Question about Cars & Trucks

Open Question

Can a radiator drain plug for a 93 gmc k2500 be replaced after it blew

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: RADIATOR DRAIN PLUG

I was able to reach up there with a small 1/4" socket driver and a small extension. Not easy, you will probably make a bit of a mess. Takes a little patience. I also suggest flushing the whole coolant system and putting in the green coolant.

Posted on Jul 27, 2008

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I want to flush the radiator on my 2001 gmc jimmy. Is the radiator draincock covered by a plastic shielding? Also does the draincock have an O-ring that would need to be replaced? Thanks. Ian v.


there should be a drain **** on either side of the lower radiator. you might have to remove the splash guard to get to it easier, If it is not leaking then the o ring does not need replaced when you drain, the drain plug does not have to be removed all the way, it has a drain hole on it when the plug is loosened to a certain point it will allow to drain. If you remove all the way then go ahead and inspect o ring and replace before installing again. but always lube an old or new rubber o ring with (oil) before installing. Installing a dry rubber o ring will result in possible failure.

Jan 21, 2011 | 2001 GMC Jimmy

1 Answer

Drain plug radiator location


Hi!!!

Drain plug is located on radiator bottom facing engine, driver side.

Note: Never open drain plug when radiator is hot, wait for it to cool down, remove radiator cap to release pressure then open drain plug.

Don't forget to rate this answer!!

Apr 19, 2010 | 2003 GMC Envoy

1 Answer

1992 K2500 gmc brake lights wont work


try looking on the fuse box, see if it is still okey, then replace if neccessary

Mar 23, 2010 | 1993 GMC Sierra K2500

1 Answer

Radiator drain plug for 2003 gmc envoy. need to flush radiator


if you cant find the drain plug you can pull the lower radiator hose to flush it

Jan 29, 2010 | 2003 GMC Envoy

1 Answer

How to replace the radiator drain petcock on a 89 k2500


There common to break off, you can pick up the replacement drain plug at NAPA and buy a stud retracter to remove the drain plug. if the plug is not leaking, Leave it alone and to drain the radiator, just disconnect the lower radiator hose on the opposite side of the radiator.

Good luck and hope this helps you on your project.

Jan 05, 2010 | 1990 Chevrolet K2500

2 Answers

93 gmc k2500 4x4 runs like its missing when warmed up. cat.converter? pulled someone out of mud,hard. over tacked engine


a bad cat will cause it not to rum faster than 45mph. usually miss at warm after over taxing is bad camshaft. you probably knock the lobe down. you need to do a compression test on all cylyinders. they need to be reading close to each other. also just make sure plugs and wires are good. cap and rotor also

Dec 27, 2009 | 1993 GMC Sierra K2500

2 Answers

Can not find drain on radiator of a 2003 gmc


It should be there. Just look hard under the radiator back-side wall, or directly under the radiator.

Nov 14, 2009 | 2003 GMC Savana

1 Answer

My 93 K2500 GMC 4X4 Suburban wont Go Once It warms up


Check the catalitic converter,fuel filter, sparkplugs and sparkplug wires.

Oct 27, 2009 | 1993 GMC Suburban

1 Answer

Highbeam headlights work but no low beam, it is not the switch........?


Check voltage at the circuit box and test the high/low dimmer switch. Corrosion on a ground wire could also be the problem.

May 19, 2009 | 1993 GMC Sierra K1500

1 Answer

1994 gmc sierra 4x4 350cu inch auto trans engine coolant gurgling started gurgling after water pump was replaced replaced waterpump with gm oem then replaced heater core then replaced head gaskets still...


I have seen this many times before. The sound is air being forced out of the radiator cap and escaping back into the coolant recovery bottle. It can be as simple as a new radiator cap or as costly as cylinder head crack, or even block cracked. It is important that your radiator be completely full with proper coolant mix and have a good working order cap with the proper pressure.

Jan 04, 2009 | 1991 GMC K2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...