Question about 2001 Chevrolet Tracker

Open Question

Egr clicking after tracker is shut off. Stops when ignition is turned on.

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
8880u81
  • 3103 Answers

SOURCE: 2003 Chevrolet Tracker Clicking sound

put a different relay in and see if it stops..

Posted on Dec 23, 2013

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Chevrolet Tracker Clicking sound


put a different relay in and see if it stops..

Dec 22, 2013 | 2003 Chevrolet Tracker

2 Answers

Car cranks over and fires wants to start but will not


with zero history (egr valve stuck open is #1 stalls reason ) clean it.
did car run perfect last month or 10 years ago?
1: compression at 170 PSI? x4 , wide open throttle, no? all are low , then timing belt slipped, not doing the 60,000 mile service caused.
2: weak or bad spark to 1 or more cylinders, the 60k , again cures that.
3: under fueling or over fueling (flooding)
read the spark plugs to see if its dry or flooding.

Mar 08, 2013 | 1997 Geo Tracker 2 Door

1 Answer

Motor turn 3000 when it's cold, when it's warm he turns low at 1500 an than up again at 3000, again an again.


I've been trouble shooting this on my tracker as well and have got the problem solved for the most case. I had a loose vacuum line on the electrical valves on the left had side of the engine in the front looking from the front. I also replaced my head gasket and discovered the EGR system was completely stopped up in the intake manifold, exhaust manifold and the EGR valve. It has gotten better since then but still revs high at the beginning for about three seconds then comes back to normal and stays there. Hope this helps

Jan 29, 2011 | 1994 Geo Tracker

1 Answer

I have a 1996 Geo Tracker with 68,000 miles. The problem is that it won't shut off. Turn the key off and take it out of the ignition switch and the warning lights come on and the engine continues to run. I...


sounds like your igniction needs to be replaced....also there is a form included
Dallas Geo Tracker Club.

maby someone else can give you insite but it sounds like the igniction is screwd up

Dec 09, 2010 | Geo Tracker Cars & Trucks

1 Answer

I have a 1996 geo tracker that the code reader says has an EGR valve problem. I have read about the cleaning the out the port? going to it. Is it possible or likely that this port? fouling is really the...


Had same problem and cleaning out port where the exhaust tube enters the intake solved the problem. This tube runs from near the EGR valve up to the intake. Two 10mm bolts on each end. Simple fix and cost is only time. 15min.

Nov 26, 2010 | 1996 Geo Tracker 2 Door

1 Answer

My chevrolet tracker is cutting off while driving and I have wait about 15 minutes before it starts


next time it stops,just take the fuel cap off briefly,then see if it will restart.removing the cap,lets air in,in case the fuel tank is not being vented,creating a vacuum,when motor uses fuel.if that doesnt work,try another ignition coil

Jul 09, 2010 | 2001 Chevrolet Tracker

2 Answers

1994 toyota camry shut off while driving or slow down


What you're describing can be caused by any number of things. However, sometimes, on that generation of Camry, a similar problem is caused by a malfunction in the EGR valve. If the EGR valve opens when it shouldn't, or if it stays open when it should close, it will kill the engine. You can try disconnecting the vacuum hose that actuates the EGR. (Plug the hose so junk doesn't get sucked in). This will disable the EGR from opening. Or, you can disconnect the EGR Vacuum Switching Valve from its electrical harness. This will also inhibit the EGR. If either one of these two "fixes" prevents the problem from happening again, you'll know that it's an issue with the EGR valve.

Apr 18, 2010 | 1994 Toyota Camry

1 Answer

2000 chevy tracker egr gone bad what are opitons to fix


usually egr sensor goes bad sometimes tube best to use new parts old ones may not work andwork short time

Jul 06, 2009 | 2000 Chevrolet Tracker

2 Answers

98 Acura RL Mentainance Light will not reset.


WITH THE MILAGE RESET BUTTON ON DASH PUSHED IN TURN KEY ON CONTINUEING TO HOLD BUTTON IN UNTIL LIGHT SHUTS OFF RELEASE BUTTON.(ABOUT 5-10SEC)

Jun 20, 2009 | 1994 Buick Regal Gran Sport

1 Answer

Egr valve location


The EGR Valve Location is typically housed on the intake manifold this schematic may help you
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008822d

Mar 07, 2009 | 1996 Geo Tracker 2 Door

Not finding what you are looking for?
2001 Chevrolet Tracker Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...