Question about 1998 Dodge Ram 3500 2WD

Open Question

Code PO 700 on a 2003 5.9 Dodge Ram Diesel

Surges and accelerates while driving. Then goes to idol with no pedal response

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

BCally1
  • 133 Answers

SOURCE: replacing serpentine belt for dodge ram 3500 diesel

5.9L DIESEL
196759.jpg The 5.9L diesel engine accessory drive system (with a/c) consists of :

  1. Generator Pulley (1)
  2. Water Pump Pulley (2)
  3. Idler Pulley (3)
  4. Power Steering Pump Pulley (4)
  5. Radiator Fan Pulley (5)
  6. Crankshaft Pulley (6)
  7. Automatic Tensioner (7)
  8. A/C Compressor Pump Pulley (8)
CAUTION: When installing the accessory drive belt, the belt must be routed correctly. If not, engine may overheat due to water pump rotating in wrong direction. Refer to or for correct engine belt routing. The correct belt with correct length must be used.
1. Position drive belt over all pulleys except water pump pulley. 2. Attach a 1/2 inch ratchet to tensioner.


196757.jpg The 5.9L diesel engine accessory drive system (without a/c) consists of :
  1. Generator Pulley (1)
  2. Water Pump Pulley (2)
  3. Idler Pulley (3)
  4. Power Steering Pump Pulley (4)
  5. Radiator Fan Pulley (5)
  6. Crankshaft Pulley (6)
  7. Automatic Tensioner (7)
3. Rotate ratchet and belt tensioner clockwise. Place belt over water pump pulley. Let tensioner rotate back into place. Remove ratchet. Be sure belt is properly seated on all pulleys.

Posted on Jan 22, 2009

  • 1 Answer

SOURCE: Trouble code P1740 on 1999 Dodge Ram 2500

I had the same code on my 2001 dodge 2500. The truck wouldn't shift from 3-4. I pulled the trans pan off and replaced a broken spring ($2.00). It is behind a thin plate with 3-4 small torq screws. You don't have to remove the valvebody. Only took me 45 minutes to fix.

I would like to give thanks to Jeff Russel from Teal automotive. He said this is a very common problem. He sells any part for any automatic Transmision and his prices are very affordable.
Here is a link to the website.
http://www.tealautomotiveinc.com/

Hope this helps.

Posted on Jul 19, 2009

  • 83 Answers

SOURCE: 2006 Dodge Ram 2500 diesel truck----need inside fuse box diagram

If you are looking for the fuse box diagrams or any other diagrams for your Ram, check promanuals.net for a factory service manual for around 20 bucks or so. It's an invaluable tool for my Ram 2500.

Posted on Sep 26, 2009

  • 151 Answers

SOURCE: 2001.5 Dodge Ram Diesel 2500 4x4 Brake Pedal drops to floor

It sounds like you have a bad mastercylinder cause when you panic brake it doesn't have time to bleed through the valve in the cylinder but under normal braking your foot is on pedal longer in turn giving the fluid time to bypass the valve in the mastercylinder in turn the pedal going to the floor.

Posted on Apr 21, 2010

Testimonial: "thnx"

  • 200 Answers

SOURCE: What does code ccd mean on overhead display 1997

It means "Crystal Clear Display" but in basic term its called a ccd bus, basically the OH console module is not communicating with body control module so you want to check power and ground pins or you just might have a bad module, sorry.
A self-diagnostic test is used to determine that the
compass mini-trip computer module is operating
properly electrically.

CCD communications test.
Following completion of these tests, the compass
mini-trip computer will display one of three
messages: “PASS,” “FAIL,” or “CCd.”

if the “CCd” message is displayed, the use of a
DRBt scan tool and the proper Diagnostic Procedures
manual are required for further diagnosis.


Posted on Jun 30, 2010

Testimonial: "Many thanks for your expert advice"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When accelerate above 30mph its cuts out or loses power but runs smooth at idle


Acceleration cut off when reach 30mph - Range Rovers

www.rangerovers.net/...rover.../27680-acceleration-cut-off-when-reach-...

Mar 30, 2010 - 16 posts - ‎6 authors
All of a sudden, RRSport HSE 2006 can not speed above 30mph. ... It's only an hour's drive away if your car could go straight upwards. .... My guess is that some control module got fried or out of whack when the power spike ...

WILL NOT GO OVER 30MPH WITH PEDLE TO METAL ...

repairpal.com > Questions > Dodge > Charger > 2006 Dodge Charger
... and a 18 wheeler comes up behind me going 85mph. or more and my car drops down to 35 to 40. ... It would not let me go pass 30mph and it would bog out. .... His truck was barely over 36k. when this happened. ... sudden I was cruising at 30 more or less and could not accelerate or shift gears I could just switch to Drive.

My Chevy Silverado won't go over 25 miles an ... - CarGurus

www.cargurus.com > Questions > Chevrolet > Silverado 1500

CarGurusSep 19, 2012 - His response wasn't even there until the page refreshed when I hit ...The engine would shut off due to a clogged fuel filter not hit 25 MPH and just stopaccelerating. ... when the gas pedal was to the floor but it wouldn't go over 30 MPH?.... When I punch it at 110 or above, it will cut out and drop to 103kph, ...

Starts,Idols perfect Bogs down, no power upon acceleration ...


Jan 31, 2016 | Cars & Trucks

2 Answers

B2300. What are the probable causes of DTC P0132?


Use an ohmmeter to check your spark plug wires all have very close to the exact same resistive value

Nov 19, 2015 | 2004 Mazda B-Series

1 Answer

95Corolla surges when you accelerate while driving


sticking fuel enrichment solenoid, EGR control or valve leaking vacuum around stem. slow o2 sensor response.

May 06, 2014 | 1995 Toyota Corolla

1 Answer

I have problems with my 1999 mercedes-benz ML320. minutes after ignition, when driving at low speed or high speed acceleration note failure. push the accelerator pedal fully and have no adequate response....


Check fuel pressure and flow. Symptoms resemble clogged filter or faulty fuel pump. Faulty fuel pumps run for a time before failing to provide proper pressure; a faulty fuel filter may function for a brief time before debris clogs it each time the engine is started...

Feb 18, 2014 | Mercedes-Benz ML320 Cars & Trucks

1 Answer

Surges to the right


it seems that all the power is going to the drivers side wheel or the passenger brake is not fully releasing..check the brake first.. then go to the drive train under the car and check everything from the wheel to suspension parts look for worn bushings etc..this requires putting the car on a lift and getting under it..

Dec 28, 2013 | Lexus ES 300 Cars & Trucks

2 Answers

I have a Jetta TDI 1993 Model and I have a problem, while driving the I get no response from the accelerator pedal, the car seems to idle but there is no accelerating power. If turn the engine off and on...


Go back to that VW dealer and complain. I'm sure you payed plenty, and I know in my shop, if a customer's car is not repaired to their satisfaction, I want to know, and make it right. Sometimes parts can be bad right out of the box, and sometimes problems are misdiagnosed. Go back, but don't agree to pay for anything untill you get a satisfactory explanation. Good luck.

May 12, 2011 | 1993 Volkswagen Jetta

2 Answers

Sometime no accelerator response


YOUR ACCELERATOR PEDAL SENSOR ON ACCELERATOR PEDAL IT HAS BOLTS HOLDING IT IN PLACE.JUST UNPLUG ACCELERATOR CONNECTOR AND REMOVE THE BOLTS THEN SENSOR.

Jun 06, 2010 | 2002 Ford F350 Super Duty DRW Reg. Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...