Question about 2001 Dodge Ram 1500 Truck 2WD

Open Question

2001 dodge ram 1500 transmission cilanoy weres it at

Took the truck to the auto stor, and they sayed i have a bad transmission cilanoy. but they didnt know where it was at! where is it?

Posted by on

  • mek16 May 11, 2010

    transmission pressure solenoid is under the pan on passenger side of valve body about 100 bucks the pressure switch is there to its about 40 bucks. dont know if this helps

  • Rob McFarlane May 11, 2010

    I'm assuming you are refering to the transmission solenoid. Depending on the model there are several different solenoids, all of which are internal transmission parts and require at the least the trans pan be removed for replacement. My recommendation is that a qualified trans tech properly diagnose and repair the issue.

    Good luck, hope this helps some.

×

6 Suggested Answers

emissionwiz
  • 61292 Answers

SOURCE: 1997 Dodge Ram 1500 transmission will a 1996 interchange

No, the frame is different.

Posted on Nov 30, 2008


  • 512 Answers

SOURCE: 2001 dodge ram 1500 v8 spark plug wire diagram

the firing order is 1 8 4 3 6 5 7 2 clockwise around the cap

Posted on Jan 03, 2009

Monster80
  • 452 Answers

SOURCE: 99 dodge ram 1500 4x4 5.9l tranny problems

Take a look at the down shift cable and make sure its not broken especially were it connects to the throttle linkage.And maybe try cleaning the electrical plug that plugs into the trans.Its about a 7 to 9 wire plug.They tend to collect water and short the wiring out.

Posted on Mar 31, 2009

greg_margo
  • 1959 Answers

SOURCE: firing order for dodge 2001 ram van 1500,

Here you go:
5.2L and 5.9L engines Firing order: 1–8–4–3–6–5–7–2 Distributor rotation: Clockwise

Diagram link below:

http://www.chiltonlibrary.com/content/images/7924/images/79243g14.gif

Best of luck!
Greg

Posted on Jun 14, 2009

  • 593 Answers

SOURCE: Remove headlight assembly from a 2001 Dodge Ram

On the upper grill side of the headlight assy. there
should be 1 or 2 push pins that hold the seal on the
headlight assy to the front of the fender. Also check
for a guide/push pin on the inner top of the assy on
the outer fender side. That should be all there is to
hold the headlight in place. Hope this helps.

Posted on Apr 10, 2010

  • 1 Answer

SOURCE: 2001 Dodge Ram 1500; how to reset computer after replacing dead battery

how do u reset after replaceing fuel pump to get radio and things back to work man told us we couldnt reset because fuel pump was bad

Posted on Aug 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission solenoid


I think that you have been getting the "bums rush" from the transmission rebuilder.. There is always oil in the gears as there is oil continuously being splashed around so burning gears is out unless you have a band /clutch slipping problem. Always run the fault codes to see if there are electronic problems and have a pressure test done to check for internal mechanical problems I advise that you find an accredited auto transmission shop that repairs your transmission and get a second opinion before you spend another dollar.

Apr 06, 2014 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

2001 dodge ram 1500 this morning the idle didnt work. truck starts but dies the second i let off the gas


your idle air control valve is gummed up. Remove and clean with spray carb cleaner and also clean the bore it came out of.

Sep 08, 2010 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

How does the brake booster work on a 2001 Dodge


Did you brake into the hydraulic system at any point? If so them Moose had the answer. Did you crank the truck in park and then push on the pedals so the brake assist booster can do its job? Check the level of fluid at the brake resevoir. A low level should be cause for a refill. Did you leave any brake bleeder valves open? I assume it was the fron disc that were reaplced. If so hopefully it hasn't blown a brake caliper . If so replacement or rebuild will be the answer. You have definitely lost pressure so look for looks on the inside of all wheels. Also try cranking your truck and then pump the brakes to allow the brake assist to lend a hand and do its job.

May 29, 2010 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Where do i locate the speed sensor on my 2001/2002 dodge ram 1500 4x4 truck


I didnt get an answer here, so I kept looking and found it for myself on autozone.com

Feb 08, 2010 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

I have a 1999 Dodge Ram 1500 3.9 V6 standard [hard to sart]


There is a safty switch on the clutch pedal arm that you need to adjust.

Dec 14, 2009 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

My 2001 dodge ram 1500 with 5.2L sometimes slips in overdrive. what could be causing it


Assuming its an automatic. Check the Transmission fluid first and foremost. Follow the instructions on the dip stick. If the fluid turns out alright then sorry to say but the clutch plates inside the transmission are going out. Transmission fluid could smell burnt. I had a 2000 ram and at 82000 miles thats when it started doing the same thing. I drove it til it wouldn't move forward or back.

Nov 24, 2009 | 2001 Dodge Ram 1500 Truck 2WD

3 Answers

2001 dodge ram 1500 5.9 camshaft position sensor location?


CAMSHAFT POSITION SENSOR 2001 Dodge Truck RAM 1500 1/2 ton 2WD 5.9L SFI 8cyl The Camshaft Position Sensor is located: Under hood, center, upper engine area, rear of intake manifold, mounted in distributor

If this is helpful.Please leave ositive Feedback. Thanks, SnugglePants

Oct 21, 2009 | 2001 Dodge Ram 1500 Truck 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...