Question about 2001 Dodge Neon

1 Answer

01 neon run rough

Vibration in stearing wheel

Posted by on

  • Lionel Sabourin
    Lionel Sabourin Jan 01, 2013

    vibrates in park is this normal i have 2 neons both o1 replaced plugs wires still vibes

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My 01 neon did the same. I am in the process of replacing all the engine mounts. But if you have done this already it could be alot of other problems. Does it do it most when your idling?

Posted on Jan 14, 2013

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 76 Answers

SOURCE: ignition lock -98 dodge neon

Sounds like the ignition cylinder is jambed, if you remove the covers and put the key in, you might be able to turn it with pliers, just turn it to the accessories position, then there is a small metal clip that pushes in, push it in and pull the lock cylinder out of place, get a new one from the dealer and reverse to install. If it's above you, your dealer can help, usually about an hours labour or so.
Hope that helps, Good luck
R

Posted on Feb 27, 2009

  • 31 Answers

SOURCE: overflow in car is bubbleing after i shut it off.

I had this happen with a buick century, and it was the fan not coming on to cool the water. Get a new fan motor or toggle switch so you can turn it off and on manually.

Posted on Jun 03, 2009

vetteman3002
  • 2299 Answers

SOURCE: i have a 2003 dodge

Is there any sound that goes with the vibration? Does the vibration change when you rev the engine up?

Posted on Jan 14, 2011

  • 1 Answer

SOURCE: 2003 dodge neon front-end shimmy

i am almost sure is the aligment and balance of the wheels, but if you just turned on your car and once you take it of parking and feel a little pull or a clunk noise it might motor mounts or transmission mounts.

Posted on Dec 15, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car momentarally shutters at all speeds and gears more and more frequently after it is warmed up. You can feel it slightly at idle.


2003 neon shaking after changing both right motor mounts ...

www.topix.com > Dodge Neon
Mar 10, 2012 - ... News Offbeat Stars! Topix > Dodge Neon > 2003 neon shaking after changing both. .... Google dodge neon engine alignment, and some sites will fill you in better. Reply ยป. Report Abuse .... 95 neon oil leak? (Oct '08), Oct 22 ... dodge neon engine vibration
Nov 10, 2012
2004 Dodge Neon SXT Problems
Jan 8, 2011
02 neon vibration under acceleration
Jul 21, 2007
97 Neon Idle rough
Jan 18, 2007
More results from www.topix.com

Oct 29, 2015 | 1995 Dodge Neon

1 Answer

My stearing oil leak away from my stearing system


Inspect the source of leakage. (Power steering pump,
clamps, discharge or high pressure pipe, suction or low side pipe, rack and pinion assembly).
- Vibrating while braking means the front wheel brake rotors are warped or rear brake drums are eccentric. (Tooling is required)

Mar 06, 2014 | 1996 Toyota Corolla

1 Answer

Had new motor mounts put on dodge neon sxt 2005, now the steering wheel vibrates when ideling, what is this caused by?


if solid mounts where installed then it is engine vibration.
the vibration is from the engine !

Apr 18, 2013 | 2005 Dodge Neon

2 Answers

Vibration in stearing wheel from engine while parked is this normal have two with same problem


No it's not. Usually a moderate vibration in park or neutral is a bad motor mount or transmission mount.

Dec 31, 2012 | Cars & Trucks

2 Answers

2003 dodge neon front-end shimmy


Check the fron tires if they are good you need new rotors.

Jul 26, 2012 | 2005 Dodge Neon

1 Answer

Car wont idle


There re few possibilities that can cause no idle issues.To troubleshoot the issue help links are provided below.Click the link below:---
Idle Problem? http://whatisbyme.blogspot.in/2012/05/2001toyota-corolla-idle-problem.html
---------
Idles rough and quits when gas pedal is pressed less? http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html-----------
Stumbling and stalling at idle after engine rebuild? http://schematicsdiagram.blogspot.in/2012/03/stumbling-and-stalling-at-idle-after.html

--------
Cooling fan Shuts OFF and Idle Drops? http://howtobyme.blogspot.in/2012/05/toyota-celica-cooling-fan-shuts-off-and.html

---------
Rough Idle and Vibration? http://whatisbyme.blogspot.in/2012/05/2006-ford-f150-rough-idle-and-vibration.html

---------
Steering Wheel Vibrates at Idle? http://whatisbyme.blogspot.in/2012/05/1993-toyota-corolla-steering-wheel.html

---------
Runs Fine But Idle Is Low? http://whatisbyme.blogspot.in/2012/05/2004-toyota-highlander-runs-fine-but.html

--------
Vehicle Will not hold Idle? http://whatisbyme.blogspot.in/2012/05/2003-lexus-es300-vehicle-will-not-hold.html

----------
Engine Idles Rough and Dies? http://whatisbyme.blogspot.in/2012/05/1994-lexus-es300-engine-idles-rough-and.html

---------
This will help.
Thanks.

Jul 17, 2012 | Cars & Trucks

1 Answer

Why would my right passenger front wheel vibrate and shake when hitting a bump?


first check the wheel bearing on that side if its not floppy check the ball joints for wear try lifting them any life in them shows there worn out,,,then check the shocker bounce the wing a fuw times and let it go if it keeps bouncing up and down more than a fuw times (2) the shocker is worn out,,,the last thing to test is the stearing arm from the stearing box/rack get hold of the wheel at 3 and 9 o clock push and pull on it,,if its easy to turn and floppy look for any bits in the stearing that flop about

Aug 24, 2010 | 2004 Mitsubishi Lancer

1 Answer

SMALL PROBLEM ROUGH IDLE.SMALL VIBRATION WITH MOTOR-DASHBOARD MAKES VIBRATION SOUND. 2003 NEON HAS 130,000 MILES BUT FEELS LIKE IT RUNS COLD ALL THE TIME.WHEN IT FINALLY WARMS UP IT RUNS KINDA BETTER BUT...


You need to find out what DTC the vehicle sets when the check engine light comes on. This will help you diagnose the problem. The engine is misfiring causing the rough running concern and probably the vibration in the dash. The DTC will tell you what specific cylinder the misfire is in P0300-304 or if the fuel is metering too lean P0171. Then you can check the appropriate system for a fault. you'll need to get a generic OBD2 code puller (local parts stores sells these things). let me know what specific DTC's you pull and I'll see if I can help you further.

Jan 26, 2010 | 2003 Dodge Neon

1 Answer

Vibration on front passenger wheel but not through stearing wheel.not wheel balance as wheels rotated.


first check your wheel nuts are all tight.also check wheel size is the wheel the same size as the other wheels.take the car to tyre center.how do you know you know you have a vibration if its not through the stearing.most likly in the back wheels.adrian;;;;;;;;;;;

Jan 22, 2010 | 2006 Suzuki Swift

Not finding what you are looking for?
2001 Dodge Neon Logo

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...