Question about 2007 Lincoln Town Car Signature Limited Sedan

Open Question

Dual control 2007 towncar driver's side blend door inop

Heat or cold inop on driver's side vents blend door inop ?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 10 Answers

SOURCE: have 1996 lin towncar where n how 2 fix blend door 4 heat n a/c

In order for the blend door actuator to be replaced, the dash must be removed from the vehicle.

Posted on Feb 07, 2009

Ad
chuck943
  • 783 Answers

SOURCE: Dual Temperature controls inside - 2002 lincoln ls

The problem is most likely a bad dual climate control valve. This component is located on the right side near the radiator under the hood. It will have several coolant hoses hooked to it and 2 silver cylinders protruding from it. You can clamp off the heater hoses at the heater core and see if both sides cool then and this will tell you that the valve is letting coolant thru when it shouldn't be.

This will narrow it down to either the valve or the control head inside the car,or wiring in between them. The only way to narrow it down further is if you have a scan tool that could access the climate control data. Have seen several of these valves cause this concern and have only seen one control head cause it.

Posted on Apr 02, 2009

  • 1 Answer

SOURCE: constant high heat

on climate control press off and heat button and let go quickly. Then press automatic. The display will start rotating eventually displaying a code 025,125 , 024 etc. Then press defrost to stop. You may hear blend door operating atb that time. It worked for my climate control.

Posted on May 06, 2009

  • 733 Answers

SOURCE: 1997 Lincoln Town Car; nothing but heat

check your vaccum lines behind the dash. if you find the one that goes to the blend door, put some vaccum on it and see if it opens and closes for you. if not, then yes, your blend door is broken. if it closes, check your temp control gauge.

Posted on Sep 19, 2009

  • 50 Answers

SOURCE: 96 LINCOLN TOWNCAR STUCK ON HEAT ONLY !

The heater and a/c blend door actuator motor is located behind the center of the dash just below the windshield. The steering column must be detached and lowered and the dash must be removed to access the blend door motor.

Posted on Oct 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2007 Pontiac g6 blows cold air in heat mode. Coolant level is okay


Possible blend door motor inoperative or restricted heater core. Once engine is at operating temperature feel the two hoses going into the heater core. They should be close to the same temperature. If one is hot and one is warm/cold, the heater core is restricted. If both close to the same temp suspect an inoperative blend door motor that controls airflow/heat inside the car

Dec 21, 2015 | Pontiac Cars & Trucks

1 Answer

Why did the passenger side of the dual climate control on my Buick Lucerne only start blowing cold air? Have no heat on that side, just air conditioning works.


May b a blend door issue..
If its electronic unit then maybe a actuator gone bad
If controlled by vacuum then a broken/loose hose
Does that side change from different settings(dash/floor/defrost even)= blend door issue usually

Sep 17, 2014 | 2007 Buick Lucerne

2 Answers

Heat comes thru driver's side vents, but blows cold air thru passenger side vents


You likely have a faulty blend door. It could be electrically, mechanically related, or even a broken door. It may be the blend door motor, or possibly the temp sensor.

Dec 30, 2012 | 2010 Ford Flex

1 Answer

The passenger side air conditioner vents do not blow cold air. The driver side air is cold as is the air from the rear seat vents. What can I do?


u have a blend door inoperative. if u have dual climate control(passenger/drivers seperate heater/air controls u may have a defective switch or a defective interior air temp sensor. possible bad blend door motor as well-hope this helps

Aug 31, 2012 | 2006 Cadillac DTS

1 Answer

The two vents on driver side of car blows hot air when air conditioning is on


I believe that your Seville has dual climate controls.So it sounds like a "Blend Door Actuator" problem. It's stuck and so it's not adjusting the mix of warm or cold air; that's how temperatures are controlled in your A/C heat system. Fault code(s) stored in the HVAC control module should be available to assist with diagnoses. AutoZone will perform a free diagnostic scan.

Jun 10, 2012 | 1998 Cadillac Seville

1 Answer

My ac only blows cold air out the driver side vents. The passenger vents and the rear seat vents just blow air.


There is a "blend" door on some models with automatic climate control and/or dual zone heat and air. If your model has this option, this might be the source of your problem. Possibly the blend door is stuck and can be freed easily if you're lucky. I have heard of some repairs for this problem to be quite costly, so definitely check around and get several diagnoses from reputable sources before jumping into this.

Jun 16, 2010 | 2005 Jeep Grand Cherokee

1 Answer

2004 gmc dual ac, driver side vents shift from ac


bad blend door actuator maybe there is way to press the buttons on controller to make doors recenter they call it

Mar 22, 2010 | 2004 GMC Sierra 1500 Crew Cab

1 Answer

2001 lexus gs300 ,heat comes out drivers side vents only. passenger side cold air only, car has dual controls but acts like heat flapper not opening


your blend door on your passenger side is most likely stuck in the cold position. Chances are you cable is broken. Good luck.

Dec 30, 2009 | 2001 Lexus Gs 300

1 Answer

Heater Passenger side doesn't change


Most likely the blend door motor is defective.

Oct 29, 2008 | 1993 Buick Regal

Not finding what you are looking for?
2007 Lincoln Town Car Signature Limited Sedan Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

fordexpert

Level 3 Expert

5537 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...