Question about 2007 Honda Pilot

1 Answer

Programming a honda transponder key - 2007 Honda Pilot

Posted by Anonymous on

  • Anonymous Apr 27, 2017

    This is for remote keyless programing to open and close the doors and not to start your car which needs the transponder in the key to be programed. two separate thing.



1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 15 Answers

Did some quick research for you and found this easy and very clear step by step instructions on how to program your transponder car key to your vehicle.. this works for the following models though :

Accord 2003 to 2006

Civic 1999 to 2006

Element 2003 to 2006

Odyssey 1999 to 2006

Prelude1999 to 2001

Accord SE 1997

CR-V 1998 to 2006

Insight 2000 to 2006

Pilot 2002 to 2006

now here are the steps:

  1. Turn the ignition on
  2. Press Lock/Unlock within 4 seconds
  3. Turn ignition off and hen back on within 8 seconds
  4. Repeat steps 2-3 two times
  5. Press Lock/Unlock again within 4 seconds. The system should now lock and unlock the vehicle to indicate it is in programming mode.
  6. In the next 10 seconds: press Lock/Unlock button allowing the doors to lock/unlock once; then press lock/unlock button of each remaining key, allowing the doors to lock/unlock once.
  7. Switch ignition off and then remove the key

Civic 1996-1998

  1. Turn ignition on
  2. Press and hold the valet button which is situated on the radio within 5 seconds.
  3. System should now lock and unlock the vehicle indicating it is in the programming mode
  4. Within 5 seconds turn ignition OFF and press Lock/unlock on the remote fob to be programmed
  5. Within the next 10 seconds, press Lock or Unlock of any remaining keys, allowing the doors o lock or unlock once.
  6. Release valet key
  7. Switch ignition off and then remove the key

Radio remotes 2 and 3 button types

  1. Switch ignition on and repeat for 3 times.
  2. Press he lock button, switch the ignition off and back on and then press lock button again.
  3. System should now lock or unlock
  4. Press the lock button of all remotes to be coded. The car should acknowledge this by locking/unlocking each time
  5. Switch ignition off to exit the programming mode.

If you will have any further doubts or question to ask i suggest you to check out the page where i found this which is :) i hope this was the solution you were looking for mate! happy happy new year!

Posted on Jan 02, 2013


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 13 Answers

SOURCE: How to make a duplicate Honda Odyssey 2001

get the vin number and take it into the dealer and ask for key codes to cut a new one . have title and id

Posted on Dec 21, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My remote transponder key starts the car but does not open the door or lock it remotely even with a new battery.

Remote starts are not a factory option. None do it. Dealers will. But it is all aftermarket. I have taken out hundreds of them. I refuse to install them.

Apr 04, 2016 | 2010 Honda Civic LX

1 Answer

My 2007 honda accord has igination key problem,i remove the remote and weld a washer to the key. Now the car could not start,please what may be the problem and how will i fix it

Keys are fitted with transponders that are recognised by the car and allow the engine to start. If you have a key without a recognised transponder then even if the key will turn in the lock, the car will not start. You may have possibly damaged or even destroyed the transponder when you welded the washer to the key.

Jul 10, 2015 | Honda Cars & Trucks

1 Answer

How toprogramm car key toyota matrix

  • 1 First you will need to purchase a blank Toyota transponder key. You can do this from the dealership, a locksmith, or an online source such as eBay. Once you have the key, take the blank key and the master key to a locksmith that he or she can duplicate the key. This will be much cheaper than the dealership.
  • 2 Now that you have the newly cut key and the master key, you can program the Toyota transponder key. Sit in the driver's side of the Toyota vehicle. Press and release the brake and gas pedal simultaneously.
  • 3 Insert the master transponder key. Do not turn it. Push and release the gas pedal 5 times within at least 15 seconds of inserting the master key.
  • 4 Press and release the brake pedal 6 times within 20 seconds of completing step 3, then remove the master transponder key.
  • 5 Insert the newly cut transponder key into the ignition, but do not turn. Press the gas pedal once.
  • 6 Wait up to 2 minutes or whenever the security light on the dashboard turns off. Once the light goes off, remove the new transponder key and press the brake pedal once. The new transponder key should now be programmed. Test the key by attempting to start the engine. If the engine does not start, repeat the steps above.
  • Mar 02, 2015 | 2010 Toyota Matrix

    1 Answer

    2000 expedition programmed transponder programmed now key won't work

    Is the key worn down or the streering wheel the transponder your fob

    Feb 11, 2015 | 2000 Ford Expedition

    2 Answers

    2001 honda accord keys were stolen and the thief broke into my car. Do I need to totally rekey or can I just reprogram the transponder and have the doors not work with the old key?

