Question about 1999 Pontiac Bonneville

Open Question

Location of blower motor resistor on a 99 pontiac bonneville?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75051 Answers

SOURCE: Where is the blower resistor located on a 2008

The blower control module also known as the blower motor resistor is on the passenger side of the firewall in the engine compartment near the blower

05b686d.png

Posted on Nov 12, 2009

Testimonial: "Thank you! You saved me hours of searching under the dash for something that was under the hood! Thanks again. Bill"

cj2176
  • 520 Answers

SOURCE: 2005 Pontiac Bonneville hvac blower does not come on

Start by checking the blower resistor. It should be under the dash on the passenger side near the blower itself. You will need to remove the glove box to access it. It is a small plate that has only a few screws and a group of wires that go to a plug in the center. Unplug it and remove the screws. When you pull it out it should look like a series of small spring shaped coils. Most likely one or two of them will be burned up. Replace it in reverse order and your blower should start working again. If this is not the problem then test the fan motor itself. Hope this helps. Good luck.

Posted on Jul 26, 2009

ZJLimited
  • 17970 Answers

SOURCE: need location on blower motor resistor on 1994

58f261e.jpg

Fig. 1: The blower motor and fan assembly is mounted in the heater and A/C module, and is accessible from the engine compartment

GM Bonneville/Eighty Eight/LeSabre 1986-1999
Blower Motor - REMOVAL & INSTALLATION
(see Figures 1 and 2)

  1. Disconnect the negative battery cable.
  2. If necessary, tag and disconnect the number 2, 4 and 6 spark plug wires from the ignition coil and move the coil out of the way.
  3. For 1993-99 vehicles, remove the nuts and cross brace bar.
  4. Detach the electrical connections from the blower motor.
  5. Disconnect the cooling tube from the blower motor.
  6. Unfasten the screws securing the blower motor to the blower module assembly.
  7. Remove the blower motor and fan assembly from the module.
  8. If necessary, unfasten the nut attaching the fan to the blower motor shaft, then pull the fan from the blower motor.
68515cf.jpg

Fig. 2: You can disassemble the fan from the motor by removing the retaining nut


To install:
  1. If the fan was removed from the motor, position the fan on the shaft, then install the retaining nut. Tighten the nut to 12 inch lbs. (1.4 Nm).
  2. Position the blower motor and fan assembly to the module, then install the retaining screws. Tighten to 5 inch lbs. (0.6 Nm).
  3. Connect the cooling tube to the blower motor.
  4. Attach the electrical connector to the blower motor.
  5. On 1993-98 vehicles, install the cross brace bar and retaining nuts. Tighten the nuts to 18 ft. lbs. (25 Nm).
  6. If removed, install the coil and connect the spark plug wires, as tagged during removal.
  7. Connect the negative battery cable.

Hope this helped (remember rated and comment this).

Posted on Mar 26, 2010

ftw1952
  • 10319 Answers

SOURCE: i need the location of the blower motor resistor

On the top of the A/C/ Blower motor evaporater box. You will see two screws holding it in with 4 wires going to it

Posted on Apr 26, 2010

jsmes1027
  • 749 Answers

SOURCE: 2001 Grand Prix: Is the blower motor resistor on a Pontiac 2001 Gra...

It is behind and underneath the glove box back by the firewall. No need to pull out the glovebox.You may need to pull the carpet back to get to one of the bolts.

Posted on May 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the heater blower resister located on a 2004 bonneville gxp


Why ? Does the blower work on high ? but no other speeds ! If it doesn't come on at any speed it's not the resistor . Does the vehicle have automatic climate control or manual ? Automatic doesn't have resistor , has a blower motor control processor . HVAC Blower Motor Circuit You need to test , not guess !

Feb 04, 2017 | 2004 Pontiac Bonneville

1 Answer

Heater stops working. it comes on and off..


Here's a link to the blower motor resistor,these resistors control the blower motor speed,when they go out,they won't work or work on 1 or 2 speeds,autozone will take back if it doesn't solve problem.Easy to remove,they are located by blower motor,just remove electrical connector and 2 screws.Here's where the blower motor is.Here's the blower motor relay.

Dec 23, 2012 | 1998 Pontiac Bonneville

1 Answer

I need the location of the blower motor resistor on a 98 bonneville


On the top of the A/C/ Blower motor evaporater box. You will see two screws holding it in with 4 wires going to it

Apr 26, 2010 | 1998 Pontiac Bonneville

1 Answer

1992 bonneville sse w/ac replaced blower motor +


You replaced the blower control module or the blower control panel on the dash? This has automatic temp control right?

Mar 31, 2010 | 1992 Pontiac Bonneville

1 Answer

Need location on blower motor resistor on 1994 pontiac bonneville


58f261e.jpg

Fig. 1: The blower motor and fan assembly is mounted in the heater and A/C module, and is accessible from the engine compartment

GM Bonneville/Eighty Eight/LeSabre 1986-1999
Blower Motor - REMOVAL & INSTALLATION
(see Figures 1 and 2)
  1. Disconnect the negative battery cable.
  2. If necessary, tag and disconnect the number 2, 4 and 6 spark plug wires from the ignition coil and move the coil out of the way.
  3. For 1993-99 vehicles, remove the nuts and cross brace bar.
  4. Detach the electrical connections from the blower motor.
  5. Disconnect the cooling tube from the blower motor.
  6. Unfasten the screws securing the blower motor to the blower module assembly.
  7. Remove the blower motor and fan assembly from the module.
  8. If necessary, unfasten the nut attaching the fan to the blower motor shaft, then pull the fan from the blower motor.
68515cf.jpg

Fig. 2: You can disassemble the fan from the motor by removing the retaining nut


To install:
  1. If the fan was removed from the motor, position the fan on the shaft, then install the retaining nut. Tighten the nut to 12 inch lbs. (1.4 Nm).
  2. Position the blower motor and fan assembly to the module, then install the retaining screws. Tighten to 5 inch lbs. (0.6 Nm).
  3. Connect the cooling tube to the blower motor.
  4. Attach the electrical connector to the blower motor.
  5. On 1993-98 vehicles, install the cross brace bar and retaining nuts. Tighten the nuts to 18 ft. lbs. (25 Nm).
  6. If removed, install the coil and connect the spark plug wires, as tagged during removal.
  7. Connect the negative battery cable.

Hope this helped (remember rated and comment this).

Mar 26, 2010 | 1994 Pontiac Bonneville

1 Answer

How do i replace blower motor resister, where is it located on 1994 bonneville


The blower resistor is under the hood on the passenger side right on top the a/c box that is bolted
to the firewall.

Feb 01, 2010 | 1994 Pontiac Bonneville

1 Answer

Where is the blower resistor located on a 2008


The blower control module also known as the blower motor resistor is on the passenger side of the firewall in the engine compartment near the blower

05b686d.png

Nov 12, 2009 | 1998 Pontiac Bonneville

2 Answers

I'm looking for the location of the resistor on the blower motor of a 99 pontiac grand prix


If it is the same as a 2002 Grand Prix the resistor is located on the firewall behind the blower motor up under the glove box. You need to remove the blower motor to get to it.

Mar 12, 2009 | 1999 Pontiac Grand Prix

Not finding what you are looking for?
1999 Pontiac Bonneville Logo

Related Topics:

194 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...