Question about 2006 Nissan Titan

Open Question

Adjust door striker on driver side front door

Needs to be tighter to stop air leak and rattling on bumpy roads

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: Front driver door rattles and the door open light comes on

The door latch keeper probably needs adjusting.
This is in the door frame and it's the mechansim which holds the door when it's closed. There should be screws you can loosen to move the keeper in so the door latches more tightly.

Loosen screws, move the keeper in, tighten screws, try the door. If still not tight, move keeper in more.

Posted on May 12, 2009

Ad
  • 422 Answers

SOURCE: FRONT END RATTLE ON MILD BUMPY ROADS. NO

control arm bushings are probably bad. now pay me

Posted on Nov 20, 2009

  • 149 Answers

SOURCE: 1995 maxima 250,000 miles, making rattling noises

check your break pads, and calipa. check your wheel balancing and alignment

Posted on Mar 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you adjust the tail gate to stop the annoying rattle when driving?


Most rattles are due to the back door not closing tight enough. There is a lock/striker that the door lock assembly latches to. Usually the striker/latch is bolted to the rear floor/bumper area and the screws/bolts securing it can be loosened and the striker/latch moved forward and retightened which in turn will cause the door to be tighter stopping any rattles. You may also have a rattle inside the door assembly itself or loose paneling causing this issue

Sep 05, 2015 | 2008 Nissan X-Trail

1 Answer

2006 zephyr


go online to fixya.com they surly can help!

Jul 06, 2014 | 2006 Lincoln Zephyr

1 Answer

Rear Hatch Window won't stop rattling


apply some strong tape to the stricker adding a little at a time until all the excess play is gone

Jan 01, 2018 | 1985 Chevrolet S-10 Blazer

6 Answers

Doors where hard to close without the weather door seals. But with them on they will not close. The body plates more but not enuff on the cab? I need HELP.


Hi!!
The doors Hinges or Striker need to be adjusted to make up for the weatherstrip thickness. To do this, loosen the hinge-to-door bolts for lateral adjustment only. Loosen the hinge-to-body bolts for both lateral and vertical adjustment.
FRONT DOORS 1kbron_78.gif
REAR DOORS
1kbron_79.gif
BEFORE YOU START:
  • Determine which hinge bolts are to be loosened and back them out just enough to allow movement.
  • To move the door safely, use a padded pry bar. When the door is in the proper position, tighten the bolts to 19-25 ft. lbs. (26-35 Nm) and check the door operation. There should be no binding or interference when the door is closed and opened.
  • Door closing adjustment can also be affected by the position of the lock striker plate. Loosen the striker plate bolts and move the striker plate just enough to permit proper closing and locking of the door.
TO ADJUST ON A: F-150, F-250, Expedition and Navigator
HORIZONTAL AND VERTICAL ADJUSTMENT
  • Loosen the front door hinge to front door bolts.
  • Adjust the front door alignment.
  • Tighten the front door hinge to front door bolts to 19-25 ft. lbs. (26-35 Nm).

FRONT DOOR FORE AND AFT ADJUSTMENT Check the rear door hinge adjustment before adjusting the front door hinge.
  • Remove the front fender.
  • Loosen the front door hinge to body bolts.
  • Adjust the front door alignment to specification.
  • Tighten the front door hinge to body bolts.
  • Install the front fender.

1999-00 F-Super Duty Models
DOOR ADJUSTMENT The following procedure is for performing fore, aft, up, down and tilt adjustments.
  • Remove the door striker.
  • Loosen the bolts only enough to allow for slight door movement.
  • Carefully close and adjust the door until flush with the adjacent body panels.
  • Carefully open the door and tighten the bolts.
  • Re-install and adjust the door striker.
  • Check the door for proper operation and alignment.
STRIKER ADJUSTMENT Mark the position of the striker before loosening.
1kbron_48.jpg
  • Loosen the striker retaining bolts.
  • Adjust the door striker and tighten the striker retaining bolts.
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

Dec 09, 2010 | Ford F Cars & Trucks

1 Answer

The doors on my ford excursion rattle. how do I


You will have to loosen the striker and slide back, move back in small amounts until door is tight. also make sure its not something inside the door rattling before adjusting the striker.

Jul 20, 2010 | 2002 Ford Excursion

1 Answer

My Vue front end shakes when I go over RR or bumpy


Stop driving and have this checked out ASAP.

You have a worn, loose or broken track rod and/ or streering rack. Also the front suspension should also be checked just to be safe

Nov 04, 2009 | 2005 Saturn VUE

1 Answer

1997 camry rattling noise when driving over bumpy road also right front door hinge loose


Not a very detailed description, but assuming the rattle is in front it may be bad shocks. A quick test would be to push down hard on the left fron of the car and let go, if the car springs back up and just stays there the shock is fine but if it comes up and dips down once again the shock is bad, it should come straight back up and stay there. Repeat on the other side.
If it were a knocking noise it would possibly be a ball joint.
Hope this helps.
Sam

May 12, 2009 | 1997 Toyota Camry

1 Answer

When exiting highway 35-45 MPH right turn only,the interior lights come on and then go off when I resume driving straight


rkgaynor i recomend checking your drivers side front door latch adjustment-the striker on the B-pillar may need to be loosened and adjusted inwards which will make the door close tighter-sounds like at higher speeds your body may lean against the door and cause the door switch to illuminate the interior lights-before looseing the bolts i recomend tracing the striker with a pencil so if any large adjustments occur and door doesnt close or open properly you will know where the original position was and can change it back.

Mar 09, 2009 | 2003 Mercedes-Benz E-Class

1 Answer

Rattling Noise from Front Driver Side


yes this sounds like worn struts i had same prob with jeep and it was front struts

Nov 08, 2008 | 1999 Mazda Millenia

Not finding what you are looking for?
2006 Nissan Titan Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...