock WHITE (-) AT BCM MODULE UNDER DRIVERS SIDE OF DASH
THIS WIRE UNLOCKS THE REAR DOORS ONLY, WILL REQUIRE A 5-WIRE SET-UP IN EACH FRONT DOOR TO INTEGRATE OR A SERIAL DATA MODULE FROM AN ALARM MANUFACTURER
PowerLock LIGHT BLUE (+) AT BCM MODULE UNDER DRIVERS SIDE OF DASH
THIS WIRE LOCKS THE REAR DOORS ONLY, WILL REQUIRE A 5-WIRE SET-UP IN EACH FRONT DOOR TO INTEGRATE OR A SERIAL DATA MODULE FROM AN ALARM MANUFACTURER

i would use a DLPK module

DLPK (2009 Chevrolet Silverado)
W2W
CC-Heated Seats Activation
DL-Arm Factory Security
DL-Disarm Factory Security
DL-Door Lock Control
DL-Door Unlock
DL-Driver Priority Unlock
PK-Immobilizer Bypass-Data No Key Req'd
RS-RAP Shut Down (Remote ACC Power)
RS-Tach / RPM Output
SS-Entry Monitoring ALL Door Pins
SS-Entry Monitoring Driver Door Pin
SS-Entry Monitoring Front Door Pins
SS-Entry Monitoring Hood Pin
D2D
CC-Heated Seats
DL-Arm Factory Security
DL-Disarm Factory Security
DL-Door Lock Control
DL-Door Unlock
DL-Driver Priority Unlock
PK-Immobilizer Bypass-Data No Key Req'd
RS-RAP Shut Down (Remote ACC Power)
RS-Tach / RPM Output
SS-Entry Monitoring ALL Door Pins
SS-Entry Monitoring Driver Door Pin
SS-Entry Monitoring Front Door Pins
SS-Entry Monitoring Hood Pin


Hope helps.

Mar 31, 2011 | Chevrolet Silverado 1500 Cars & Trucks

2 Answers

A yellow light just came on on my 2008 Impala. Its a circle with an exclamation mark. What does it mean?


Tire pressure monitoring system. Start by checking your tire pressure and set to what the sticker on the drivers side door frame indicates. If this does not turn the light off you will have to re-learn the sensors to the vehicle. This is done by:
reset the tire pressure monitoring system, to do so, you need to get your key fob, and put your ignition key in the ignition, turn it to the accesories position, and simultaneously press the lock and unlock buttons on the key fob. hold them until the car honks the horn.

then take something to let out air in the tires, you need to start with the left front then go to the right front, then the right rear, then the left rear.

start at the left front, drop the pressure in the tire until the horn beeps, -usually takes 8 seconds or so. then repeat on the other tires in the order above.

After you finish with the final tire, the horn will honk again, then you know your done. usually honks 2 times.

and then you can turn the key off, and set your tire pressures.

Feb 25, 2011 | 2008 Chevrolet Impala

1 Answer

What is the correct tire pressure for a 2009 Chevy Impala with Goodyear tires? was not on my papers


Look at the inside of the drivers front door. There will be a tire pressure inflation sticker. I do believe 30psi is normal for most newer GM "full size" cars.

Sep 26, 2010 | 2009 Chevrolet Impala

3 Answers

Reset tire pressure monitoring system


after you have inflated the tires to the correct pressure press the tire pressure button for a few seconds untill you hear a beep sound .that indicates the tire pressure has been reset. hope that helps

Dec 22, 2009 | 2009 Volkswagen Tiguan

2 Answers

2008 chevy cobalt can you turn off the tire pressure moniter system


Tire pressure monitoring systems are not defeatable. Well i should say, not easily defeatable. Why would you like to turn it off?

Oct 25, 2009 | 2001 Chevrolet Cobalt

Not finding what you are looking for?
2002 Chevrolet Impala Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...