Question about 2002 Volkswagen Jetta TDI
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
you should have an h7 bulb, once to take the rubber grommet behind the headlight, you will see the h7 socket, which has to wires in it, gently pull thi socket off, then there is a small wire holding the bulb in place, gently unhook the wire from the one side. and turn it to the other side and the bulb shoudl come out... replace the bulb putting it in the same way the other bulb came out.. notice the h7 bulb has a small notch on one side. it has to go in the same way or the wire will not hook back on. once it has been placed, turn the wire over the base of the bulb and hook it again, then put the socket back on the bulb and put the grommet back on the headlight.
Posted on May 03, 2010
Although you posted this question under a 03 VW Golf and you have a MKV. The best I can do is a MKIV set up. From the rear trunk there are access ports just for this job. The right port will be just above the light housing you will find a wire harness for the right assembly. Follow the harness and it will lead you to the assembly. Once located you can squeeze the two tabs and pull the circuit board where the bulbs are installed. Push on the bulb and twist anti-clockwise then pull out of the socket.
The left should be the same procedure and it is located behind your audio components.
NOTE: It's a good idea to wipe your hand and the glass bulb, leaving oily residue will cause early bulb failure once in operation.
Posted on May 30, 2010
Tips for a great answer:
Jan 01, 2017 | 2008 Toyota Highlander
Aug 09, 2016 | Cars & Trucks
Apr 04, 2011 | Hyundai Santa Fe Cars & Trucks
Jan 27, 2011 | 2000 Volkswagen Beetle
process for replacing tail light bulbs is the same in all models. If
you have a burnt-out tail light bulb, you may need to replace the
brake light, the reverse light or the turn signal. The procedure to
replace each of the bulbs is the same.
1. Open the Hummer's rear swing gate. This will expose the edge of the vehicle's tail light assembly. You'll see two small Phillips head screws that hold the tail light assembly in place. Put on your gloves.
Remove the two screws from the tail light assembly. Pull the tail
light out and inspect the back for two bulbs. The top bulb is the
brake light and turn signal. The bottom bulb is the reverse bulb.
Determine which bulb you need to replace.
the tail light into its cradle. Hold it with one hand and replace
the Phillips head screws with the other.
Dec 03, 2010 | 2008 Hummer H3
May 30, 2010 | 2003 Volkswagen Golf
Jun 12, 2009 | 2007 Hyundai Veracruz SE
Mar 21, 2009 | 2008 Honda Ridgeline
303 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: