Question about 2008 Nissan Note 1.5
Number plate lights off repaired wires but is there a fuse on car
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
the license plate because of its position gets a lot of dirt and water problems so i would go back and take another good look remove the bulbs again and see if you can clean the inside with a little sand paper or a little scrape with a small screwdriver then spray with a little sileacone oil replace bulbs.Then switch lights on they should be ok if not try moveing them slightly with your fingers they should light.please let me know how you get on.adrian
Posted on Feb 18, 2009
SOURCE: Nissan Narvara Lights problem
Check for a good ground. Remember, these vehicles have a LOT of plastic in them. Each light regardless of where it is almost always has its own ground wire. It's not like the old days when a car was made out of metal and the ground was "built in'.
If I remember right, Nissan has two ground wires on the battery; the large one normally seen on vehicles and a smaller one that is grounded to the body. That is where I would start. From there, I would check the ground around the fuse locations and work out to the light pigtails themselves. Use a good OHM meter to check continuity.
Hope this helps.....
Posted on May 03, 2009
Tips for a great answer:
Jan 24, 2016 | Cars & Trucks
Jan 05, 2016 | Suzuki Cars & Trucks
Dec 10, 2015 | Ford Cars & Trucks
Nov 11, 2015 | 2001 GMC Yukon Denali
Dec 06, 2013 | Nissan Quest Cars & Trucks
Dec 25, 2012 | 2003 Ford Escape
Apr 29, 2011 | 1997 Jaguar XJ6
Nov 02, 2009 | 2000 Ford Focus
Jun 07, 2009 | 2003 Mercedes-Benz E-Class
Mar 27, 2009 | 1996 Ford Escort 4 Door
Jun 18, 2014 | 2008 Nissan Note 1.5
838 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: