Question about 2004 Honda Civic

Open Question

ErrE code on 2004 Honda Civiv

I had to replace my battery on my 2004 Honda civic. I couldn't get the radio to come back on after trying a few codes. After trying several times I realized I had a card with the code on it but now it wont let me enter the code. The radio has ErrE displayed on it.....what do I do?

Posted by on

  • 1 more comment 
  • llynnls Jan 18, 2009

    I figured it out. To reset, disconnect the neg- terminal on the battery for about 30 seconds. The error should reset and you will be able to re-enter your code. Good Luck!

  • llynnls Jan 18, 2009

    To reset, disconnect the neg- terminal on the battery for about 30 seconds. The error should reset and you will be able to re-enter your code. Good Luck!

  • llynnls Jan 18, 2009

    This actually worked!!!!

×

6 Suggested Answers

pmalone41
  • 1 Answer

SOURCE: i need radio wiring diagram

I just installed a radio and speakers in my 1992 Civic LX (132323 miles). Most radios are removed by disassembling some of the dashboard components. On mine I had to remove the lower center console (where the ashtray/lighter is located) to access the rear of my old radio. There is a metal support strap back there which stabilizes the radio and provides equipment grounding. This has to be removed from the radio before you can un-install the radio. Also there may be a metal mounting sleeve around the radio, if so you must use (2) thin metal strips (or thin screwdrivers)to disengage the (2) side clips from the sleeve. You should then be able to remove your old radio.
As for wiring , I had to discard the wire harness the came from the old stereo and hard wire the new unit. I used a 12v circuit tester to find my (+) positive (typically red) and (-) negative (typically black) leads. Speaker wires are in pairs. (example: blue/white white/blue or white/white-black)

Posted on Nov 23, 2008

  • 496 Answers

SOURCE: Radio code

I think if you remove the radio fuse for a few seconds it will start the code required sequence over. This next part from Honda owner's manual for 2002: "When the radio shows "code" then enter the five digit code using the radio preset buttons. If you make a mistake, do not start over--complete the five digit sequence, then enter the correct code next try. You have ten tries to enter the correct code. If you are unsuccessful in ten attempts, you must then leave the system on for one hour before trying again."

Posted on Jan 11, 2009

raycrazek
  • 106 Answers

SOURCE: Got new battery for Honda Civic, radio shows "Enter C"? Help Plz!

call your nearest honda dealer and ask for the service department most of the time if your real nice they will look it up for you and tell you what to do and how to do it.. good luck ray

Posted on Jan 17, 2009

blueextc3221
  • 15935 Answers

SOURCE: Got new battery for Honda Civic, radio shows "Enter C"? Help Plz!

Options you have:

1 - Check your owners manual. Sometimes the code is written in there. It is a security code that locks the radio and renders it useless unless you enter the code to thwart thieves.

2 - Call Honda at 1-800-999-1009 and go to option #5.
The representative will ask you for your VIN # and some personal info like phone #, address and radio serial # (press 1, 6 and "on" button on your radio at the same time, record 10 digit code). They then proceeded to have you get in your car to try different codes.

3. You can got to this site https://radio-navicode.honda.com/ to enter the vin - but you will have to prove you own the car.

Hope this helps!



Posted on Jan 17, 2009

johnny5846
  • 379 Answers

SOURCE: Need to input my radio code on 2005 Honda Civic

ok your radio displays ERR , OK 3 options let it sit for an hour turned on , to reture to CODE display , or pull the radio fuse out for a minute and put it back in , returning to the CODE display , or disconnect the battery for a minute , returning to the CODE display . you got the ERR display because the code was wrong or not entered correctly , make your choice of getting the radio back to the CODE display by 1 of those 3 choices , while the radio displays CODE , use the preset buttons , if the first number of your code is 4 , then press the #1 preset button 4 time , when the first number has been input , put the 2nd number in by pressing the #2 prest button , if 2nd number of code is 8 , press the # 2 preset button 8 times till the # 8 is displayed , and so on . you see where this is giong ? when you have entered all the numbers correctly you will have you radio back . when you say you have the radio code , good luck ! were rooting for ya .

