Question about Cars & Trucks

Open Question

How to reset engine management light Renault 1.9d kangoo

Light stayed on after running vehicle with egr disconnected ie doing tests

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 345 Answers

SOURCE: location of crank sensor on renault megane 1.6, 2004

bit confused...the cranksensor will be on the gearbox housing the camsensor will be near the cams not the gearbox if the camsensor has packed up it wont start but if it packs up while driving the engine will run untill you stop it then it wont start,a cranksensor could cause the engine to stop at anytime if it fails..your problem could be the idle air control valve or a timing related issue..

Posted on Dec 31, 2008

  • 1 Answer

SOURCE: renault kangoo 1.9 d immobiliser probims.{2001} model.

hold the central locking button down on the centre consul inside the van for more than 5 seconds the doors should lock Then unlock,then press the key fob within ten seconds the doors will lock and unlock again this will re- program the key code

good luck jk

Posted on Feb 05, 2009

  • 132 Answers

SOURCE: How do you reses the check engine light?

If you bring it back to the mechanic who last serviced it he will gladly reset it free of charge.

Posted on Mar 26, 2009

  • 115 Answers

SOURCE: 2005 jeep grand cherokee limited 5.7 hemi vehicles hesitates

The egr valve is located on the front of the right cylinder head. It has a tube attached to it and going to the intake manifold.It has failed and is why your jeep is running rough and hesitating. Replace it and it will fix your driveabllity issues. Disconnect the battery for 2 min to clear the code.

Posted on Apr 02, 2009

  • 1 Answer

SOURCE: replace cv boot on a renault kangoo

Did one today, assuming drive shaft removed take off large clip from inner boot slide back joint socket comes away leaving the knuckle joint on the shaft remove 19mm circlip and tap knuckle off spline this allows outer boot to come back - easy enough. Not much tubber to secure new clip over boot though especially with all the grease.

Posted on Jun 10, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Kangoo automatic has power but will not start ie all ingition lights etc on but will not turn over just dead

have a load test done on the battery as this is symptomatic of a bad battery.

Feb 08, 2015 | 2003 Renault Kangoo

1 Answer

How can I sort glow plug light problem on Renault Kangoo 1.5Dci? Initially it extinguishes as it should after a few seconds. It comes on when accelerating, and if accelerating hard, seems to reduce po

This is a common problem with these vehicles, most likely to be a faulty rotor sensor on the fuel pump but can sometimes occur due to dirty connectors within the relays and related wiring. The rotor fix isn't a major deal.

Dec 01, 2014 | 2005 Renault Kangoo

1 Answer

Kangoo fuel gauge keeps on flashing

I think but sure without a play myself and that is you need a new head unit ,the back of the speedo unit is full of electronic gizmo ,well it is a renault after all

May 02, 2014 | 2007 Renault Kangoo 1.4

1 Answer

I have a renault kangoo 1.5 dci, 2005. The stop engine light flashes and the car wont start. No power at the injectors. Do i need to reset the chip key? If so how? There is no button on this key.

run the fault codes first to see if the immobiliser is at fault. IT could be a cam/ crank position sensor or a sensor that sets off the engine light to protect the engine and gear box.

Feb 18, 2014 | Renault Kangoo Cars & Trucks

1 Answer

What is a egr valve

It stands for 'Exhaust Gas Recirculation Valve', its all to do with emissions. but strangely enough they can be blocked off if they start playing up without affecting any performance. do a search on a renault forum and it'll tell u more about it.

Nov 18, 2012 | 2007 Renault Kangoo 1.6

2 Answers

Renalt Kangol battery leakage overnight

Here's a very useful site for Renault problems:-

and here's a solution that someone else found, which may help:-

Apr 28, 2011 | Renault Le Car Cars & Trucks

1 Answer

Renault kangoo 1.9 diesel glow plug light comes on when driving, power drops off but no smoke,show fault code p100d

p100d error code is due to fault in EGR Valve.The EGR valve shuts off to when 3000rpm is the EGR Valve needs to be checked and replaced. Thanks. you can rate this solution and show your appreciation.

May 19, 2010 | Renault Sport Cars & Trucks

2 Answers

Annoying Renault Kangoo electrical problems.

I have a Nissan Kubistar which I understand is the same vehicle as Renault Kangoo.
The key fob works perfectly well most of the time then everyone once and while, the key no longer unlocks the vehicle and then the indicators don't work. After some time, the key works again as do the indicators etc.
I have replaced the battery in the key fob but it doesn't seem to have made any difference.
Any suggestions??

Dec 03, 2009 | 2006 Renault Le Car

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

256 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides