Question about 2000 Chevrolet Cavalier

Open Question

What size is the rear brake line for a 2001 cavalier

What size is the brake line for the rear of a chevy cavalier

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: No rear brake light / turn signals on 2001 Chevy Cavalier

The problem is the turn signal/headlight/hazard switch assembly on the steering column which the brake light wiring runs through. The part is easy to change and cost about $50 at most parts stores

Posted on Sep 05, 2008

  • 3 Answers

SOURCE: How do you change the headlight for a 2001 chevy cavalier

i actually just did this a couple days ago, this takes about 20 minutes and a little bit of patience. When you pop your hood you will see a protective piece of plastic over the headlights/radiator, you firstly have to remove the plastic clips holding that piece then pull that piece of plastic off, once done u will see 2 bolts holding each headlight in place, i believe it is a 9/16 socket but if not just find the one that fits, remove the 4 bolts (2 for each headlight) and pull the headlight in an up and outwards manor. if you feel any resistance do not yank look at why it is catching and clear it, then it should just pop out (the headlight and the corner piece and clipped together so dont pull it too far out) then when the bulb is accessible pull the old bulb, put the new bulb in and voila place the headlight back into position, redo the 4 bolts holding the headlights and re-attach the plastic headlight/radiator cover. Enjoy the new lights

Posted on Dec 24, 2008

motor1258
  • 6674 Answers

SOURCE: 2001 chevy cavalier door contact switch install

If no screws or nuts holding it that you can see from outside, then just use a screwdriver or something and pry at the base where it is against metal.

Posted on Jan 04, 2009

carfreak1217
  • 109 Answers

SOURCE: 2001 chevy cavalier turn signal relay location

Above the brake pedalc956ca0.gif

Posted on Jun 27, 2009

  • 2309 Answers

SOURCE: replace fuel pump in 2001 Chevy Cavalier

remove the gas tank, undo the ring that holds the sending unit , replace fule pump and new sock filter, reinstall

Posted on Nov 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1997 chevy cavalier. I replaced wheel cylinders, brake lines, front calibers master cylinder and booster. When I bleed the brakes I only get brake fluid from the front bleeder on the ABS system. I...


sometimes if you leave the bleeder screw open it will gravity bleed the cylinder.Make sure master cyl is full and do one wheel at a time.I have seen this work, I have done it.

Nov 16, 2010 | 1997 Chevrolet Cavalier

2 Answers

How to change rear brake disk on 01Chevy Silverado


need a torx 55. must remove caliper in the bracket then remove the caliper. Bracket bolts are 17mm I think.

Oct 23, 2009 | 2001 Chevrolet Silverado 1500

1 Answer

No brake in front rear is good check leak no leak no air in lines cavalier 2001


master cylinder need repaired or replaced, there are kits that you can rebuild it with

Aug 09, 2009 | 2001 Chevrolet Cavalier

1 Answer

Chevy Cavalier 2001 ABS Brake problem


You don't say what brakes.

I have had many cavys and worked on them. Great cars.

Your problem sounds like a **** rear wheel cylinder and bad drums/rotors and abs sensor wire.

My car just did everything you describe, I put in new wheel cylinders, drums, brakes, rotors, and 2 new rear brake lines. For less than 200 bucks the car is like new again and has well over 100k.

You can do it yourself. Doesn't take special tools. I followed online how-to's.

Apr 16, 2009 | 2001 Chevrolet Cavalier

1 Answer

Brake pad replacement


You will need to look in your owners manual and maybe for an advisement phone into a Chevy dealership and ask ...... your engine size will actually have no affect in what size of pad you must use and sometimes the size will be posted on the pad that is currently installed

Jan 10, 2009 | 2001 Chevrolet Cavalier

1 Answer

Chev Cavalier 2003 only one rear turn/brake/hazard light


I have a 2002 Chev Cavalier that had the same exact problem. I replaced the bulb harness (purchased from a chevy dealership for around $5) which was fairly easy to do. I have had zero problems with it since.

Sep 15, 2008 | 2001 Chevrolet Cavalier

4 Answers

1999 Cavalier rear brakes engage and lock up before front brakes engage. Any ideas?


you have to change the rear to the front line on your master cause of the proportioning valve is not on the good wheel

Jul 15, 2008 | 1997 Chevrolet Cavalier

6 Answers

No rear brake light / turn signals on 2001 Chevy Cavalier


The problem is the turn signal/headlight/hazard switch assembly on the steering column which the brake light wiring runs through. The part is easy to change and cost about $50 at most parts stores

Jul 05, 2008 | 2001 Chevrolet Cavalier

Not finding what you are looking for?
2000 Chevrolet Cavalier Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...