Question about Cars & Trucks
What is the cost for a clutch and fitting for vw golf plus year 2009.
Could be your clutch's slave cylinder,part is 166.00 at Autozone,Is your clutch's reservoir empty,if so then your slave cylinder is leaking and is bad.How does your clutch pedal feel,,not much or any pressure.
Posted on Dec 30, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
undo centre wheel hub nut 30mm/32mm, socket. undo lower wish-bone outer bolts, disconect battery,/remove starter motor,/remove transmission mounting bolts to body frame ,/ remove all surrounding bolts around bell housing transmission,/ remove clutch cable from transmission,/ remove drive shafts from centre hub and transmission,/ make sure car is standing on axle stands at front of jacking points,/use a trolley jack to suport engine sump with a piece of wood,/ slide transmission away from flywheel,/lower transmision on floor,/undo all clutch plate preasure bolts 10mm,/remove thrust bearing located on centre transmision shaft ,.also make sure if fitted speedo cable needs to be removed.new clutch plate should indicate flywheel ,without fitting clutch plate wrong way round/otherwise transmision will not bolt to engine block.,
Posted on Jul 23, 2009
SOURCE: 95 VW Golf, Clutch cable tricks
look above the clutch cable the is a rubber boot, abot 8-10 inches long. If u notice on either end of this boot are rubber prongs, or ears or whatever u wanna call em. Compress the cable by hand trying to bring these rubber ears as close to each other as possible. Once this is done, use a wire and wrap the wire around both ears as this will prevent the cable from decompressing. Might have to compress it by the pedal itself, but should be able to do it by hand. When u wrap the wire, do it in a figure 8 fashion because u have to get all 4 rubber ears otherwise the cable will decompress on one side.
Posted on Nov 13, 2008
there is a fan resistor which controls the speed of the fan,which is probably burnt out,should be located near the fan motor,behind glove box.
Posted on Oct 13, 2009
If you're asking this question, I two assumptions 1) that it's your first time because clutch replacement procedure is generally the same as any make of vehicle. It requires allen and 12pt bits (spline drive) so you can remove the starter, bell housing, CV joints and specially a 30mm x 6pt x 1/2 deep socket. A 1/2" drive torque wrench is needed as well to torque everything down to spec. If this doesn't deter you from doing it yourself then a public library usually has Clymers or Chilton service manuals for most vehicles available for reference. So my other assumption is you don't have a manual and need free information. Good luck and always let Safety be a priority.
Posted on Apr 08, 2010
Tips for a great answer:
Oct 04, 2012 | 1997 Volkswagen Golf
May 09, 2011 | Volkswagen Golf Cars & Trucks
Mar 02, 2011 | 2004 Volkswagen Golf
Dec 19, 2010 | 2000 Volkswagen Golf
Jul 02, 2010 | 2001 Volkswagen Jetta TDI
May 16, 2010 | 1996 Volkswagen Golf
Aug 27, 2009 | 1999 Volkswagen Golf
Aug 14, 2009 | 1999 Volkswagen Golf
151 people viewed this question
Usually answered in minutes!