J5

Posted on Jan 19, 2009

  • 1 Answer

SOURCE: Honda radio says ERROR E

You only get like 10 tries this means you made to many attempts trying to put the wrong code in. Disconnect the battery cable and then try putting the code in the radio again.

Posted on Feb 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Messed up radio in 2001 homda civic


Try disconnecting the battery for about 15 minutes and connect it back up and see if that will program the radio. Good luck

Nov 22, 2014 | 2001 Honda Civic

1 Answer

I ran the battery down after i left my lights on and now the radio wont do anything just says errE how do i fix that


you may need to get the passcode, try this

1. Look in your glove box for a white sticker with black numbers on it. The sticker will be about 1 1/2 inches long and 1/2 inch wide. There should be 5 digits on it. These 5 wonderful numbers are your radio code. Put the code in through the preset buttons on the radio. You'll hear a beep and the radio will come back to life. (though you'll have to reprogram all your presets)

2. Ok, there's a sticker there, but there's more than 5 numbers on it! What do I do with that? Don't worry, that's the serial number for the audio unit. Call a dealer, tell them what happened and that you have the serial number and they can get the code for you for free. Write the code down and stick it in the glove box. Follow the steps in #1 above.

Mar 06, 2011 | 2004 Honda Civic

1 Answer

Car radio code needed


radio thinks it was going to be stolen so it set the security need to check manuel or call dealer
you will need ownership info

Mar 03, 2010 | 2004 Honda Accord

1 Answer

Error code: errE on radio


either the radio must be replaced, because honda has problems with the radio. or you need to disconnect the battery for 10 seconds then put in the radio code again

Sep 06, 2009 | 2004 Honda Odyssey

1 Answer

Radio displays "Erre" after I disconnected battery


yes , open the compartment at passenger side. inside you will see a code. Shut off the radio and put the radio on , the screen will tell you code , put in that number and it will work

Aug 20, 2009 | 2002 Honda Civic

2 Answers

2005 honda civic stereo won't turn on - screen reads "2 Erre"


first try diconnecting the battery for 10 sec then re enter the security code

Aug 10, 2009 | 2005 Honda Civic

1 Answer

How do you reset erre for radio on 2004 acura?


Look in the Acura book that came with the car then you have to do this: If you have jumped or replaced the battery at anytime this will happen. You have to get the serial number off the radio by removing it or partially taking it out to see the numbers on it try not to remove any cords. With the stereo out (to make sure you get the right number off of it) call an Acura dealership with the number and they will give you the another number to enter into the stereo and directions on how to punch the numbers in. Make sure while you have the stereo out you write the serial number down and keep it in a safe place also the number that the Acura dealership gives you because if you sell the car or if it happens again its easily accessible. Good Luck!

Jul 13, 2009 | 2002 Honda Civic

1 Answer

2004 Honda Radio Code Needed


Hi,welcome to fix ya.
try 64122 enter it using the radio preset buttons

Apr 06, 2009 | 2004 Honda Civic

3 Answers

Honda radio says ERROR E


You only get like 10 tries this means you made to many attempts trying to put the wrong code in. Disconnect the battery cable and then try putting the code in the radio again.

Feb 26, 2009 | 2004 Honda Accord

3 Answers

Need to input my radio code on 2005 Honda Civic


ok your radio displays ERR , OK 3 options let it sit for an hour turned on , to reture to CODE display , or pull the radio fuse out for a minute and put it back in , returning to the CODE display , or disconnect the battery for a minute , returning to the CODE display . you got the ERR display because the code was wrong or not entered correctly , make your choice of getting the radio back to the CODE display by 1 of those 3 choices , while the radio displays CODE , use the preset buttons , if the first number of your code is 4 , then press the #1 preset button 4 time , when the first number has been input , put the 2nd number in by pressing the #2 prest button , if 2nd number of code is 8 , press the # 2 preset button 8 times till the # 8 is displayed , and so on . you see where this is giong ? when you have entered all the numbers correctly you will have you radio back . when you say you have the radio code , good luck ! were rooting for ya .

J5

Jan 19, 2009 | 2005 Honda Civic

Not finding what you are looking for?
2004 Honda Civic Logo

Related Topics:

674 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...