Question about Nissan Frontier

Open Question

Nissan frontier wont shift out of 1st gear - Frontier Nissan Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 2003 nissan altima 2.5s transmission rough shift

Probably sensors! I have already replaced the crankshaft positioning sensor once, nissan replaced it once under recall and now it is bad again! Plus my speed sensor is bad too! Go to any part store and get diagnostic test ran, it will tell what sensors are bad.

Posted on Oct 02, 2008

  • 1 Answer

SOURCE: 1998 chevy k1500 4x4 4

first of all your truck is already in first gear when your going down the road....lol

Posted on Mar 06, 2009

glamarre82
  • 140 Answers

SOURCE: 04 nissan sentra shifting hard

Do you have a CVT? (Continuosly Variable Transmission) I doubt that you do so if you dont, nissans are known to have hard shift into second gear you mean.(Once the car moves, its already in first gear) so if it shifts fine into other gears, I wouldnt worry too much unless it gets worse.

Posted on Jul 15, 2009

  • 1 Answer

SOURCE: 2003 Nissan Sentra SE-R Spec-V clutch sticking and hard shifting

I am dealing with a very similar issue on my 03 Spec V , So far i noticed the clevis pin was loose and the locking hitch pin that slips thru it had fallen out . this caused the gears to not wanna engage due to the bolt behind the clevis which runs to the master cylinder was not getting pressed in when i pushed the clutch pedal in because the clevis pin was slippin on n off giving me no pressure up top .. I had to remove my lower dash panel in order to get visual n hand access to this pin , it is a tight spot to work in as well . May be easist to remove the 4 14mm bolts that hold yur driver seat in to give ya more room to work n stretch out ur arms

Posted on Dec 24, 2009

Jta91
  • 99 Answers

SOURCE: 1999 saturn sl2 transmission wont shift from 1st gear

Your valve body and possibly input shaft nut need to be replaced. The valve body's booster valve is worn down and won't create pressure. Before it went completely out it slammed on the input shaft nut and loosened it.

You need to replace the valve body and retorque the input shaft nut. The transmission is not junk. The above needs to be replaced and change the filter and fluid and do it every 20K miles.

Posted on Feb 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Nissan Frontier will not shift past neutral into drive. I've tried pulling as hard as I can but it will not budge


that little pin hole by the gear lever you've probably noticed but never knew what it did will get the gears to move. put a pin inside the hole and it will release the gears

Jan 15, 2016 | 2011 Nissan Frontier King

1 Answer

Starting frontier after manually shifting automatic gear shifter without key?


The shifter lever must be in either neutral or drive. The Frontier has an unlock mechanism to shift the lever if is locked.

Oct 08, 2014 | 2000 Nissan Frontier

1 Answer

No 5th gear or reverse


I have a 1998 Nissan Frontier, 2wd. I was driving back from lunch one day, and the 5th gear stopped working. Then the next day, the reverse stopped working. It switches into 1st, 2nd, 3rd, and 4th just fine. Please help. What do you think it could be. I have no money to take it to the shop

May 28, 2012 | 1998 Nissan Frontier

1 Answer

My 91 maxima will not shift out of 1st gear its


Try going to your local parts store (such as AutoZone) and ask about the transmission control solenoid. Go here for the direct link to their website with that specific part for your 91 maxima.

Apr 01, 2010 | 1991 Nissan Maxima

1 Answer

Check engine light is on, codes say throttle body sensor. Replaced sensor, light back on in two days, now truck seems to rev an extra 5000 rpms occasionally when shifting from 1st to 2nd gear. 2001 Nissan...


the throttle body butterfly is letting too much air through so its probably stuck or dirty, they should be cleaned every service but noone ever does, if its revving beteen gears then its prob getting stuck in different places so it could probably just use a good clean out

Feb 10, 2010 | 2001 Nissan Frontier Crew Cab

1 Answer

Nissan is telling me that the problem I have explained to them is called "shift shock." Ever heard of it? between 1st and 2nd gear at 20mph while lugging, it will knock very hard into gear. Rough stuff! ...


I have a 2006 Nissan frontier and have never had that happen. It does have the ability to lock the gear while on a downgrade. When I go down a hill and I hit the brake the transmission will lock the gear until I hit the gas...but it only does it downhill and I told about the feature when I purchased the truck. Maybe what is happening is the hill control activating. What you are describing..It does not sound right. I would take it to another dealer for a second opinion. How does the transmission fluid look and have you done a transmission service on a regular basis?

Oct 15, 2009 | 2005 Nissan Frontier

1 Answer

I can't shift into reverse. All other 5 gears are


My VW is not shifting into reverse at all; I think a certain person was driving and mistakenly pressed the gear shifter down for all gears--reverse is the only gear you press the shifter down first in. Doesn't grind, 1 2 3 and 4 work but no reverse no reverse lights.
I've read several complicated (can't see scenario's) posts on screens and linkage and a cable fixed one guys problem but still no solutions.

Oct 07, 2009 | 2002 Nissan Frontier Crew Cab

1 Answer

1998 nissian fontier se 3.3L p0734 wont shift from


Check your fluid level.

But most likley you have to have the shift solenoid replaced.

Sep 11, 2009 | 1998 Nissan Frontier

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

723 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...