Question about 1999 Ford Taurus

1 Answer

Blower only works on high doesn't go to low or medium

Replaced switch and blower still having this problem

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 962 Answers

Replace resistor in between the blower motor and the wiring. It is a small gadget not an electronic resistor as in TV resistor.

Posted on Jan 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2010 Dodge Avenger the blower was only working on the to low and medium prop mob up with penny work for a while to penny fell out won't work now


2009 dodge avenger blower motor works on low, medium ...

www.fixya.com/.../t21143783-2009_dodge_avenger_blower_motor_wo...
Nov 2, 2013 - 2009 dodge avenger blower motor works on low, medium low,medium high but not high. Resister has ... SOURCE: Dodge 2001 Stratus - A/C fanonly blows on High ... working. Jan 04, 2010 ' 2003 Dodge Durango · 1 Answer ...

Oct 29, 2015 | Dodge Cars & Trucks

1 Answer

1992 chevy C1500: Heat works on low speed, no medium, and high only works intermittantly.


On any other vehicle it sounds like the blower fan switch.
The fan switch provides power or ground to the resistor and there would be a high speed blower relay to bypass the resistor.
But in your case the fan switch is part of the controller.
I don't have a diagram for a 92 but the 94 model shows relays for low medium and high speeds. Each relay gets power from a fuseable link. The high relay gets power thru the low relay if the low relay is not engaged.
If you have the model with 3 relays you may need to check them.

Feb 01, 2013 | 1992 Chevrolet C1500

1 Answer

Blower motor only works on low and medium on 2007 dodge nitro


You replaced the resistor and WHAT relay? The blower motor circuit on a 2007 Dodge Nitro does not use a relay.

The blower resistor gets it's power from the A/C - heater control unit.

If you check for voltage at the blower motor resistor connector (Key on, relay disconnected), the DARK BLUE/GREY wire should be hot when the control switch is on HIGH. The DARK BLUE/VIOLET wire should be hot with the switch in the MEDIUM 2 position.The DARK BLUE/ORANGE wire should be hot with the switch in the MEDIUM 1 position. The DARK BLUE/BROWN wire should be hot with the switch on LOW.

If any of these are not as stated above, then you either have a bad A/C - heater control unit, or faulty wiring between the control unit and the resistor.

Jun 02, 2012 | 2007 Dodge Nitro R/T New Cars

1 Answer

I have a 1992 chevy lumina that only the high on the heater control works. i have replaced the control panel the blower module checked the blower motor still only works on high.


either the switch or there is a resistor pack in the heater duct that gets burned out and only 1 side works if it is not the high medium low switch check resistor pack mounted in the heater duct.

Jun 23, 2010 | 1992 Chevrolet Lumina

1 Answer

I have high speed blower but no medium or low


It's likely a relay. I've often seen where the lower settings are ran through one relay and the higher setting ran through another because of the difference in amperage. I'd start there, the relays are often pretty cheap and a lot easier to replace than tearing the dash apart to change the switch.

Oct 09, 2009 | 2003 Ford Taurus

2 Answers

Why does blower fan speed switch lock-out off and low speed positions on 1998 chevy silverado? It stopped working altogether then I replaced a 10 amp fuse and now only medium high and high will work but,...


Sounds like you may have a bad blower motor resistor.  When they go bad, they usually wipe out all speeds except high.  But could knock out just one or two of the speeds.  It should be located near the blower motor.

Sep 10, 2009 | 1998 Chevrolet K1500

1 Answer

Ac blower fan problems


change the blower resister module,if this doesnt work replace the control head

Jul 05, 2009 | 2000 Dodge Ram 3500

1 Answer

AC comes on in low to medium but shuts off on high.


It could possibly be the switch. Many automotive a/c blowers have a relay to engage the highest fan speed because the high current required will necessitate the use of heavy wiring to and from the blower motor and a heavy duty switch. Check for a high-speed relay and also there might be a circuit breaker in the blower system.

Hope this helps, rhais

Jun 28, 2009 | 2002 Dodge Durango

Not finding what you are looking for?
1999 Ford Taurus Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...