Question about Cars & Trucks

1 Answer

My go gear mp3 has turned off due to low battery and wont start and respond to my computer

It has turned off due to low battery and is not responding to my computer... i did try reset but it did not work

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 14 Answers

Allow to charge for at least 8 hrs and repeat

Posted on Dec 30, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 14036 Answers

SOURCE: 97 chevy camaro wont start *security light it's on*

power locks check fuse and relay.take car to dearlership.they have to check your theft deterrent module.when its in security mode.your problem could be it cant read the chip on ignition keys or the theft deterrent module is failing.not a home fix.

Posted on Jun 22, 2009

SOURCE: Smart for two X on dash, locks not responding.

Most probably you have a synchronization problem between key and the car.As signal is received since the signals are flashing , but security is not responding.
First , if you have a spare key , try it and see if that works. If not you need to reprogram the keys again. You can do that at any authorized Smart service center and it should not take much time to do it. Good luck

Posted on Oct 22, 2009

  • 2448 Answers

SOURCE: My 2005 F-250 is stuck

This sounds like a simple shift cable adjustment Your in 2 wheel but its telling you your in 4 wheel low all the time If this is correct the problem is at the shift lever inside the truck or at the transfure case its an adjustment of the cable

Posted on Nov 09, 2010

  • 328 Answers

SOURCE: Fuel pump is not responding.

you have to replace the pump itself

Posted on May 29, 2011

  • 1 Answer

SOURCE: d4 light on wont start

Hi dipu

Posted on Mar 02, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Plow responds slowly when lifting or angleing?


How cold is It.?? Serious. Or possibly battery is low. Does it respond better, the more you use it? Is fluid where it should be.?

Mar 04, 2015 | Cars & Trucks

2 Answers

1999 grand marquis engine runs but car wont move


I am sorry but you have a failed automatic transmission. You will needit removed and rebuilt.

Oct 16, 2012 | 1999 Mercury Grand Marquis

1 Answer

Is there a list for computer codes for 1980-1990's Chrysler Le Baron


Yes here is that list.
Chrysler products COMMON CODES OBD1 (vehicles made before 1995)
Part 1: Chrysler Domestic vehicles
CODES/Meaning
88 display used for start or test
11 camshaft signal or ignition signal, no reference signal during cranking
12 memory to controller has been cleared within 50-100 engine starts
13 map sensor not detecting any change during test
14 map voltage too high or too low
15 vehicle speed sensor, no signal detected
16 knock sensor circuit. open or short detected
17 low engine temperature, possible thermostat fault
21 oxygen sensor signal, neither rich or lean detected
22 coolant sensor voltage low
23 air charge voltage high/low detected
24 throttle positioner sensor voltage high/low
25 automatic idle speed motor driver circuit, short or open detected
26 injectors 1,2,3 peak current not reached
27 injector control circuit does not respond to control signal
31 purge solenoid circuit, open or short detected
32 egr solenoid circuit, open or short detected
33 a/c clutch relay circuit, open or short detected
34 speed control servo solenoid, open or short detected
35 radiator fan control relay circuit, open or short detected
36 wastegate solenoid, open or short detected
37 part throttle unlock(PTU) circuit, open or short detected
41 charging system circuit not responding to control signal
42 fuel pump or auto shutdown (ASD) relay voltage sensed at controller
43 ignition control circuit not responding
44 battery temperature voltage circuit problem
45 turbo boost limit exceeded-map sensor detects overboost
46 battery voltage too high
47 battery voltage too low
51 air/fuel at limit
52 logic module fault
53 internal controller failure
54 camshaft reference circuit not detected
55 end of message
61 baro read solenoid, open or short detected
62 emr mileage not stored
63 eeprom write denied
64 flex fuel sensor signal out of range
65 manifold tuning valve, open or short detected
66 no ccd messages
76 ballast bypass relay, open or short detected
77 speed control relay, open or short detected

May 31, 2011 | Chrysler LeBaron Cars & Trucks

1 Answer

Oldsmobile cutlass 1993 Wont engage when engine cold.


Check your transmission fluid level You will need to top it up if low. Low fluids mean that not only will the transmission be slow to respond but when it engages gear it does so with a bit of thump. If the fluid stays low this thumping of the gear changes will eventually shear off the input shaft. Also check the linkage located from beneath the gear shift to the transmission casing and adjust it if necessary. My guess is that topping up the transmission fluid to its proper levels will solve the problem without need for any adjustment

Apr 29, 2010 | 1993 Oldsmobile Cutlass Ciera

1 Answer

Suzuki sidekick transmission - wont go into drive gear until warm


I have the same issue - the car cold will not shift out of first until the trans fluids are warmed for about 5 to 10 min. did anyone respond to your question?
Bill
RGRDonovan@aol.com

Nov 16, 2009 | 1992 Suzuki Sidekick

1 Answer

When shift to drive the car wont respond. on 1 2 or reverse it responds normal


check the trans fluid,this happens when the fluid is very low, only goes in reverse,i had the same with my car,low trans fluid, PLEASE ADD NOW BUT CHECK FIRST IF IT IS LOW????

Oct 30, 2009 | 1997 Chevrolet Lumina

2 Answers

Van wont start


Hello Sir,

as u say, the problem symtoms are those when there is battery problem, maybe its low.

or else, whenever if u have locked ur car with the remote control center locking system n then opened the door with with the tradition keys, then ur car wont respond to any of ur keys untill u unlock it using the remote.


I am sure the problem lies with the battery.

or maximum there will be a wire loose connection.


thank u sir, if u feel my solution is worth reading then plz vote m/ rate me.

thank u sir

Jul 18, 2009 | 1997 Volkswagen Eurovan

1 Answer

When driving (auto) in 2nd gear car jurks


If the transmission fluid was VERY low, the damage may already be done. I know on alot of Rav-4's, there is a computer problem, that causes transmission problems. basically, it wants to shift into 2 gears at once, and will eventually make the transmission come apart. BUT, it has to be replaced WITH the ECU because it will just break the new transmission. I would take it to your local Toyota dealer and have them check the ECM and transmission.

Feb 14, 2009 | 2002 Toyota RAV4

1 Answer

1991 gmc sierra wont start


There are so many things that could have caused this problem to occur. Here are some of my suggestions:

1. Blockage in the air supply to mix with the fuel. Throttle body might need cleaning

2. Compression in the cylinders might be low, probably due to large ring gaps. If you can get your hands on a compression tester to check the compression values of each cylinder, so as to ensure they are in operable range. By the way, was the vehicle smoking heavily when in operation?

3. Is your battery giving a good turn over of the engine? A weak battery can cause an engine not to start. The engine would turn over but just won't start. (Is the engine turning over when you try starting, or does the engine not responding when turning the key?)

4. Igniter in the distributor might need electrical checks to ensure proper electrical circuitry. Liaise with an auto-electrican about this.

Dec 29, 2008 | 1992 Oldsmobile Bravada

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...