    Hello Sophie,

    FIRST OFF ...
    >> I would ALWAYS choose a LOCKSMITH
    over a DEALER regardless of cost (strong opinion).

    Very sorry to hear of your violation...
    It never feels the same but now you are SAFER with the
    knowledge ... you were never actualy safe.

    If other than your CAR keys were ALSO taken...
    YOU NEED TO FOCUS on those other KEYS
    FIRST (particularly house & mail-box)

    Truth is...
    your car is never ANY safer than the GLASS IN THE Door
    (and only we... the owners... care about that GLASS).

    Car TRANSPONDER locks are another situation.

    If you use a LOCKSMITH it will be cheaper & safer.

    I have used eBay to get my new KEY and KEYLESS
    entry fobs... AND ... would TRUST a LOCKSMITH worlds
    better & longer than I could throw a DEALERSHIP...!!

    My niece had her car UNLOCKED and her HIGH-END
    sound equipment expertly removed THE NIGHT
    following getting her HONDA serviced at
    She nor I FEEL it was a coincidence (opinions)...

    LOCKSMITHS trade on their excellent REPUTATION
    and do the SAME work for half (or less) the COST.

    2001 HONDA ACCORD 3 0L V6 Ignition Lock Cylinder RockAuto

    REMEMBER to ask them the ERASE/OVERWRITE the
    old keys & FOBs.

    The locksmiths MIGHT know how to RE-KEY your existing cylinders (I think un-necessary)...
    Dealers probably (opinon/experience) won't even TRY...

    and of course...
    NEVER leave anything of value in your car!!

    2 Replacement for 1998 2002 Honda Accord Key Fob Remote KOBUTAH2T eBay

    OEM transponder keys

    If you are serious about this comment me back... I'll pull
    your owners manual and look for your capabilities.....
    you can do NOTHING YOURSELF.

    ManualsLib Makes it easy to find manuals online

    Carnac the Magnificent

    May 30, 2017 | 2001 Honda Accord

    1 Answer

    Does honda civic lx 2002 have a chip in the key? the black part of my key got broke but the key will turn the car on but wont actually start it

    Yes, it contains a transponder chip. If you still have the fob part with the chip in tape it to the plastic close to where you put the key in. Honda used a proximity transponder so as long as it is near by it will read it ok.

    Feb 12, 2012 | 2002 Honda Civic

    1 Answer

    How to reprogram a new key honda prelude 98

    The new key must be programmed using special procedures you can't do at home, you must alos have at least one working transponder key or the module must be replaced, about a $600 part.

    Feb 09, 2012 | Honda Cars & Trucks

    1 Answer

    2006 dodge charger transponder key stopped working. car wont start anymore. i can open and lock the doors fine but just cant get the car to start

    This means that the programming of the Transponder Key has been corrupted or the Programming data of the Key in ECU ( Electric Control Unit ) has been lost or not responding. You now have to get a new Transponder Key. You can get it on E-bay for $30. After you receive it, reprogram the car to the New Transponder Key to the ECU ( the process in usually given in the instruction manual or in the Service Manual ). Then the car will start perfectly.

    Sep 26, 2009 | 2006 Dodge Charger

    2 Answers

    Need spare key and transponder key for remote start universal byp

    you have to tow car to dealer - then they cut and program key - yes,it is a bit pricey!
    internet offers ways but will only work couple times - repos do same thing

    Jan 06, 2009 | 2007 Mitsubishi Eclipse

    Not finding what you are looking for?
    2007 Honda Pilot Logo

    1,694 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Honda Experts


    Level 3 Expert

    77499 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22306 Answers

    Kevin Daniels

    Level 3 Expert

    1455 Answers

    Are you a Honda Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides